Having problems with your Hotpoint Dishwashers ?

My dishwasher is stopping through its cycle. I need the timer sequence chart for a hotpoint aquarius super plus df22 dishwasher


Answers :

Repair Help & Product Troubleshooting for Hotpoint Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher is stopping through its cycle. I need the timer sequence chart for a hotpoint aquarius super plus df22 dishwasher


... Hotpoint Dishwashers

Hotpoint aquarius super plus df22 on/off switch not staying in?


... Hotpoint Dishwashers

I HAVE A HOTPOINT AQUARIUS SUPER PLUS 7834. THE CYCLE IS NORMALLY STARTED AT NUMBER 3 ON THE DIAL BUT THEN THE MACHINE STOPS AT 4,5,RINSING AND DRYING. TO OVERCOME THIS PROBLEM WE STEP IT ON MANUALLY AT EACH POINT. WHAT WOULD CASUE IT TO STOP AT THESE PLACES?


... Hotpoint Dishwashers

We have a hotpoint aqaurius dishwasher df23n. When put on wash 4, the timer stops half way through and has to be helped. When the programme then continues through the rinse cycle, it stops half way through. I have tested the water heater and thermostat electrically and they seem ok. Is there anyting else that stops the timer at these positions? The timer knob is free to turn and is not jamming? Steve B


... Hotpoint Dishwashers

Hotpoint aquarius dishwashers keeps stopping half way through wash flashing between the 40 and 60 temp light. How can I fix this please


Control panel is sensitive on this model. Mine did the same and machine would not wash to the programme, stopped half way or would not set at all. Switch off machine and unplug from the mains. Leave for 10 minutes. Plug back in and switch the mac ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My hotpoint Aquarius Dishwasher starts up bu only runs a few moments before stopping with 2 lights flashing " wash " " drying "


I had the problem of flashing lights and water did not pump out.Found a piece of bacon in drain pump wedged between impellor and pump body...cleaned it out...problem solved.. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Hotpoint Aquarius FDW 20 dishwasher. Prewash and Wash lights were flashing, machine had stopped and water was at the bottom of the machine. What does this indicate? After removing some debris from the water drainage pump, then reassembling the machine, I now get the pre-wash LED flashing and a motor operating, but no futher progress into the wash cycle. What does this mean?


Dishwasher always full of water at the end of cycle ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hotpoint dishwasher Aquarius FDW60 - stops during cycle and delicate light flashes - can it be repaired? What is the fault.


Switch the machine off and unplug at the mains. Leave for ten minutes, then plug in and switch on. My dishwasher control panel had a mind of its own and did what it wanted including leaving water in the bottom of the machine. The electrics sometim ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Circuit diagram Hotpoint Aquarius Dishwasher DF22


... Dishwashers

Is there a micro switch on a dishwasher to let the water in hotpoint hydrocare super plus model no 7822 my machine dosent seem to fill


Most Dishwasher have a flote switch for the water level. You need to check it as well as the water inlet water valve. ... Dishwashers

Hotpoint super plus 7820 manual were dose the dishwashing little soap bar go ? lol


... Dishwashers

We have a Hotpoint Super Plus 7822 dishwasher, water is there but does not flow through the sprinkler bars, How can we fix this problem?


Hi\015\012\015\012The spray arms doesn't spray water deu to several reasons, one of the common issue is due to clogged holes or low water pressure. Please check the water pressure, make sure that the water pipes are connected and has no l ... Hotpoint Dishwashers

I have a Hotpoint Super Plus dishwasher 7820. It worked well for a long time. Towards the end of the cycle it leaks a lot of water from the underside of the door, so it seems. I have fitted a new door seal. No success. What may be the cause?


The door seal has to be in a proper position completely around the door (including the bottom area of the door). If not, it will leak. Also, there are two black corner baffles/seals (located in each front corner inside the tub area) that may also b ... Hotpoint Dishwashers

Hotpoint Aquarius dishwasher FDW60; not washing properly, washing cold; items wet and slightly slimy. Delicates light flashing when machine stops.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

How to reset dishwasher hotpoint super plus 7821 %3F


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hotpoint aquarius dishwasher, After 2 minutes stop and flashes Eco 45oc and Delicate 50oc. Tried on intensive and normal washes


Its not on the door. it will be inside the washer.once you pull out you can see the power board manually with sharp eyes. there look for elements that are puffed on TOP.just go and replace them. ... Dishwashers

Hotpoint aquarius dwf30 dishwasher


You can plumb into hot but there are some snagsfirst hot water pressure is often a lot lower than cold so the machine may take a long time to fillsecond if the water is too hot it will destroy the resin of the water softener and you will ... Hotpoint 24 in. DWF32P Free-standing Dishwasher

My hotpoint aqarius dc26 dishwasher has stopped


This may be caused by a leak your dishwasher as a build in anti flood switch which stops water from entering when it leaks into the base of dishwasher . You may be able to check this for yourself by unplugging your dishwasher and slowly pulling it o ... Dishwashers

GSD500X-73WB Dishwasher: Automatic timer has stopped working. It is still possible, though, to work the dishwasher manually by turning the dial. How much will it cost to replace the timer? I guess that it is the whole control unit including the timer that would need replacing.


... GE 24 in. GSD500X Built-in Dishwasher

Dishwasher runs for appx 14 min & stops washing half way thru wash cycle. Timer contunies to run. No drain pump out (nothing). Let dishwasher set idle for appx 1 hour and it will re-set. Set timer forward to end of wash cycle and it will complete rinse and final rinse. Then go to dry. Timer works ok.


This sounds like something is stuck in the drain pump. You can remove the inner cover to look for obstructions. You have a dual purpose motor it does the both circulating and draining. The blockage is causing it to overheat and trip the thermal prote ... Whirlpool DU840CWD Dishwasher

My Hotpoint Aquarius FDW60 dishwasher is not going through cycle - lights on though


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dwf50 hotpoint aquarius dishwasher


Hi, just found this forum after searching the web 4 a solution to my hotpoint DWF50 problem. I came down this morning to a machine which base tray was full of water and lights 3 ECO & 4 Fast flashing.Anyway my solution was as i had se ... Hotpoint 24 in. DWF32P Free-standing Dishwasher

Hotpoint aquarius dishwasher fdm 550 - Hotpoint Dishwashers


... Hotpoint Dishwashers

I have a Candy CS 455M slimline dishwasher which is 3 years old. The program button has stopped moving round I put dishwasher on and went to work and it was still washing the dishes when I got home from work 8 hours later. I thought it might have stuck and been a one off but no it happens every time is it the timer? is a new timer easy to fit?


... Candy 17 in. CS455 Built-in Dishwasher

Dishwasher timer stops at 28 min but dishwasher still run and timer does not advance


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1971 seconds