Having problems with your Husqvarna 3300 PSI 3.2 GPM Gas Pressure Washer 020524 ?

The chemical reservoirs do not feed to the pressure hose. what's up with that???


Answers :

Repair Help & Product Troubleshooting for Husqvarna 3300 PSI 3.2 GPM Gas Pressure Washer 020524

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The chemical reservoirs do not feed to the pressure hose. what's up with that???


... Husqvarna 3300 PSI 3.2 GPM Gas Pressure Washer 020524

How do you adjust the chemical feed on a Annovi Reverberi pressure washer pump?


Your chemical feed works on most units on low pressure. there should be a adjustment nob red on the intake unloader. if not its preset ... Annovi Reverberi Pressure Washers

I recently purchased a northstar 4000 psi pressure washer. I had the same series pressure washer for the past 6 years and used a downstream chemical unloader quick connect to pull chemical. I attached it to the pressure washer and it is not pulling. I havent modified anything and I dont want to pull chemical through my machine.


The injector might be worn out or have something inside of the valve causing it not to ****. If you are using a new high pressure hose or a longer hose this may also have an effect over the injector not working. ... Northstar Professional Series Pressure Washer 4000 PSI

North star petrol pressure washer. working fine, then no high pressure, checked water feed, water filter , pressure relief valve and gun nosall well work sometimes and keep working, when you release the trigger and try in again the pressure gone again. please help, many thanks, richard


Sounds like the regulator is sticking or is airbound. loosen the water connection and then tighten it back. Could also be that the trigger gun is faulty or needs adjustment. Hope this helped ... Karcher 2500 PSI Pressure Washer

My pressure washer doesn't suck the chemical through the chemical valve


... Dewalt DPD3100 Gas Pressure Washer

We have a Karcher G2500VH pressure washer. If you start the engine with the trigger pulled on the spray wand it will run at full pressure until you release the trigger. after that, when you pull the trigger it will not have any more pressure than the water hose feeding it. Does it have an internal unloader valve? What is the part number?


Hi, Karcher calls the unloader valve a spill valve, this is a link to a full drawing/parts listing , and your fault description might well be a sticking /seized unloader(spill ) valve hope this helps ... Karcher 2500 PSI Pressure Washer

My pressure washer will not pickup chemical - Honda Pressure Washer PSI 3000


What model number is your pressure washer? ... Honda Pressure Washer PSI 3000

Chemical injectors pressure washer - Pressure Washers


... Pressure Washers

Soap feed The soap feed hose on my Karcher 2650 does not suck up the soap into the washer. I pulled off the connector piece that the hose is connected to. I can blow through the hose. There is a little metal finger thing that you can tell pushes up into place when the water pressure is high. It seems like it is supposed to drop down and allow some soap through when the water is running. I found a loose(attached to nothing) gasket, looks like a little donut. It was just free floating in t


I fixed mine works good too, watch my video step by step i put it on youtube ... Karcher G2650HHR Gas Pressure Washer

Where would I find availability of parts in QLD Australia to suit a pressure cleaner 3200 psi coupled to a Briggs & Stratton motor pressure washer number 020225-0 part required chemical injection kit FIG E on general assembly part number 192914GS


Wayne, Any Pressure Washer dealer should be able to sell you what is called a "Down Stream Injector". What you need to know is the flow rate. Like, at low pressure, see how many Gallons/Liters Per Minute actually comes out the wand. That i ... Briggs & Stratton Pressure Washers

Soap wont feed thru hose on pressure washer. - Pressure Washers


... Pressure Washers

Remove the lower wash arm (1) by turning the nut (4) clockwise (right) lift the arm off, there is a bearing (3) (small thin plastic washer) under the arm, be sure not to loose it. Lift the tab on the back of the feed tube cap (2) and swing it to the right and lift up, this may need a bit of pressure to release it This is for my Whirlpool dishwasher DU1100XTP. I'm putting it back together and can't remember if the plastic washer goes on top or underneath the feed tube cap. Also how do I remo


This is not a tuff job plastic washer goes on top . and torx screws . you use a proper torx tip for the screw size . ( you can go to sears parts .com and put in model # and see a good break down of the wash arm s and t ... Dishwashers

Hi there I have a Bosch SGV4313GB/17 Dishwasher the problem is there insuffient water pressure to feed the washer arm and they are not rotating Ihave cleaned the arms and circulation pump impeller with white vinegar ,I have also overriden the door switch and operated the dishwasher with arms removed and the circulation pump seem to be working but with insuffient pressure also the machine does not fill to the depth it did when it was fine! How does one tell if it is the impeller or the


Ours is a SHU3300UC/06 model, basic model which we bought in 1999 so have had 9 years of trouble free service.Recently\015\012we noticed that there was soap left in the soap dispenser after the\015\012machine had finished all the cycles. On fu ... Dishwashers

It will not take the chemical/soap in the pressure washer? I have checked both ends on the chemical hose and both seemed to fit tight on recievers. Then I checked and did not see where it was pulling air in the hose to keep it from pulling from chemical bottle. This is a brand new washer. Am I doing something wrong?


... Pressure Washers

I have a Whirlpool GU2500XTPQ3 dishwasher that is about 5 years old. The dishes in the top basket do not get clean. I checked the water tube that feeds the upper spray arm and the top spray and there aren't any obstructions. Our water pressure and temperature are suitable. Could the pump be plugged or otherwise lose its ability to circulate enough water to adequately feed the upper sprayers? How can I check on that?


Hello,\015\012\015\012Welcome to FixYa,\015\012\015\012Based on your description as well as all you`ve done on your own I`d suspect you`re on the right track with the plugged pump suspicion.\015\012\015\012The plac ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Gas driven portable pressure washer no longer draws chemicals up


Picks up under low pressure conditions by adjusting wand or changing tip. ... Honda Pressure Washers

Karcher K 2400 HH Psi pressure washer shoots water out of the chemical tube


... Karcher 2500 PSI Pressure Washer

How to feed solution rmv2.5 g30 pressure washer pump


... Pressure Washers

ISTEAD OF VACUM THE SOAP INJECTOR IS BACKING UP TO RESERVOIR PRESSURE WASHER


... Craftsman 2600 PSI Honda Powered Pressure Washer

My karcher k5.80 left on with no water feed now it just nums no water pressure


... Pressure Washers

I have a Generac MC660 pressure washer with a chemical injector on it The head bolt has broken where it bolts on to the pump. Do you carry parts?


This is a Help forum but you should be able to find a service dealer from Comet. Here is a link to their web site. LINK ... Comet BXD2527 Pressure Washer Pump

Karcher k3.86 lowered operating pressure and constant surging at idle, it back feeds into the water feed/supply hose until trigger is pressed


It sounds like your non-return valves are damaged. in the pump there are usualy 3 non-return valves, these are located under 3 large brass hexagonal caps. take the valve out and inspect them. if you are lucky they may just need cleaning, as sometimes ... Karcher K2.26 Electric Power Washer

CHEMICALS DO NOT MIX WITH WATER - Pressure Washers


... Pressure Washers

Can't get soap to feed into system - McCulloch FHH18A Electric Pressure Washer


I have a SIMONIZ S2000 electric. I bought the unit about 8 weeks ago used it once. On the second use yesterday the unit didn't work as well, the pressure seemed only a bit better than hose pressure and soap did not dispense at any pressure. SO.... af ... McCulloch FHH18A Electric Pressure Washer

Water shoots out of chemical injector hose on pressure washer


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0683 seconds