Having problems with your Hotpoint 24 in. HDA3400G Built-in Dishwasher ?

Center water tower came apart

\015 The center water tower in the dishwasher seems to have three nesting pieces that extend upward. One day I found one of the pieces on the floor of the dishwasher after I ran it. It was a 4" piece with a hole in the center at the top and three holes going around the top. I figured it should go back into the center of the tower, but the lip on the bottom of the piece won't allow me to put it in. Please help!\015

Answers :

There have been many versions of the spray tower used over the years. If you have the model HDA3400G which you posted under, you should get a part number WD22X10008 which is the lower spray arm and tower assembly. By looking at the new part, you will see how a couple tabs hold the part on, and can figure out how to remove the old one with a flat blade screwdriver (or two). If you have a different model, please post the exact model number. The model number sticker is generally located on the left side wall of the tub, right by the front.
Repair Help & Product Troubleshooting for Hotpoint 24 in. HDA3400G Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Center water tower came apart


There have been many versions of the spray tower used over the years. If you have the model HDA3400G which you posted under, you should get a part number WD22X10008 which is the lower spray arm and tower assembly. By looking at the new part, you wi ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Water tower The water tower came off of my Kenmore Ultra Wash III dishwasher. I cannot figure out how to get it back on. There is a gasket on the water arm. Does the water tower actually go on top of the bottom rack? And if so, then how?


I had the same problem finding a Water Tower laying in the bottom of the dishwasher. Solution is to simply lift the bottom rack and insert the tower into the center-most square hole. Twist the tower with the large lip on the bottom of the rack and th ... Kenmore 17439 Built-in Dishwasher

Maytag pdb2430awx fill with water and starts washing, but the only circulation is through the center tower. There is no circulation through the upper or lower spray arms. Everything else seems ok.


... Maytag Dishwashers

I have a dishlex global 500, will not draw water in, comes up with error code nf. I have taken all hoses and filters apart, cleaned them, still no luck. I cannot find a blockage. ps, the dishwasher tripped my power off , then error message came up when I reset power


... Dishwashers

Hello, we have a Frigidaire dishwasher Model# FDB1250REC2. There was all kinds of junk down in the lower filter area and when I tried to remove the parts they all came out together and then fell apart. I need to see how the parts go back together, because I thought I had them in there correctly, but when I opened up the dishwasher after running it the water sprayer was laying on the heating element. Could you please help me get it back together right? Thank you


I am having the same problem...were you able to fix it? ... Frigidaire Dishwashers

I have a three-year-old Sears Kenmore Elite dishwasher. I find that despite the fact that we scrape and rinse our dishes before loading the machine, after each three months of use (two loads a day) or so, I have to take the machine apart (spray tower, racks, bottom impeller, bottom screen housing, food grinder cover) and clean-out the food grinder area, for it fills-up with sludge. The sludge restricts the water flow and there isn't enough flow to turn the impellers via that steering jets.


Have you tried different detergents? Some detergents after getting wet and going through the wash cycle with the debris from the wash turns into a grease substance that grimes up in some dishwashers. Try running the machine with hot water this someti ... Dishwashers

I have a GE Triton Triclean Quiet Power iii dishwasher, which I believe is a GSD5930d00ww - came with house - some clown took the model # sticker off. Anyway, after tearing it all apart to replace check valve, it is now dripping water from the front left lower corner...any ideas? Is it just a matter of replacing the gasket?


... GE 24 in. GSD5930 Built-in Dishwasher

I have a dishwasher HDA2100F01ww and the inlet rubber hose came off from somewhere (Kitchen Flooded with Water) I took apart the panel and have looked under the dishwasher but I can not see where it connects to. Does someone have a drawing of where this connects to?


Enter your model # at www.appliancehelponline.com for a diagram part #462 in the diagram is the drain hose. This connects to the drain pump. Here is a link for a similar ... Hotpoint 24 in. DF55 Free-standing Dishwasher

I have a Whirlpool dishwasher (Model #: du800cwdb5) and need help going about the repairs myself. When the dishwasher is turned on, the spray arm at the bottom does not spin, nor does it spray any water and the spray tower produces water but, rather than spraying, the water just kind of bubbles out of the top of the tower. The tower does also does not extend up as it supposed to.


There is something clogged in the motor/pump or its intake ... Dishwashers

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dishes all cloudy and spotty. Maytag Intellisense plus 1996 dishwasher. I have real hard water that leave white calcium build up. I can remove and clean all of the lower spray arms and filter. How do I remove top spray arm to remand remove deposits? The motor sounds good, hot water, fill ok. On the inside top of center of arm where it meets the center input connection there is gunk to remove. How do I get to it? remove arm? thanks


The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your d ... Danby 22 in. DDW399 Free-standing Dishwasher

Have GE Dishwasher model GLD6700N20WW,unit has stopped draining! Took apart and pump was running when check, but no water coming out. Checked drain line and pulled apart pump housing, all clear. Thought maybe pump has a silinoid built inside of it and was stuck shut, so bought new pump and same thing, no water will go thru! Please help me? Is it control module, or turbitity sensor possibly?


... GE Profile PDW8600J Built-in Dishwasher

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

We lost electricity very briefly today which caused the dishwasher, washing, drying, clean buttons to blink when the electricity came back on. I opened the door to do a load of dishes hours after the electricity came back on and the basin was filled with water which caused water to spill out of the dishwasher. The basin was empty last night when we used it. It seemed to fill up when it was not running.


It seems unit fill valve is stuck open and water is coming in even when machine is off.fill valve opens up only when u start the unit.2 chks this u can open the door and look at the hole inside from where water comes in.if water is coming in with do ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Hi, we have a Bosch Exxcel dishwasher which mid way through a cycle a button saying Check Water came on. we turned the machine off and opened the door and found loads of water in the bottom. my husband then scooped all the water out and cleaned filter in the bottom, where we did find some bits of plastic from the kids yoghurt pots, and took the water hose off the back and checked for blockages, which there was none. the water is certainly coming from the water pipe through the hose as we tested


Check your water level sensor. And also check to make sure that your pump is working correctly. It sounds like a couple of different things that need to be addressed. First check the water level sensor. It is a tube that is located from the back of t ... Bosch 24 in. SHU43 Built-in Dishwasher

Check water light stays on rendering machine unuasable.checked water supply.all filters .googled problem told me to switch water supply on and off rectified problem for 10 minutes then check water light came back on. water remains in bottom of appliance.


... Bosch Dishwashers

I turned on the dishwasher tonight and noticed nothing was happening, but I was getting a clicking sound. I moved the dial back to off and started over. Some water went in, but then nothing happened again. I clicked forward one click at a time. Sometimes water came in. THEN WATER STARTED LEAKING OUT. I clicked back to off. After water stopped leaking, I opened the door. There is still water in the bottom. What do I do???


Hi \015\012\015\012Thanks for using FixYa. As the water is not draining and clicking is\015\012coming from the bottom so the issue seems to be with the drain pump solenoid. Usually, these issues are related\015\012to ... Kenmore Dishwashers

There is gum stuck somewhere in my dishwasher drain line. The water won't go down. I took the inside apart and can see the hole where the drain water goes. I disconnected the drain hose under the sink. I got the water to drain out when there was alot in there, but now it won't drain again. I blew compressed air from a compressor backwards through the hose and it makes a big splash and bubbles inside the dishwasher, but the water still won't go down. I put Boiling hot water and vinager in there t


Ther e is noo easy fix, short of replacing the drain line( if indeed thats where the clog is)although you checked the hose from the under the sink, did you check with in the hole where the sink conection is made??and try disconnecting the drain hose ... Dishwashers

Water will not drain out. do not have a drain airGap. when opened dishwasher this afternoon still had water in the bottom of it. Emptied the dishes, closed the door, pushed cancel/drain. the green light came on and i could hear the dishwasher running but not hear the water draining out. Let it run the 2 minute cycle for cancel/drain opened the door and the water is still there.


Hi,Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Waterwill not drain out ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

While on vacation our house had been checked at one week later &again 2 weeks later, @ 3 weeks check, floor in front of dish washer & entire kitchen had standing water , as DW door was opened bottom of DW had water standing up to bottom of door . Water supply to house was shut off before we left. , Since we returned home we have used DW daily with no indication of where this water came from. Any ideas ? Thanks, Bob


Take a long shot. Say your mains leak a little, quite possible, and you machine's inlet solenoid valve leaks a bit, say about a litre a day - you probably would not notice it during the normal course of events, in a week it would leak a ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Have a whirlpool washer and it would not stop filling so I turned off the water facets and bailed out the water and then ran rest of water out on spin cycle. I unplugged washer and turn hoses back on and water still came in could it be the "fill valve". thanks sharon


... Whirlpool DU805DWG Dishwasher

Miele dishwasher model# g868 could be 4 or u at end, customer complained water not coming into d/w ,when i got there water was coming in.for a few minutes then stopped filling ,drains fine, customer had not operated machine for a few days.i disconected the safety valve hose from under sink to see if water comes through does not when advancing cycle by hand, washes ok when water came in, thanks, Murray


... Dishwashers

Leaking from underneath. Water appears from under basboard to the right of dishwasher, not from directly in front. Only seems to leak during rinse cycle and has just started recently. Removed front panels and noticed the bottom of cabinets on both sides have water damage as if water has been leaking for some time. Never have seen any water until now. GE model GSD500X-66WB. Came with house, approx. 15 yrs old.[


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012,fhjsuj ... GE 24 in. GSD500X Built-in Dishwasher

GE PDW8280 - MIDDLE ARM WILL NOT SPIN - WATER FLOWS AND SPINS FROM TOP AND BOTTOM ARMS - MIDDLE ARM HAS WATER FLOWING BUT WILL NOT SPIN. tOOK APART AND CLEANED - SPINS FREELY BY HAND BUT NOT DURING CYCLE. SUSPECT LOW WATER LEVEL? WATER IS ONLY UP TO BOTTOM OF HEATING ELEMENT


Take the whole middle spray arm assembly off -- spray arm and long tube that it is attached to. I cleaned the inside of the spray arm and found some odd stuff but it still didn't swing after the cleaning. I order all new parts and when I was repl ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1403 seconds