Having problems with your Jackson 10A Free-standing Dishwasher ?

We have and older Jackson model 10 AB at church, used 10 to 20 times per year. The pump motor quit this summer and was replaced by a local appliance service company. About $700 job. Upon using it recently, the first time since the new pump was installed, the RINSE cycle seems very anemic, that is, low volume and low spin rate. The dishes were not completely rinsed. Temperature was correct, 185 degrees. The service person came back to look with no improvement and now the Heaters will not co


Answers :

Sounds like a wiring problem but it is controled by a thermo to make sure you get to the proper tempt . so ck the connections and mke sure the thermo is good . . and the element is good . ..hope this helps mm .. ps run the dishwasher at least several times a month as sitting to long is not good for it . ( once a week would be even better ..) mm
Repair Help & Product Troubleshooting for Jackson 10A Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have and older Jackson model 10 AB at church, used 10 to 20 times per year. The pump motor quit this summer and was replaced by a local appliance service company. About $700 job. Upon using it recently, the first time since the new pump was installed, the RINSE cycle seems very anemic, that is, low volume and low spin rate. The dishes were not completely rinsed. Temperature was correct, 185 degrees. The service person came back to look with no improvement and now the Heaters will not co


Sounds like a wiring problem but it is controled by a thermo to make sure you get to the proper tempt . so ck the connections and mke sure the thermo is good . . and the element is good . ..hope this helps mm . ... Jackson 10A Free-standing Dishwasher

I had a service tech at my house to repair my refrigerator. He also took a look at my Maytag WU504 dishwaser, which was not cleaning the dishes anymore. He was less familiar with dishwasher diagnosis, but found that the lower spray arm was pumping out water through the jets properly in the cycles, but that the spray arm was not rotating. He seemed stumped and called his supervisor, who suggested it might be the wash impeller. I have looked at the parts diagram on partselectdotcom and taken t


You are absolutely correct!!\015\012\015\012The support retaining nut allows the arm to spin without falling off.\015\012\015\012And it would definately cause dishes not to clean if the arm didnt rotate.\015\012\01 ... Dishwashers

Hi, I have an LG LDS4821 dishwasher and it appears to stop working properly. The dishes don't seem to be cleaned at all. It seems like the spray arms are not spraying the dishes as the dishes are still dry/dirty after a normal wash cycle. I did notice that the detergent was used during the wash, and a trail of white residue was at the bottom of the tub. I can hear water pumping into the dishwasher, but when I opened it during a wash cycle, there was a puddle of water at the bottom of the


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... LG LDS4821 24 in. Built-in Dishwasher

When starting a wash cycle it pumps out the remaining water as usual. It fills normally but does not pump/wash the dishes. It continues to heat and when first noticed it seemed to have gone through the complete cycle but didn't wash. The detergent door had opened and the soap pack dropped out but it never dissolved. The dishes were extremely hot too. Is the same pump used to both drain the washer and wash the dishes?


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Asko 24 in. 1805 Built-in Dishwasher

Dishwasher is not cleaning well, dirty film all over everything, like its not rinsing. In rinse cycle only, some water comes out of lower left port inside but nothing else. Hear a low buzz underneath unit like a motor or pump is energized but no water getting to the top.During normal wash cycle, buzz from underneath seems to cycle on and off, say every minute or so like its cycling on an overload. Do I have a bad pump and if so how do I get to it?


Hi. This may well be a pump issue, or an obstructed hose assembly, as well. Your symptoms are indicating that the impeller may be damaged. In order to pull the necessary schematics, I will need the entire model number. This ID tag will allow me to pu ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Dishwasher The dishwasher detergent door opens during cycle but powdered soap remains in tray. At end of cycle glasses and dishes are wet. a little water is left undrained at bottom. This is a Frigidaire model FDB510LCS1. Checked upper and lower spray arms and they seem ok and pump seems to be working


I have seen this problem before on a couple of dishwashers.\015\012\015\012How are the dishes doing? Are they coming out clean, or do some of them "fail". \015\012\015\012If you rinse the dishes before putting them in the di ... Dishwashers

Whirlpool dishwasher doesn't seem to fill with enough water despite good water pressure. Therefore, pump sounds like it is cycling from pumping water for about 2 seconds to going dry for 2 seconds to pumping water for 2 seconds to going dry for 2 seconds, etc. Spray arms rotate only for the 2 seconds when pump is actually pumping water. Dishes do not get clean.


... Whirlpool 24 in. GU2548XTPS Built-in Dishwasher

My Frigidaire Model FDB2810LDC1 dishwasher will not stop running. Seems to complete a normal cycle and different cycles can be selected with normal time countdown but at end only rinse agent low light remains lit and sounds as if pump is still running. If opened, water appears to be streaming from rotator arms. Have cycled power but symptoms remain.


... Frigidaire Dishwashers

Noisy dishwasher my Kenmore quietguard 4 has developed an exceptionally loud hum/buzzing noise seemingly coming from the door of the dishwasher, when closed, locked and put on either drain or wash cycle.If the unit is allowed to sit for 1-2 days, the drain cycle will empty the tub without the buzzing noise starting. If anything else is attempted afterwards, like a wash cycle, the noise immediatley starts at a low level, then becomes steadily louder, until the full volume is reached, and does not


I have aloud buzzing nose and humming what is the problem ... Dishwashers

The spray arms do not seem to be rotating. The dishes are not getting clean and even though we had the spray devices cleaned by a service tech and just ran a full wash cycle with vinegar, the soap dispenser isn't fully cleaned of soap and the dirtiest of the dishes are still soiled.


Probably the pump is bad ... Dishwashers

My Asko D1606 doesn't seem to be filling/retaining enough water to pump actively through the swing arms. When I add a litre or so of water in manually and hold in the door catch, I can see it appear to start working properly. The tablet is still sitting on the bottom of the dishwasher after the cycle has ended and the dishes are still dirty. The pump sounds all right and it is emptying fine. Also, probably due to the lack of water, the cutlery basket has melted right through, and I am sure any p


Check to see it the dishwasher has been pushed back ever so slightly. The water coming into dishwashers and exiting are on timers and if the hose is pinched this can affect it. Your dishwasher may appear to be in the same place but just pull it forw ... Dishwashers

Noticed dishes on top shelf not entirely clean. Ran machine empty and opened many times during wash. Noticed that Lower Spray Arm works as expected, but Middle Spray Arm turns only 1/8 or less, then Lower Arm spins again. Schematic with Use and Care manual just says pump motor switches from one to the other in certain cycles, but I don't see this happening. Looked for obstructions to water flow and pressure seems normal. Is control for this function part of the pump, or in the control panel?


Something could be in that checkball, see page 5 ... Frigidaire 24 in. GLDB653A Built-in Dishwasher

My 5 year old bosch dishwasher cycles to one minute and then cycles forever and ever with very soapy water in the bottom. After a very long time, the water is out of the dishwasher but soap residue is left on the dishes and the bottom ot the dishwasher.We are presently using only 1/2 teaspoon of detergent (Finish brand). I have had a repairman here to look at it, but he didn't seem confident that it was a timer issue and even though I have paid the exorbitant service call fee, I am not sure I wa


Hello,Welcome to FixYa.Based on your description ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

I have a Kenmore dishwasher and recently it seems to have stopped pumping the water, as in stopped spraying the water. It still sounds the same and runs through the cycles but it seems to only steam the dished as opposed to wash them. There is no leaking of any kind.


Water not getting to the unit as they should be or your pump is clog with left over you will need to take the spray arm out and get to the pump and clean it.watch for broken glass!!! ... Kenmore 24 in. 15689 Built-in Dishwasher

SGS5022GB/07 Dishwasher. Water seems to be pumping into unit but not washing dishes. Full cycle running but doesn't seem to be any water circulating.


... Bosch Dishwashers

I don't have the model number here but it is the machine with the three control buttons on the front of the door. It seems to have lost its programming. It will start and do the initial small flushing wash. The pump runs. But it never seems to do the actual washing cycle. The dishes, although wet, are not clean. Yours truly, Brian Felske email [email protected]


... Dishwashers

Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.


... Bosch Dishwashers

I got a whirlpool dish washer Adp4407. When the machine is switched on it carries out the cycles but seems that the hot water cycle is not working and the dishes are still unclean even after completin


... Dishwashers

My Bosch dishwasher SMU 7052 UC/14 does "nothing". You can select the cycle, the timer progresses, but nothing happens - no water, no pump.... About 7 years ago I replaced the inlet valve, but that seem fine this time. Anyone have a service manual? Andy


... Dishwashers

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

Dishlex DX450 has been working OK for years - suddenly not washing - white deposits and cutlery looks greasy - but machine clean and all filters and arms clear of debris. Have removed pumps and hoses - all clean - no obvious problems. Seems to complete a full cycle - but the problem is consistent every wash - independent of the dishes. Welcome any insights - thank you, Richard


... Electrolux Dishwashers

Same problem. motor/pump cycling when trigger is not pulled. There are no leaks, no air in the pump, low pressure. It seems it is losing pressure internally, is there a bypass valve that may be leaking?


... Karcher K2.26 Electric Power Washer

Model #gld5800l15cc doesn't clean dishes. doesn't seem to fill enuff before the cycle. the pump starves. for the heck of it I poured water into it manually and it worked fine. all the sparayers then had good pressure. I cleaned the inlet screen at the solenoid and its still the same. Help please!!!!!


Replace the level sensor in the tub of the washer. ... GE Dishwashers

The dishes have food residue washed onto them and water spots on all glasses regardless of the amount of detergentinse agent. The pump seems fine there is no water left in the machine after a cycle. any suggestions other than getting a new machine? thank you!


Hi,The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your ... Bosch 24 in. SHU43 Built-in Dishwasher

Water sounds like its comming to dishwasher after awhile dial turns(timer) disher wsher goes in to dishcharge pumping out water but inside of dish washer seems dry like no wash cycle took place


Look inside the dishwasher for large plastic mushroom-shaped thing in the bottom.\015\012This is a float.\015\012Sometimes a knife or fork or something else gets in the bottom of the dishwasher and won't let the float go down. When the float is up li ... Asko D1706 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1777 seconds