Having problems with your Indesit 24 in. D61 Free-standing Dishwasher ?

Door catch plate Indesit d61

\015 I have ordered a new Merloni door catch plate as the original has snapped and wondered if someone could tell me how to replace it please. The cost of fitting a \302\2434.00 door catch plate is ridiculous! Hoping some one out there will be able to help me and explain in detail. Many thanks. Callie\015

Answers :

Undo the screws at the top of the front door and puul the control unit out this gives you acsess to the door catch which is quite simple to replace be careful the stainless steel is quite sharpe
Repair Help & Product Troubleshooting for Indesit 24 in. D61 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Door catch plate Indesit d61


Undo the screws at the top of the front door and puul the control unit out this gives you acsess to the door catch which is quite simple to replace be careful the stainless steel is quite sharpe ... Indesit 24 in. D61 Free-standing Dishwasher

I have a 13-year-old Maytag DWU9906BAE. It has worked well but the door now opens too far - about 20 degrees lower than horizontal. I've taken the door apart and the reason is that the upright part of the two L-shaped hinge plates no longer catch on the back of the door jamb; for some reason they are now angled too far out and miss the catch plate on the back of the jamb completely. I'm no expert but they don't look warped, nor does the frame that they attach to. They're made of stamped


... Maytag Dishwashers

Indesit d63 dishwasher, door locked shut. took top off+got to latch, the plastic catch wouldn't pull out of the latch. undid it all, all seems unbroken but cannot seem to arrange the latch so that it will allow the plastic catch to come out when levered. also not sure if the handle is supposed to click the switch to another position, or just tweak the switch as it opens the door. is a new latch supplied with the switch ?


Check with whoever you order the latch from, usually parts are individual for electrical parts and never assume that the screw or washer will come with new one, save every piece. ... Indesit 24 in. D63 Free-standing Dishwasher

Indesit IDL500 door catch killed dishwasher


... Indesit 24 in. IDL500 Built-In Dishwasher

How do i fit replacement bottom door seal to indesit d61 dishwasher as it is different to original and is supplied with thee metal clips


... Dishwashers

Indesit IDL500 door wont close properly, catch appears to be the problem?


A lever inside the door lock is attached to a spring. If the lever or spring is broken, it wont lock. ... Dishwashers

Indesit D61 dishwasher... Upper spray arm catches/sticks on back of machine. Can I only use upper tray on lower setting hence unable to wash dinner plates in bottom tray due to height restriction.


... Indesit 24 in. D61 Free-standing Dishwasher

Door catch broke.door no longer clicks shut - Indesit Dishwashers


You can replace it, you need to know the model number. http://www.apwagner.com/ ... Indesit Dishwashers

Unable to shut the door on my Indesit DE43 dishwasher. The catch appears to be stuck in the open position.


... Indesit Dishwashers

I have an Indesit D63 and would like to know where I can buy the "catch" that fits in the top side of the door: A tenant removed this part and just left two screws so I do not know the part No. or what it looks like. I live near Gerona, Cataluna. PS the tenant did a bunk !!


Please refer this manual. It might be helpful if you can lead me to the part if it is visible in the illustrations o ... Indesit 24 in. D63 Free-standing Dishwasher

Indesit di260 hi door catch has broken got new one need to know where the screws are hidden to undo this to replace it thanks


Indeset DI620 appears not to be pumping water in, light 1 flashes as error code is it the motor? ... Indesit 23 in. DV62 IX Built-in Dishwasher

Indesit dishwasher door wont close , and keep dclosed, the catch doen1t seem to work anymore , dishwasher working fine , water leaking from below because not closing properly , have had dishwasher for 2 yrs no problems as yet .Wondered if this was a common fault thanks


On a D61 I managed to solve this without dismantling the door!If you look carefully in the hole where the white catch fits you can see the shaft it rocks on. I put a small screwdriver in here and levered it forwards. It didn't want to stay so I ... Indesit 24 in. D63 Free-standing Dishwasher

Door catch does not engage when door is closed. The programme still works even though the catch does not engage. I have changed the door catch and the micro switch but the catch remains in the same position


... Dishwashers

Door catch Door closes but latch inside door panel does not lock in place so door will not remain closed. Appears that plastic part in door catch recess will rotate but is not under any spring pressure and will not lock in place.


Hi.Usually the spring is not sold as a single part.You will need to replace the door lock.Regards. ... Dishwashers

Smeg DI612CA integrated door springs open, catch won't hold when trying to close door. Have removed before and reset catch. Same problem now seen again. Likely that I need new catch unit, or could problem be electronic?


... Dishwashers

Mtsui mf145 faulty door catch. the door is not shutting and i think catch is broken


... Dishwashers

Electrolux ESL 63010 dishwasher. This worked fine until the door catch broke. I replaced the catch but could not remember which way round the two electrical leads went (red and black). I tried both ways with the same result. The lights come on the control panel and I can change the programme, but on closing the door the house fuses blow. I have checked the earth cable is fine. Any ideas?


Red - is active powerblack - ground or neutral ... Electrolux Dishwashers

Door won't shut on dishwasher indesit idl 535 took the front cover off. right hand spring at base of door sheared off can't identify part on indesit website


... Ariston Technologies Dishwashers

I am having problems with my smeg dishwasher door. The machine is three months old. The bottom left hand corner of the door is catching on the outer wall of the machine and catching and cracking the bottom plastic drip tray. The model is SA8210w


This a faulty installation and adjustment of the door. Whilst it is not directly a manufacturers fault it should be covered anyway, as installation is generally by the distributor or the manufacturers agent.It is also generally condsidered under law ... Dishwashers

I have purchased a repalcement detergent dispenser-assembly and do not know how to take old one out and relpace with new part. The new part has a face plate that snaps on to the screw mounted base plate assembly which attaches to the door. I need to know how to remove the old dispenser and install the new dispenser without breaking parts and scratching the door. Is there a schematic or exploded repair view I can check out or even written directions?


Hello\015\012& Welcome to FixYa\015\012\015\012To replace the detergent\015\012dispenser you can check this video. The video gives you step by step\015\012instructions:\015\012\015 ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

I have a Fisher and Paykel Nautilus DW920 dishwasher. However, the door to the detergent dispenser does not open reliably every load -- usually I have to open the dishwasher door about 20 minutes into the load and open the soap dispenser myself. The catch on the dispenser will have released, but the dispenser door will not have sprung open. I am not sure exactly what the problem is -- the soap dispenser door simply seems a bit stiff in its holster. Given a little nudge, it springs open fine. I h


... Dishwashers

Neff dishwasher door catch not corking, door does not close ?


Look carefully at the catch and the latch as almost all can be adjusted with just a screw driver. ... Neff 24 in. S4456 Built-in Dishwasher

Indesit D61 dishwaher


I've had this problem when the sprayers are partially blocked, might be worth checking them if you have this problem, tweezers can be helpful for removing bits of rice or whatever may be causing the block. ... Indesit 24 in. D61 Free-standing Dishwasher

Indesit d61 dishwasher


Contact parts dept for unit. check on line. should be easy to get.good luckmark ... Indesit 24 in. D61 Free-standing Dishwasher

Smeg integrated dishwasher door does not close tite. it closes with the catch at the top and stays closed but it not flush with the rest of the doors and is angeled open a few mm or more which causes it to leek from the front bottom corner, how can I get the door to close properly ? thanks


... Smeg 24 in. DWF1 2 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0880 seconds