Having problems with your Indesit 24 in. D61 Free-standing Dishwasher ?

Indesit WD10 Washer dryer seal needs replaced. Where can i buy the part and is it an easy job to fix myself????

\015 As above\015

Answers :

Hire a tech and have him get the parts or order them for him.
alternately, you could attempt to do this service on your own.
unless you are very mechanically inclined, you will be very frustrated trying to get this apart.
some things are better left for others that do it all the time. if you have a lot of time and do not value it much, then you could attempt this.
if this is a washer/dryer unit, you might have leaks from doing it yourself. and then again, you might not. having someone else do it is no guarantee they will not err, and give you leaks too.
good luck
mark
Repair Help & Product Troubleshooting for Indesit 24 in. D61 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Indesit WD10 Washer dryer seal needs replaced. Where can i buy the part and is it an easy job to fix myself????


Hire a tech and have him get the parts or order them for him.alternately, you could attempt to do this service on your own. unless you are very mechanically inclined, you will be very frustrated trying to get this apart.some things ... Indesit 24 in. D61 Free-standing Dishwasher

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

Dish washer Hi there, Last time I started my dishwasher, clear water spilled out in a large amount. We pulled the washer out to realize some plastic parts underneath had totally smashed down. Is it possible to replace those parts, or do I need to buy a new washer?


Yes youcan replace them just give dishwasher name ? ... GE Dishwashers

After a power surge the dishwasher does not work at all. It just beeps constantly. There are no lights on the touch pad at all. The only thing that stops it from beeping is to remove the 2 pin black and white wires. I replaced the control module. Nothing changes. Do I need to replace the touch pad? What about the 3 digit clock? These parts together cost 145 dollars. I do not want to buy these parts and put them in to find out that did not fix the issue. I also unplugged the


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

How do fix a replacement lower door seal on an Ariston LSV66 dish washer, the replacement part is not the same as the original and I'm unable to workout how the new clips securely hold the seal in place


... Dishwashers

Dishwasher racks are falling apart from rust. I would like to replace them, but am confused as to what parts to buy. Also, do you know where to buy them? When I searched for replacements, it seems like by the time I finish buying all the replacement parts, I should just replace the entire dishwasher!


The racks are like 200 dollars a piece,replace the dish washer. ... Dishwashers

I recently purchases a KitchenAid dishwasher model kudsosfrss from a thrift store (I know, silly me). On intallation I learnd why it was in the thrift store. The Normal and Start/Resume buttons are dead on the keypad, and the washer will not run. I don't want to throw good money after bad, but if I can buy parts and fix it myself I figure it might be worth it. Any suggestions?


8574143 is the part number for the black console control panel which is the part i believe u want,, u may look at it or purchase it at repairclinic.com, searspartsdirect.com, hope this helps let me know ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

Is it possible to buy replacement parts for a 204627 gs pressure washer gun???


... Briggs & Stratton 204627gs Pressure Washer Gun Up To 3000 Psi

The front panel doesn't work anymore. There is electricity going into the dishwasher but the panel doesn't light up. Is this an easy part to replace or should get an appliance repair man to fix.


May just be the door switch(s) ... Whirlpool 24 in. DU1148XTP Built-in Dishwasher

Do I need a repairman to replace my broken door handle (part#99002839??rn Is this an easy fix I can do myself??


You can try if you have tools. If it is complicated do not attempt as you may have to open up the entire door cabinet.Try opening from the gasket edges of the door and use the machine. Hope no locking arrangement in the handle !! ... Jenn-Air JDB6510 Built-in Dishwasher

Sears dishwasher 665.15882000 part #8268296 fell off and I can't find the "screw" that holds it in place...probably went down the drain. Now dishes do not "dry" on air dry. The part that matches the number for replacement parts does not look at all like the one that fell off. The one I have is round and the replacement one showing looks like some funky ninja weapon. Will this work on my machine? How easy is it to replace this part?


... Dishwashers

My KitchenAid KUDS01FLSS0 won't turn on when the "Start" button is pushed. Several months ago it began requiring multiple pushes to get it to start. All the cycle lights on the control panel work when pushed - except the "Start" button. Online & repair parts person suggested I replace the: - Tail Cable Ribbon; did not fix problem, then - - Electronic Control Board (interface) which also did not fix it. Should I replace the Electronic Control Board that is actually the part with the buttons


... KitchenAid Dishwashers

I purchased a replacement lower dishwasher basket for a DU8500XB-0 Whirlpool. The replacement part is W10311986. The part fits washer as far as rolling in and out, but there are 4 extra parts that I don't know how they fit, no paper work with the part from FSP. Basket probably fits more than one machine. Would like to know how the extra parts fit the basket. Thanks


Did you get a response to your question? I have the same question. ... Whirlpool W10311986 DISHRACK

I have a Karcher 550M pressure washer and was using today when all of a sudden the water started to pour through the handle hence lost the pressure of the water. Is this a rubber washer issue or the gun needs replacing or simpler than that. To be honest although I have had the washer for about 3/4 years now It is hardly used. Also can I fix it and where would I purchase the allen key to replace. Thanks Brian


... Karcher Pressure Washer Gun 91120200 91120200

My dishwasher's top rotating sprayer keeps coming loose. The screw and plastic bearing fall out and I think that it has stripped out the end where it seats into the top of the washer. Any ideas on how to anchor this in? Adhesive? A larger screw? The plastic bearing is Part No. 568 and the screw is Part No. 569. If I replace the conduit arm (Part No. 585), will that give it a new, clean spot to screw in too? How difficult is it to replace this arm?


\012Hi,\012That is not that hard to fix and you can easily buy the parts yourself online...Here is a tip that will help you with the online buying...How to Buy ... Dishwashers

Upper spray arm and tube assembly. This part fell off the back wall. Can not figure out how to get it to stay on again. Looks like it should clip in, but nothing to snap it in place. The part does not look brocken when compared to the part would order to replace. No info in the manual and their service department was no help, How do I fix this.


Hi,\012Those p[arts wear and even though the parts do not look broken they are not up to the specs. of a new part...\012That is not that hard to fix and you can easily buy the parts yourself online... ... Bosch 23 in. SHU 8805 Built-in Dishwasher

I do a mucky job we catch chickens so imagine the muck n grime..........all a sudden washer won't drain.........replaced pipe from washer to drainpipe but now washer got mind of its own......help please


... Servis 23 in. M4306 Free-standing Dishwasher

I have a McCULLOCH 1500 psi pressure washer and it seems like I need the top part of therod where the waer comes out it no longer adjusts the water stream seems like a little plastic defkector that you adjust your stream with, snapped and broke looks like I HAVE TO REPLACE THE ENTIRE TOP PART OF THE 2 PIECE ROD on the bar it says the following max130barmax60C PA66-GF30 Where could I purchase this piece Andy Nowostawsky my adress is 15447-rue d'esterel Pierrefonds,Quebec H9H 1Y9


... McCulloch Pressure Washers

Need to replace detergent dispenser-how difficult is this? The rinse aid portion of the dispenser does not work but it is a one piece unit. How easy is it to swap this part out. It is for the Jenn Air but is Maytag part 99003320 Thanks


Hi Jeff. These parts are easy to swap out. Just be sure to kill the power at the breaker first. Also, consider this. IF you use the newer tabe, or plastic pillow style dishwasher detergent you can just toss it into the machine and close the door, ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

I have Whirlpool ADP 962 dishwasher. The front door is leaking when washer is running. I can feel a rubber seal at the bottom of the door, when I open the door, which seal is wavy and corrugated. How do I replace the seal, and what is replacement part number. Thanks Trevor H


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012\012q4w5ifgf ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

The detergent dispenser cover release tab broke off and the cover doesn't stay shut prior to starting the washing cycle. Is this easy to replace and if so, where can replacement parts be purchased?


... Bosch SHU5315UC Dishwasher

Looking for manual for honda pressure washer,its a GX 340 11.0 HP that I can view online without buying so I can find the part and part number


Go to this page: \015\012\015\012http://www.jackssmallengines.com/help.cfm\015\012\015\012You must have your exact engine model number lis ... Honda Pressure Washer PSI 3000

Bosch dishwasher the string on the door tensioner has broken I have the new part but dont know how to got out the lower part. Do I have to take off the hole door or is there an easy way to change it? It seems odd that as its string and must be prone to breaking that there is not a simple way to fix it.


You have to remove the entire dishwasher from under the counter. Then locate the broken cable. There is a panel you need to remove to access it. It attaches to a spring which goes to the underside of the dishwasher. Not an easy repair. Need alot ... LG 24 in. LDF 7811 Built-in Dishwasher

I have a hole in the water hose to my pressure washer. Can I fix it or do I have to buy a new pressure washer? Loraine


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1403 seconds