Having problems with your Hotpoint 24 in. HDA3400G Built-in Dishwasher ?

My hotpoint hda3220z07bb has no power at all , turning the timer dial gets no response at all, but I do have power to the motor, water inlet and the interlock works fine, the unit appears dead but there's power there.


Answers :

CHECK DOOR LATCH OR TIMER BAD
Repair Help & Product Troubleshooting for Hotpoint 24 in. HDA3400G Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My hotpoint hda3220z07bb has no power at all , turning the timer dial gets no response at all, but I do have power to the motor, water inlet and the interlock works fine, the unit appears dead but there's power there.


CHECK DOOR LATCH OR TIMER BAD ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Maytag MDBH979AWS dishwasher - there appears to be no power coming in to it. The dishwasher will not turn on and there are no lights on the control panel. I checked the power in the breaker box and it works fine. Any suggestions what to do next?


Maytag MDBH979 power sensor will not turn on dishwasher. The other buttons and lights turn on when pressed but not the power button. Please help. ... Whirlpool MDBH979AWS Builtin Dishwasher

Dishwasher was cutting out intermittently,totally dead no power then after 15mins or so,finally went bang this am,smoke etc,took insection cover off at bottom swit6ched on again to see spark dead short on unknown unit with four wire block connector attatched,two white to same connector and two purple,left disconnected and workin fine,hot water,inlet and outlet both working fine so what does that unit do?


... Bosch 18 in. SRS43E02 Slim-Line Built-in Dishwasher

I have a GE Profile, GSD4930X73WW, dishwasher. The upper wash arm is not spraying well at all. I checked the water line from the pump to the upper arm and it's fine. I cleared the filters and cleaned the float. I also took the inlet valve off and cleaned the screen. Although the washer works better overall, the upper arm still does not work well. Nothing appears to be in the upper arm assy to clog water from spraying out. All seems clear from the turbid sensor (next to the pump) through t


... GE Dishwashers

Hi, I have a fisher and Paykel double dish drawer model DD605. A couple of days ago when we opened the top drawer all the lights flashed and beeped in sequence repeatedly and would only stop when the power was turned off or the dishdrawer closed. Today I went to turn the top dish drawer on and cannot change the cycle off rinse. I can push the eco button and the rinse cycle works no problem but I cannot change the cycle. The bottom drawer is running as I write this and appears to be fine. An


Hi\015\012\015\012\015\012Could you please let me know which all lights are blinking/lit solid in sequence from right to left. This could be an issue of drawer lock mechanism or flood switch issue. PLease post back with detai ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Bosch dishwasher, model SHX46A05UC/30 has been working fine. I ran it once today on the Power Scrub Plus cycle (always use this one). Shortly after unloading the dishwasher I needed to run it again with more dishes. Within a few minutes of running the dishwasher I heard loud, almost grinding noises. Nothing appears to be stuck. Any ideas on what to do? This dishwasher has always been quiet up until today.


... Bosch 24 in. SHX36L05UC Stainless Steel Built-in Dishwasher

Bosch SHY66C My Bosch dishwasher won't fill with water.  All electrical connections are fine and I can hear it make a sound as if it is trying to start about every 2 minutes.  There was water in the bottom so I used a shop vac and pulled it all out but it still won't start and is doing the same thing.  I checked the solenoid with a multi-meter and it appears to be working.  My power went out last night for about two hours and that's all I can think of that might have affected it.  The dishwasher


I'm a novice on this question, but i agree with the above statement about check the stuck float switch or check for a bad safety switch or lockout switch of some sort. I would suspect something is definately faulty in that area. Will the dishwasher r ... Dishwashers

Our Kenmore Quietguard 2 is not working - there appears to be no power at all, it stopped in the middle of it's cycle. We checked the circuits, and they are fine..any other ideas?


... Kenmore 24 in. 15932 Built-in Dishwasher

I have a Siemens dishwasher SE64530/17 type S9 V15 Unit powers up and appears to begin wash cycle. However little or no water enters unit. Unit is about 12 years old and has been working fine. There have been no changes to installation, plumbing or electrical.


... Siemens Dishwashers

I have a 7 yr old KitchenAid undercounter dishwasher that was working fine, then it suddenly appeared to lose power: no lights and no response when buttons pressed. The circuit breaker is not the problem. Any idea what might be wrong?


Hello smaumer... \015\012\015\012When you say that the circuit breaker is not the problem, are you sure you are getting power to the receptacle that supplies power to teh dishwasher ? Just because the breaker in your house does not appear ... KitchenAid KUDR01TJ Dishwasher

I have a GE Max,mod # GSD6610G00SB....it worked fine a few days ago,today theres no power to it,Any suggestions?I've already tried holding in the reset button and checked the breaker with no luck and can't find the papers!


... GE Nautilus 24" Built-in Dishwasher

It appears that water is not running through the dishwasher or that the sprayers are not working correctly. There doesn't appear to be a clog. However, I did find a round rubber "washer" (I think that is what they are called) laying in the bottom of the dishwasher - where does this part go. It was working fine until this wash. The heating element works fine but like I said it appears that something may be wrong with the spray tower. Please advise Model number of Hotpoint: HDA3420Z01BB T


Hi,\012When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher ... Hotpoint Dishwashers

My dishwasher is a Smeg model STA 6143, and the door won't close. It seems fine until the last few centimeters, then it jams and won't close easily. If you press hard, it'll shut but not latch. Nothing appears to be stuck anywhere. We've tried jiggling the door but it seems somehow to be misaligned, although there's no reason why it should all of a sudden appear to be so. The electronics work fine, the racks fit fine (we also removed them, and the door still won't close), and nothing appear


... Dishwashers

Dishdrawer The top drawer of our dishwasher has stopped working. It has been working fine for about 18 months but now it seems to have no power coming through to it. The bottom drawer is still working fine. There have been no electrical surges that we are aware of.


Hi there,\015\012\015\012If you have no power to the top drawer and it is difficult to open it may be that your heater plate has blown and requires replacing. If it has no power and opens easily you may have the child lock on and need to hold the loc ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

An electrician switched off the power whilst doing other work. Power was restored OK. But when we came to use the dishwasher there appeared to be no power to it i.e the control panel remained blank. We have checked the fuse box and all appears to be in order.The appliance is a Siemens FD 8909 dishwasher


Maibe the internal fuse of the dishwasher blow for a spike, check first if you have power at the socket if so is highly posible that you have a blown fuse in the dishwasher ... Siemens Dishwashers

Model 580.752601 Craftsman power washer,dosent seem as if the pump is operating worked fine last time used


... Craftsman Pressure Washers

I have a ge profile quiet power 3 model # gsd4330z00ww, theres power to the dishwasher but its acting like theres not, no lights or buttons work.


The control board may have failed. There is no way to know the exact problem without troubleshooting with a multimeter ... GE Dishwashers

Bosch Dishwasher SHX56B05UC won't turn on after working fine everyday for almost 5 years. Checked circuit is fine. Disposal is running which is in same line. It won't turn on with power button today. It worked until now without any problem. What should I look for. Called a repair person but it will cost me $105/half-hour for the repair visit.


... Bosch 24 in. SHX46B05 Stainless Steel Built-in Dishwasher

Appliance had been working fine now all of a sudden no water is running in the dishwasher.The machine appears to run through all of its cycles but without water. The water pressure in the ajoining sink appears a little low though the water pressure in the rest of my home is fine. I see no water leakage anywhere. Do I need to call an appliance tech or should I call a plumber? Thank you.


... GE GSD1000 Dishwasher

I have a slimline dishwasher from Ikea. The model is Whirlpool DWH C10 W manual. Everything worked fine up until the other day when I switched the machine on and it made a noise as if it was working but nothing happens. No water comes into the washer although inlet pip looks fine. I have poured water in and it is drained okay but the dishwasher is not cleaning dishes. After checking through numerous forum and reading about a flood prevention switch which can be sorted by tipping the d


Ok so slow down and lets look at the d/w problem and don't take the kitchen apart.. in the tank there is a float in the front corner. lift the float and listen for the click that would be the float sw . if no click th ... Dishwashers

I cant get me dishwasher to start i have tested the overflow switch and its fine i have also tested the water inlet valve and its is fine. but it will not fill the dishwasher with water i have even removed the hose to see if there was any blockage in the line come out from the what inlet valve. the button light up on dishwasher and the cycles work a long with the start button, i have left the door open to see if the door senor could possibly bee an issue and it tested good and function correctly


Hi.If there is no voltage to valve, then parts that can be responsible are only and all the following:Overfill switch or overfill device.Door switch.Electronic control Wiring.If the overfill switc ... Dishwashers

No power dishwasher worked great then all the sudden get no power to the top drawer .botom works fine .


Top drawer turns on runs aprox 3 min then starts to beep and we have to turn it offthe clock pops up and and stays at 2;00 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Bosch diswasher water inlet work fine, when the wash motor or cycle need to start nothing happens. The timer is advancing normal. Water outlet(drain pump) is also working fine. There is no woosh sound (start of wash cycle) and arms is not rotating.


Hi,\015\012\015\012it sound's like the wash motor is either seized or just stuck, let's hope it's the later. Bosch had issued a service tip about this problem several years ago titled "Loosening Frozen Impellers" strange choice of word's considering ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Our craftsmen electric pressure washer stopped working while in use. We have power - red light on gfci and we tested the master switch - has power too. So what can be the problem? One post mentioned a jammed pump switch. What is that and where is it? We used it 2 weeks ago and it worked fine.


The pump switch they spoke of is an internal switch. It is activated by a valve so that when you let go of the trigger, the machine shuts off. This valve is stuck or the switch is bad. Usually the valve is the problem. I would go to Sears and get ... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1365 seconds