Having problems with your HP Pressure Washers ?

I have a handy power HPGW 1500 pressure washer and when its used the water sprayes out of the gun around the handle part as well as the nozzel is it possible to purchase a new gun and connection to the machine


Answers :

Repair Help & Product Troubleshooting for HP Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a handy power HPGW 1500 pressure washer and when its used the water sprayes out of the gun around the handle part as well as the nozzel is it possible to purchase a new gun and connection to the machine


... HP Pressure Washers

We have a 6 year old Jenn Air dishwasher model JDB2150AWP We had a cracked door close unit which we replaced but got a short while restoring connections I am wondering if there is an internal circuit breaker, relay or fuse on these machines that we need to check and possibly replace since we cannot get it to run at all. No power or lights at all. I believe all connections are secure and we replaced the door close unit with new parts.


... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher

The plastic recessed door handle on our Smeg Model PL823X Type 11053 has suddenly cracked and broken away with normal handling which makes it difficult to open the door. We are told we need a a complete new program selector panel, that is very expensive and we are informed we may as well but a new machine. Is that true and is that good design? Purchased about 2006/7


... Dishwashers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

I have a KitchenAid KDS-17E dishwasher, which has worked well since I acquired it second-hand in 1984. Last night it ran continuously, stuck in the prewash part of fullcycle, with water being pumped through the system, and was fairly warm in the morning. It drained normally when I pressed the Cancel/drain button. I tried the machine again in full cycle. After 20 minutes it was still stuck in prewash, with the water temperature about 42 C, so I stopped it. Machine is connected to cold wate


Your problem is a bad timer.and you really got your moneys worth on this dishwasher.The timers useally go much soon than this one 7-8 years is the norm.The timer gets stuck in one position is a good sign its loseing its ability to fuction normally, ... Dishwashers

Hi I have a brand new Honda Power washer GC 160,2600 psi 2.3 GPM my husband taught me how to use it last night and I think I have followed all of steps: 1. hose free of kinks 2. connected to machine 3. purged pw handle of air and made sure water from house coming through 4. pulled out choke 5. turned red button to "ON" position 5. pulled T handle enging starter and it sounds like it will start but doesnt what am I doing wrong??? yes it does have gas in the fuel tank.


... Karcher 2500 PSI Pressure Washer

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

I have LG dishwasher for 2 years now. Working perfectly until one day one glass gets broken during washing cycle. Immideatly we get EO error. We check possible reason of error in the manual then decided to try to fix ourself. We open bottom cover and drain outcoming part. Immideatly we discover a piece of glass that was preventing a small plastic piece to rotate. We remove that piece of glass. Put back covers and machine. We connected it back to outlets and run it. All was working again !!! This


In order to fix problem we disconnected dishwasher, put it on one of side, opened bottom cover - the one that is outside of dishwasher. We find out the part that is\015\012connected to the drain horse. We take of 3 screw and open that part too ... LG Dishwashers

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

Need new gun and connection to gun


The DuraBuilt and Coleman pressure washers have a gun that tends to leak through the plastic clyinder wall that holds the plunger that moves with the trigger. You won't see the holes, but if you remove the upper half of the housing, hold the ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

Spare parts My son in law got one of the poles stuck in the hand gun which snapped off. The part is now out but wont hold the smaller piece - need a new gun. Where can I get one from.


... Psi Sistema GT11 1400 PSI Pressure Washer

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

How does the upper arm on a Bosch dishwasher connect? It broke off ordered the new part and the part does not connnect? The piece I am trying to connect the upper arm into must be broken?


... Bosch SHU3305 Dishwasher

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

Water Connections I have a new house with an Asko 1805. I think it is only connected to the cold water pipe. Can i connect it to hot as well, to reduce its cycle time?? If so, how can I access the connections? The front foot panel doesnt reveal any pipes.


In the US dishwashers are usually connected to the hot water supply. Although the ASKO 1850 I believe has an in line heater. Using hot water supply will reduce electrical useage.\015\012\015\012Interestingly we use to have ASKO washer and ... Asko 24 in. 1805 Built-in Dishwasher

Just past where the water inlet line connects to the Fl-48 Fagor there is some kind of thermal switch that is disconnected. I assume this has some kind of mechanical connection so that the line pressure does not blow it off. I do not see any kind of mechanical connection and there is no way to screw or fasten it down that I can tell. I got the machine used and don't have a parts list to see how it is supposed to be held on.


The installation parts list is available in the document at\015\012FAGOR FI-48 Instuctions. \015\012\015\012The ... Fagor 24 in. FI-48W Dishwasher

Whirlpool Dishwaser Model #DU8000XX5. Dishwasher won't do anything. Almost as if not getting any power. Was told to check thermal fuse. Noticed some burning around suspected fuse. Ordered new one, but new one doesn't look like old one. Old has 4 connections, new one only has 2. What gives?


... Dishwashers

Trigger gun I just install a new hose for my Karcher 330?Hose is working, but the trigger gun is lose, no turn off went is released, the equipment is always on ?..did I missing a part inside the gun ?..


It sounds like you left out the spring in the hose.There are about 10 different models of K330 with several types of guns. Go here and search until you find ... Karcher K2.26 Electric Power Washer

My Karcher K730 MXS pressure washer was leaking water out of the rear of the gun handle. I bought a replacement hand gun and the new gun is doing exactly the same!


... Karcher Pressure Washers

Hotpoint dishwasher I need to change waste pipe on my hotpoint dishwasher. I was given this dishwasher by a friend and it works well but I cant connect the waste pipe to the bit under the sink as the rubber connection on the end is missing. I bought a new waste pipe but not sure how to connect


Did you have a dishwasher before? If so, you must have had a sink tail piece with a dishwasher drain coming off the side. For the connection, you may have to get an adapter to fit the end of the dishwasher drain hose to the sink tail piece. Take a ... Dishwashers

New part installed, now a new problem


If washer was over heating the element was working . there also should be a thermostate to control it . I would think that the themo would be bad and should have been replaced with element . . ck old element for short and ... Fagor LFA-65 Stainless Steel Built-in Dishwasher

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers

My Frigidaire FDB935RHS0 top rack is not getting enough water (pressure) to rotate the top rack sprayer. We have looked at all the connections under the machine as well as the tubing, but we have not found any obstructions or problems. The water moves very slowly up the tube to the top of the machine and the water only seems to trickle out of the feed line therefore the sprayer doesn't spin or spray. We have disassembled the bottom sprayer and have found no obstructions there either. Do you have


... Frigidaire 24 in. GLD2350RC Energy Star® Built-in Dishwasher

Whirlpool DWF417W, Type 12155 A couple of weeks ago the machine failed to empty, leaving dirty water in the machine at the end of the cycle. Start a new program it emptied & all was then well. A couple of days ago we started a wash cycle as normal, shut the door, the pump normally runs for about 10 seconds then the cycle starts. However the pump just runs continuously?? After looking here there seemed to be a few links to the subject of water being in the base & the anti flood switch being ac


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0974 seconds