Having problems with your Hotpoint 24 in. HDA3400G Built-in Dishwasher ?

Whats inside the junction box on hda3400g00ww


Answers :

Repair Help & Product Troubleshooting for Hotpoint 24 in. HDA3400G Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whats inside the junction box on hda3400g00ww


... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Bosch APEXX model number SHY99A05UC/14 lost power. Power input line appears to have arced (white power line and wire nut show signs of stress). The power breaker did not throw at the junction box. Already cut back wire and re-attached new wire nut along with replacing the breaker at the junction box. Still no power. There are no other visible signs of power stress or water damage underneath the unit or inside the doo panel.


I do not have access to the user or service manual for this model.\015\012However, such symptoms could be result of heater element or thermal overload fuse blowing. Do you remember having a very hot dishwasher when the it lost power.\015 ... Bosch Dishwashers

Hello, I've been working on a Bosch Dishwasher. It has no display of any kind, and there's a strange grunting sound coming from the wash motor when power is applied (like if you had just plugged it in), as if it's trying to start. The junction box is getting 120V, all connections to the junction box are fine, and the display board and the main control board are all getting the proper voltage. Now, we've already replaced the main control board and the problem persists. The tech line suggested


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

I have an LG Dishwasher Model LDF7810BB. I have no response at all from the control panel, no lights at all, no error messages - completely dead. The unit worked quite well for 2 years, then just quit. I have good power at junction box. I have taken the unit apart, tested the line filter box on the R of the dishwasher (actually jumped it). No response. Thoughts? Allan.


... LG 24 in. LDF7810 Built-in Dishwasher

DW blew GFI fuse and spartked out junction box


Unplug it and check the junction box its probably shorted there ... Frigidaire 24 in. FDBB944C Built-in Dishwasher

How to replace junction box in Bosch dishwasher.


... Bosch 24 in. SHU43 Built-in Dishwasher

Whirlpool Undercounter Dishwasher DU8900XY1, My dishwasher is dead. It stopped in the middle of the wash cycle and has not operated since. I checked the power at the junction box and power was confirmed. I could not see or smell any burnt wires. I don't know the next thing to trouble shoot to fix the problem. Please help


Take off the kick panel and open up the j-box at the dishwasher only. Just make sure there is no burned wire nut or loose one\012\012Thanks ... Whirlpool Dishwashers

Ditches come out looking very dull, glasses look gray and dull, inside of machine gets a light white film on it, I have been using Cascade in the box for as long as I have had the machine.


If you have hard water, glasses can look spotted and cloudy even after cleaning. Sometimes changing the dishwasher detergent can help. The easiest solution to clearing up glasses that start to look cloudy is toadd some vinegar to t ... KitchenAid KUDR01TJ Dishwasher

Where's the junction box to hook up main power cord


Hi,Underneath the dishwasher behind the kickplate... usually in the right front corner...heatman101 ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Asko dishwasher DW95.FI model 1996. How do I remove lower panel (not kick panel) covering junction box?


... Dishwashers

Hi, in my Whirlpool dishwasher series 280-0, the dish-washing powder is not used, as it fully remains in the dish-washing box inside the door of the washer.


... Dishwashers

I have a Maytag Model Quiet Series 300 (MDB5601AWW). I have power up to the junction box but non of the lights go on. I've tried the two different types of tests but nothing happens.


... Maytag Dishwashers

I have a Bosch Dishwasher, Model Number SHX46L, Serial Number 860200524 that is no working properly. After running a cycle, it did not pump out all of the water, though the water is very clear, and the dishwasher does not display that there is any electricity going to it. I have verified the is 120 Volts AC at the appliance junction box. However the dishwasher will not turn on, and no lights will come on? Do you have any suggestions? I would appreciate it if you would let me know what you


... Bosch SHX46L1xUC Dishwasher

I just purchased a RMV2.5G27D Universal pump. Installation was easy, but I have two questions. 1. No where in the booklet does it say to put oil in it, does it come with oil already inside? There was no oil in the box but the instructions kept refering to 2.2 ounces of oil. 2. It had a red plastic plug opposite the water intake, included was a brass plug that fits into that area, does the plastic plug stay or do I put the brass plug in it?


The red plastic plug comes off, that is the plug that is only used for shipping. You should have got a ventable oil plug to replace that one in the box. The oil you would need is this ... Annovi Reverberi RMV2.5G27D Pressure Washer Pump

I have a aeg 43070 vi dishwasher It keeps tripping the circit breaker on the house fuse box . I have reset the leak cutout by dipping the dishwasher back and stopped the warning sound,but went for about a minute and then trip the electrics again . any ideas whats wrong ?


I assume you are refering to the earth leakage circuit breaker. This trips when a earth leak fault has occured. The normal cause for this could be\015\012A) Water leaking via a pipe at the bottom comming in contact with one of the electric moto ... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

ON THE TOP OF THE DOOR IS A ROW OF LIGTHS THAT INDICATE YOUR SELECTION FOR WAS, DRY ETC.. THERE IS ALSO WHAT LOOKS LIKE THE NUMBER 3 INSIDE A BOX. THERE IS A LIGHT TOO AND IT'S STEADY GREEN. I CAN NOT CHANGE IT AND THE WASHER DOES NOT RUN??


... Jenn-Air 24 in. JDB1270AW Built-in Dishwasher

Bosch SHX46A02UC dishwasher hardwired, circuit breaker ok, know there is power to junction box. No lights, no activity, cancel and drain switches not functioning, disconnected for a few minutes and reconnected. No change. Leaning towards control module, i will visually inspect and spray circuit cleaner on switches. Any other suggestions gratefully accepted. THANKS


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Dishwasher appears to have no power - no panel lights at all (lock, start, etc). Power is 120VAC at outlet to DW when disconnected but the voltage is 60VAC at junction box under DW once it connected. Acts like a floating ground but N is 0VAC to Grnd. ??? what should I be testing / checking??


Door switch ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

There was a short in the junction box. i fixed that by stripping wires and installing new wire nuts. the dishwasher ran. for some reason the water is NOT entering the dishwasher


There is a chance that the coil on the fill valve has become bad. If the valve was being operated at the time the short occurred the coil could have overheated and burnt up.A couple ways to check it would be;\015\012\015 ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

We went to run our dishwasher and lights are out....nothing works......house fuse fine. Been told to look for fuse box inside of dishwasher panel but cannot identify.


If the circuit breaker is good then you need to check the main power line to the unit and make sure everything is connected properly. ... KitchenAid Dishwashers

1765991 is whats on tag inside dishwasher - Dishwashers


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. Please tell me the brand & model number of your Dishwasher so that i can provide you with model specific information. Also tell me what issue you are facing with t ... Dishwashers

Washer quit in mid cycle, leaving standing water inside. no problems at the breaker box


Sounds like the timer ... Dishwashers

I got a double drawer fisher and paykel dishwasher and the first drawer was not working and after a few days we saw that it was smoking and smells burn so we turn off the main switch and took out the burned box. my question: is replacing the parts will solve the problem? but whats reason that got burned?


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers…Dishwasher Problems The ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Have a GE Quiet Power 3 Dishwasher. Went to reun it and when I closed the door no lights came on to pick a wash cycle. Nothing like it lost power. No buttons work, nothing. Opened door and removed inside door panel. Have power at door latch switch. Actually have power at all 4 connections and doesn't change when engaging switch as if door was closed. Switch does click but no power at front control panel. Whats up. I have my own Handyman/Home Remodeling business and I'm very good at fixing things


If your dishwasher is not running check the following \015\012\015\012You have already taken care of the 1st item.Power Supply The main power supply is the first thing to check. Also remove the toe ki ... Dishwashers

IDL750 - Fuse trips when turned on. HELP! We had some electricians here to install a new electrical socket for a new fridge. They put the new socket in the same wiring as for my existing dishwasher!! The first time I tried to start the dishwasher cycle with the new fridge plugged in, the circuit box fuse tripped. Now, even with the fridge turned off, the dishwasher makes the fuse trip when turned on. Is there a fuse inside the dishwasher that has blown and needs to be replaced? or a ground brea


Hi.The first step is understanding if the problem is the socket or the appliance. Find an extension long enough to reach a different socket. Move the appliance to reach the power cord, and connect the dishwasher to a different power sock ... Indesit 24 in. IDL700 Built-In Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0451 seconds