Having problems with your Jackson 25 in. TempStar HH-ST Free-standing Dishwasher ?

We have two Jackson dishwashers - both broken - and have been told they can't be fixed because Jackson is out of business. True? Call 302-734-2222 or email at [email protected] We would LOVE to get them repaired. They do not run. They come on, warm up, but nothing happens.


Answers :

Repair Help & Product Troubleshooting for Jackson 25 in. TempStar HH-ST Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have two Jackson dishwashers - both broken - and have been told they can't be fixed because Jackson is out of business. True? Call 302-734-2222 or email at [email protected] We would LOVE to get them repaired. They do not run. They come on, warm up, but nothing happens.


... Jackson 25 in. TempStar HH-ST Free-standing Dishwasher

AS PER DIRECTIONS FROM TECH, I PURCHASED AND INSTALLED A NEW CONTROL UNIT. THIS WAS BECAUSE MY WHIRLPOOL DISHWASHER GOLD GU2300XTLB3 QUIT WORKING IN ALL CYCLES EXCEPT SHORT CYCLE. PUT EVERYTHING BACK TOGETHER AND TRIED TO GET THE DIFFERENT CYCLES TO WORK. NOTHING WORKED EXCEPT THE CLEAN LITE FLASHED A CODE 7.(FLASHED 7 TIMES THEN QUIT. THEN IT WOULD FLASHED 7 MORE TIMES THEN QUIT) iT HS BEEN DOING THIS FOR WELL OVER 24 HOURS. WHAT MUST I DO TO GET BY THIS ERROR CODE AND GET IT TO START W


Hi,This is a common problem with Whirlpool washers.If\015\012the clean light is the one flashing then your dishwasher could have a\015\012heater circuit problem (depending on the age) or this could simply just\015\012be water colder ... Dishwashers

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have used the McCulloch (FH180A) three times over the course of two years. On my fourth use the pressure washer just surged on and off and I would get a tiny spray from the gun each time it surged. In other words it would do nothing. Please help... very frustrated. Thanks


Sounds like the problem could be low input water flow or pressure. There could be crud on the intake where you hook up the garden hose, there could be some other sort of blockage. Try hooking it up to the hose and pull the trigger (with the po ... McCulloch FH180A Electric Pressure Washer

I have a KitchenAid Dishwasher KUDIO1iLBS2 and none of the lights come on and if I press any of the buttons nothing happens. The unit is getting power to it as I shocked myself. I did ordered and replaced the control board and still nothing is happening. Any suggestions or ideas? Is there a reset button or is there a possible fuse that is out that would make the lights not come on? Please help.


... KitchenAid Dishwashers

My Viking dishwasher won't fill with water. The motor seems to be running but no water enters the chamber. It's Sunday morning so I'm not able to get a repair person here. I got a response that said ''The ventilators are blocked. Turn it off and have the motor checked'' i was hoping for instructions on how to unblock the ventilators or clean it out. I have a house full of people for the weekend and would love to get this thing back up before Monday when a repair person could come. Any suggestion


... Viking Dishwashers

AEG Favorit 675 Once you press the on button, the inlet solonoid opens and the container below the dishwasher fills but nothing happens after that.I'am an electrical contractor who would love a circuit diagram to this model so i can follow the squence of operation, it is my own dishwasher.


See this manualpag 19-21http://www.serviceforce.co.uk/pdfs/U04142.pdfSergio ... Dishwashers

Kenmore ultra wash quiet guard dishwasher, the pots and pans and the normal wash button are blinking. The start and cancel and smart wash out tons have a faint light glowing. Thoughts? I tried the sequence of pressing heated dry, normal wash, heated dry, normal wash and that did nothing. I've flipped the breaker too. I was in process of taking it apart to clean filter, thinking that would help, but lost my manual and now I can't get that off to flea either:(. Sig


... Kenmore 24 in. 15689 Built-in Dishwasher

Hi, I have a Fisher and Paykel DD603 dishwasher. The bottom drawer works fine but the top drawer doesnt work at all. It appears normal until the start button is pushed and then I get 3 very quick beeps followed but a 4th slightly longer beep. Then nothing happens, any ideas or help would be much appreciated. Thanks Neville.


... Fisher and Paykel 24 in. DD603MFC Built-In Dishwasher

I have misplaced manual for my Jackson Omega CS dishmachine serial no. 017 3271 M I would like obtain a copy or get a download. Thanx John


Hi.Jackson CS is same as Jackson delta 5, here the manuals:Delta ... Jackson 25 in. Conserver XL Free-standing Dishwasher

Hi I have a dishlex global 500 and the handle broke. Whilst I was replacing the handle some cables came lose an got disconnected.. So I would love it if it is possible to get some sort diagram or something to plug the cables back in the correct spots Thank you


See the diagram attached.sincerely. God bless you ... Dishwashers

Kitchen Aid model KUDS01FLSS3, water gets pumped into bottom of dishwasher but when the cycle needs to change to shoot the water over the dishes nothing happens. When the cancel button is pushed all the water will drain.I have cleaned out the bottom drain compartment that was jammed with calcium build up and guck. Would this be a pump /motor problem or electrical circuit board problem?


... KitchenAid Dishwashers

When I hit start, nothing happens. It won't even light up. This was happening for a while and I would hit other buttons to eventually get the start to work, but now it doesn't work at all


Bad fuse or control board is shot ... Maytag Dishwashers

Bosch DW model SHU53A05UC/17 was working fine until yesterday evening. Went to turn it on and now get nothing. No lights, no power zip. It's on its own 20amp circuit. Checked the fuse and it's not blown. Flip the breaker on/off a few times anyway to make sure. I was installing a floor and used my miter saw on the sump pump circuit (diff from the DW circuit). It blew the fuse a few times. Any chance, on a diff circuit, it spiked and damaged a board in the DW? What part (part #) would


... Dishwashers

FDB750RCC1 When I start the DW, the motor hums loud then soft then loud then soft...if I advance the dial some sections of the cycle nothing will be running and others the motor is on, but no water is getting into the unit. I just replaced the inlet valve and solenoid and that didn't change anything. I can see water in the recirculating pipe running up the unit, but it will just try to make it up and fall back down. Not sure how to proceed...my thoughts would lead me to the main motor, but


Can you hear the water solenoid click when it calls for water? If so, check that the water source valve is on and water comes out of the valve. Check the entry hose for kinks. Remove everything under the lower arm down to the deck keeping track ... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

Husky Model HU80833 pressure washer was working, then no pressure. What is wrong? Unit is over two years old. Had been working properly earlier in day. While trying to finish job, it lost pressure and nothing would make it get back up to pressure. Also tried it again later, same result


... Honda Pressure Washers

Kitchen Aid model KUDS01FLSS3, water gets pumped into bottom of dishwasher but when the cycle needs to change to shoot the water over the dishes nothing happens. When the cancel button is pushed all the water will drain.I have cleaned out the bottom drain compartment that was jammed with calcium build up and guck. Would this be a pump /motor problem or electrical circuit board problem?


... KitchenAid Dishwashers

I have a Kenmore Elite 665 Dishwasher. The front control display has been partially working but the dishwasher still worked. Today when we tried to start it it will do nothing & it is getting the correct power. Would this be the control circuit board or something else?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Dishwasher I turn on the dishwasher and all the buttons flash, (no noise) i can go through and try and select a setting but when i press start nothing happens the buttons just keep flashing? Do you have an instruction manual or can you tell me how i would get one?


What brand is it? go to that web site put in model number and download it there. also you might have the controls locked press and hold the heated dry button for three seconds to see if that unlocks the controlls. ... Dishwashers

Upper spray arm and tube assembly. This part fell off the back wall. Can not figure out how to get it to stay on again. Looks like it should clip in, but nothing to snap it in place. The part does not look brocken when compared to the part would order to replace. No info in the manual and their service department was no help, How do I fix this.


Hi,\012Those p[arts wear and even though the parts do not look broken they are not up to the specs. of a new part...\012That is not that hard to fix and you can easily buy the parts yourself online... ... Bosch 23 in. SHU 8805 Built-in Dishwasher

I have a Maytag Mod MDB8750AWS. I want to know how to get to the internal food disposer so I can clean it? Diagram would be helpfull, there is nothing in my owners manual about this!


Your problem is probably in the filter plate. Remove spray arm, filter cover, impellar housing and impellar.Them you can remove the filter plate. You can see a break down at ww ... Dishwashers

I bought the unit almost a year ago -my warranty is not up yet- but i can't get it work properly. Dos not matter what i put in it or how it always comes out spotty or greasy or food particle dried on the dishes. I checked the water temperature, the soap , tried different make, quantity, texture nothing helps. I gave up using it but i would like to find out what to do before the warranty is up. !!?? Model: Maytag dishwasher MDB 5601 AWBO NW 4212949


The problem is hard water. There is a new product out called the dishwasher filtration system. It filters the water before it enters your dishwasher. It works amazing and has a money back guarantee. You will love the ... Maytag 24 in. MDB5651A Built-in Dishwasher

We have a Kenmore Ultra Wash Dishwasher, several years old. The lock light went on yesterday and we could not put it on wash or anything. We hit cancel, unplugged the machine, left the door open so it would stop the cycle...nothing worked. How do you get the lock off when it goes on like that? I just went into the kitchen, shut the door and the lock was off, strange.


There is a key (usually the dry key) that needs to be held for 4 seconds to turn the child lock on or off. If it comes on again try holding this key for 4 seconds.If it was pressed and held by mistake this could cause the lock to activate ... Kenmore Dishwashers

I have a bosch SHU6802UC dish washer. Recently the cycles were getting very long (3+ hours) and now when you press power/start, the unit turns on and you can hear the rather loud hum (pump?) of the cycle starting but it does not do anything else, just continues the loud hum. No cycle, does not fill with water, nothing. I ran the diaognostic and it immediately came up "7" on the display. Any thoughts or direction would be greatly appreciated. FYI, I did thuroughly clean it which made no di


There are a few possibities...if you remove the lid and take the two t20 screw off the left side panel at the front you could check the pressure chamber and its hose are not blocked. Use the link and go to page 4, part 263834 and 361113. You ca ... Dishwashers

Our dishwasher doesn't seem to be getting the dishes clean anymore and leaves a residue. We have changed detergents and all that, but to no avail. Is there a filter or something that needs to be cleaned or changed? I would love to have my clear glasses clear again. Thank you very much for any input you can give me


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1166 seconds