Having problems with your Indesit 18 in. D41 Slim-Line Free-standing Dishwasher ?

Hi, only have first light (pre wesh?) flashing, pump runs but nothing else happens??? Any ideas on the fault?


Answers :

Looks like the flood switch is activated. The dishwasher has detected a leak in the motor compartment and it shut down and tries to pump water out. Turn the power off and pull the dishwasher out. Tilt it to one side and then put it back in. This should move the water out if there are any leaks. Turn the power back on and check operation.
\015\012
\015\012Also try the Rapid 25' cycle and see if the behaviour is any different.
Repair Help & Product Troubleshooting for Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi, only have first light (pre wesh?) flashing, pump runs but nothing else happens??? Any ideas on the fault?


Looks like the flood switch is activated. The dishwasher has detected a leak in the motor compartment and it shut down and tries to pump water out. Turn the power off and pull the dishwasher out. Tilt it to one side and then put it back in. This shou ... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

Fault code f70, drain pump keeps running, nothing else works


Hi,\015\012\015\012Yes. F70 is a flood in the base of the unit which activates the float switch and constantly activates the drain pump until the water has gone. Isolate the unit at the power switch and remove the bottom panel under the ... Miele Optima G2470SCVi Built-in Dishwasher

Bosch Dishwasher has started acting upo. If I turn on the dishwasher it runs the pump for approx 2 seconds then cuts out. This carries on the cycle spraying the soapy suds around the compartment but there is no running pump sound. Any idea how I can access the pump to either attempt to clean it out or to replace it? Or does this indicate another fault that may need attention. Any idea of the cost of parts UK. Thanks for assistance ****


Most dishwashers pump out briefly before filling in order to clear pressure chamber. The next step is the water fill which is monitored by the pressure/level switch. Once water level is attained timer will advance through cold rinse cycle. If no fill ... Dishwashers

Drain pump runs continuously. Nothing else happens!


Water had accumulated in the sump - a plastic tray at the bottom of the dishwasher which catches any leaked water. This operates a float switch which makes the drain pump run all the time. The fix was to tilt the dishwasher backwards to drain away th ... Bosch Dishwashers

The water is pumped out after the rinse cycle then it continues to run and make an unusual noise but nothing happens. The noise is almost a grinding sound. There is also a smell like some part may be hot or the wiring may be hot. I can reset the dishwasher and re-run the cycle up until that same point and it does the same thing again. I have had a repairman out twice in the last six months. The first time he could find nothing wrong because the problem was intermittent and he couldn't see anythi


Timer \015\012\015\012or\015\012\015\012 ... Bosch Dishwashers

I have a Dewalt 3800 pressure washer fitted with a 67DX39G11 pump. Started unit up for the first this year, has pressure for 15 seconds then nothing. Water is flowing through okay, everything seems in order but no pressure. Unit is 2 years old but has only 15 hours of total running time. I think the pump has failed, is it normal for a pump to fail with only 15 hours on the clock?


... Dewalt 3800 PSI Pressure Washer

Hi I went away on holiday and my dishwasher AEG 50800 was in perfect order. When I came back after three weeks it does not work. It was not in use while I was away so I don't get how come it is not working now .It does start up but its like the pump is just not kicking in. Ihear water running but the blades dont move and nothing seems to get washed, any ideas. Or is a new expensive pump my only option? My Husband seems to think a seal might have gone. Can a seal go while not in use? Thanks


It's worth looking under the machine. There is an overflow area with a float switch which sometimes fills up and it stops it working ... AEG Dishwashers

2H displayed and pump runs nothing else happens


I, along with many others online, are experiencing the same problem. The bottom line is the control panel needs to be replaced. Beware, though, that the replacement panel may also be bad as I've seen many reports that they are poorly designed and Bos ... Bosch 24 in. SHU53 Built-in Dishwasher

I have a parmco td6s-f1 the drain pump keeps running and nothing else happens any thoughts


... Amana Dishwashers

I have a Hotpoint FDW80 Dishwasher. The drain pump runs continuously, even though there is no water inside, I poured water in with a kettle and it does drain correctly. After a short while fault code AL01 appears. I have removed the base tray to check the "anti-flood" swithch and that is OK, even with the switch disconnected, I still get AL01. Any ideas?


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Maytag MDBH945AWS dishwasher that makes loud noises when running through the wash cycle. When first purchased the DW was whisper quiet. At about 6 months it was noticeably louder. Then just recently it alternates between clicking (sounds like the soft food disposer), loud vibrating hum, and the medium loud hum that has been steadily increasing. I've disassembled it down to the motor and haven't found the problem. No obvious abrasion from parts interference. Nothing in the pump ass


... Maytag Jetclean II MDBH945AWS Stainless Steel Built-in Dishwasher

Bosch Logixx dishwasher gets stuck on either wash or final rinse programme and runs all night until stopped manually. heat, pump, water supply, arms led controls all working. Any ideas as to the fault


You have a bad control module. send me a 4 thumbs post if this was helpful to you.p.s im a old bosch tech ... Bosch 24 in. SGS09L12 Logixx Free-standing Dishwasher

I have a parmco td6s-f1 the drain pump keeps running and nothing else happens any thoughts


... Amana Dishwashers

Hi, I have a Fagor 1VF-453IT dishwasher and one day I switched it on - it did nothing else but all the red LEDs (5, I think) started to flash. And that's it, it doesn't run. No idea why, but I'd appreciate a hint before calling a mechanic or starting spending huge amounts for parts and repairs. Any chance for a reset or something? Thanks a lot!


... Dishwashers

Becod 2731fw dish washer pump running continualy on turning the washer on and nothing else


Lower tray flooded have u been using 5 in 1 tabs iff so dont use rinse aid iff not check inlet inside d/washer left hand side tighten up tip machine 2 45 degrees either side this will empty tray ... Beko 24 in. D3731F Free-standing Dishwasher

My Kenmore Elite suddenly stopped filling with water. I pushed start but when I checked it hours later the soap dispenser door had opened, the soap is just lying in a puddle, and nothing is clean but the clean light on the front panel is blinking. I tried again to no avail. Any ideas? I've had the machine since it first came on the market and have had other issues with it--it never drains completely, it makes sounds like someone revving a sports car engine when the drain pump is engaged, my dish


Https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a4 ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Just installed an estate TUD6710S and on the first run it is leaking from the check valve. It is leaking from the pump side of the valve. There isn't any leak where I have the drain connected. I do not have a garbage disposal, so, there's not a problem there. The drain connection is 20" from the sub-floor... don't know what else to check.


... Estate TUD6710 Built-in Dishwasher

Kenmore Elite 630.1630 (made by Bosch) sounds like the pump is running but there is no water coming into the washer. The timer starts over like normal, but nothing else happens.


... Dishwashers

Bosch SHU43C My Bosch SHU43C is stuck with the drain pump running. I ran the self-test and it gave me the fault code 4 wich indicates a filling fault. The washer is empty and all wash cycles display the correct number of minutes for the cycle. It counts down to 0, but the pump continues to run. Does this indicate a stuck float, or is the problem with the control board? Where is the float located? Are diagrams/pictures available on-line anywhere? I've done some searching, but haven't found any. R


My SHU43C is just over 3 years old. I had a similar problem recently. First, there were a few floods. Then, the Bosch only drained non-stop. Even when I used the Cancel Drain buttons the drain pump would run without stopping. When I ... Bosch 24 in. SHU43 Built-in Dishwasher

Good mroning after starting any program first the pump will run followed by water intake. After a while the machine stops and the light intake/drain starts blinking. Most of the time water will stay in the machine. After pressing the on/off bottom first switching the machine on again and starting a new program the machine pump start running emptying the water but than stops after a short water intake again. I opened the water stop but it seems to be ok. The filter inside the machine is cle


Good morning don't get shocked because ullu ki to abhi subah hi hui he ... Miele 24 in. G892SCU Plus Built-in Dishwasher

Dishwasher LFK-011S: First it occasionally gave four beeps (overflow) but no water in bottom or under. I then noticed that with lower water pressure machine worked ok few months. Now last week in the middle of program, drain pump started to run, machine gave four beeps and pump kept running even main switch off. Now when I plug in power cord, the pump starts to run immediatelly


... Fagor LFA013 SS 23 in Builtin Dishwasher

Shx98mo9uc dishwasher has the drain pump running constantly. Do I replace the pump or is there something else triggering it to keep running? The dishwasher will not drain also.


... Bosch SHX98M09UC Integra 800 Series Dishwasher w/Display

Asko diswasher Dishwasher will not get water. Lines all checked, water on. Pump runs even when in off. Problem started when there was a water clog in the sink next to the dishwasher, and the dishwasher backfilled with water. We used a shop vac to get the dirty water out. Next day tried to use dishwasher, runs, but no water and empying pump will not stop running. Ideas?


Check for water leaks or not draining/overfilling fault ... Asko D1776 Stainless Steel Built-in Dishwasher

E1 fault code Dishwasher runs for about 5 minutes. Water fills up at bottom of unit and then machine seems to pause then fault code E1 appears then water is pumped out from bottom of machine. There are no leaking pipes and drain is installed correctly. I installed a new wash pump and fault still appears.


Hi,\015\012I think both the heater and thermostat / trip switches need to be checked.\015\012If water is going in and out ok, then it seems to be waiting to heat the water. It sees a fault - so just clears out.\015\012Heating elemen ... Dishwashers

I have a mod KDSU01DJ that will not drain. I've had it all apart, there are no clogs, nothing stuck. I bench tested the motor and the pump, both run ok. It seems like the pump isn't pushing hard enough. Should the motor be running with the pump during the drain cycle. I"m stumped. Thanks.


Yes the drain pump motor must be running during the drain cycle.This manual will help trace your problem.4317196.pdf ... KitchenAid KUDS01DJ - Multiple Color Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1423 seconds