Having problems with your Jackson Dishwashers ?

Serial # 03G10787M Model: AJ-44CE Is this a high temp dishwasher?


Answers :

Repair Help & Product Troubleshooting for Jackson Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Serial # 03G10787M Model: AJ-44CE Is this a high temp dishwasher?


... Jackson Dishwashers

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers

I have a Maytag Quiet Series 300 Dishwasher (can't find any other model number etc). The normal and high temp wash lights are steady and the Start/Resume light is flashing. I've tried turning off the power and the high temp, heated dry, high temp, heated dry sequence but nothing works. Any help would be really appreciated! Thanks


... Maytag 24 in. MDB5651A Built-in Dishwasher

KitchenAid dishwasher, Model # KUDP021RBS1 - "Normal and cancel lights blink constantly". I had this same problem about two weeks ago so I googled your site and though the solution I found was not exactly applicable to my problem but I tried and that is - Press high Temp, heated dry, high temp and then heated dry and then cancel button and then close the door. Would you believe it worked like a magic wand. But this same problem resurfaced and I am trying all those old tricks but nothing is worki


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a kitchenaid dishwasher, SS, model # KUDIO1ILBL6. When you press the ''normal'' button to run it, nothing happens. Tried other cycles and same thing, the green light goes on above the cycle but its just not starting. I tried resetting by opening, pressing high temp scrub then energy saver dry, high temp scrub, energy save dry, then close and hit cancel. Is there any other combo to reset it? or does it sound like something else is wrong? thanks!


... KitchenAid Dishwashers

Extremely heavy limescale residue on all items after dishwasher has finished. water temp in house has been turned down. Had water tested by city water company and results were clear. 12 months ago maytag replaced heater element under recall, but dishwasher always seems too hot. Neighbours do not have this problem. Any advice would be most welcome.we only use quality powder and rinse aid. Have cleaned dishwasher numerous occasions. model MDB4651AWS1 SERIAL # NW5015848


Hi,The scum, film and white residueproblems have started since the reductionof phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your dish ... Maytag 24 in. MDB4651AWS Stainless Steel Built-in Dishwasher

I have a Jenn Air high end dishwasher. It is very ambiguous on what model, type or serial number is but the number next to ''type:'' is 776-0 and there is a an E39927. jov1270awy and a 49022. None of he numbers or references have any description that indicates their purpose. Symptom: We can not get the dishwasher to start up. The buttons for choosing what type of wash will light up but when the power button is pressed it does not light up and the dishwasher will not start. Needless to say the ki


... Jackson Dishwashers

Here again is my model and serial it stops in the middle of the cleaning cycle Kenmore 665.16773402 serial # ft0302854 Here is how I have been resetting the dishwasher. I hit the following sequence of buttons: Normal Wash Heated Dry Normal Wash Heated Dry Normal Wash After that ? all the lights are lit up as follows: Smart Wash, Pots Pans, Normal Wash, China Gentle, Turbo Zone, Hi Temp Wash, Sani Rinse, Heated Dry, Sanitized (Green light ? not a button), Lock on (Red Light ? no


Door latch.Open and close the door to make sure the door latch is securely fastened\015\012 \015\012Hi-Temp Wash, Hi-Temp Rinse, or Sanitize options.Some models have options that may requi ... Dishwashers

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.


... Kenmore 24 in. 16022 Built-in Dishwasher

I have frigidaire dishwasher model # FFBD2411NS. It stopped working as if it had no power. I switched the breaker swith to shut if of then tut on. After that the lights above the "high temp wash" and "heat dry" buttons started blinking. What is going on?


Hello Marcus, since you have already reset the dishwasher, confirm\012that the door is properly latched and try selecting a cycle. If resetting the power did not correct the issue, it\012could potentially mean a number of things: a potential wiring f ... Frigidaire FFBD2411NS

Frigidaire dishwasher Model# FDBB4365FC0 Display shows PF (blinking) Air Dry and High Temp Wash LEDs are blinking Electronic board has recently been exchanged.


Hi t_l_stock...hope this helps..Good luck..Hi-Temp Wash, Hi-Temp Rinse, or Sanitize options.Some models have options that may require a water heating delay, such as Hi-Temp Wash, Hi-Temp Rinse, or Sanitize. Additional time may be re ... Dishwashers

I have model KUDL03VWH0 kitchenaid dishwasher. Since I bought it the dishes have a white film on them unless I use High temp scrub. Now the soap is not released until after the cycle is over.


... KitchenAid KUDS301V Dishwasher

I have a model FDB2310LCC2 dishwasher and it won't turn on. The column cycle lights washing cleaning drying and sanitizing are all blinking simultaneously along with the "high temp wash" light. I de-energized the circuit breaker for approx. 1 minute then re-energized and no difference is noted. Any ideas?


This may be a problem with the door interlock switches. You will need to shut off power to the dishwasher, unscrew the control panel and remove the wires to the door switch ( make note of where the wires go on the switches) and check the switches wit ... Dishwashers

Kenmore Elite Drawer Dishwasher model 465.13329600 Normal Wash and High Temp Wash buttons stay lit, as does green Lock button. The Start/Resume button and the red button on the front of the drawer keep flashing. I've tried key combos suggested above, but nothing seems to work. Even tried shutting it off at the circuit breaker to reset it, and that didn't work either. This ****** was purchased in 2006 or 2007, and hasn't been used very much. WTF?


... Kenmore Dishwashers

Dishwasher Manual hot point electronic model su2000es serial by173426. In the temps window the letters c d are lit up


... Hotpoint Dishwashers

Frigidaire dishwasher Model GLD2250RD50: Stopped washing dishes when a ran the garburator full of water, panel lights of high temp and nearby started flashing, then I pressed cancel/start, lights went out the washer wont run, checked breaker no problem. door latched,


... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

My kenmore dishwasher model 665.13749K603 the Quiet Guard Deluxe will not select any of the wash functions. The only lights that will work are the high temp, sani rinse and heated dry. When I test the mashine all of the functions work. Please help this is driving me crazy.


... Kenmore Dishwashers

Tank temp Our School Dist. has a Hobart dishwasher Model AM 15 T. After filling the unit it reaches a tank temp. of approx. 160 F, but when it is run through a couple cycles the temp. falls below 140 F, the min. wash temp is 150 F. The supply from the hot water tank is approx. 140 F. The rinse cycle reaches well above the 180 F min. Is there anyway to adjust the tank temp. on this model or could you suggest a solution to the problem. Thank-you John Fry


Check to see if your element is scaled up or your element may be damaged ... Hobart AM15T Dishwasher

I have a newer model GE dishwasher. About a couple of weeks ago we lost power to home. When power was returned the dishwasher was making a high pitch sound and power was not returned to the front display. I had to remove a black/white wire from front of the display to make the high pitch sound go away. Do you have any solutions to make the high pitch so go away and for power to be restored to the front display? Thank you.


Hello\015\012\015\012High pitch sound comes when the main control also known as the electronic board goes bad and needs replacement. Please try to blow air with hair dryer on the display just to check if that'll solve the problem. Hope yo ... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

I would like to purchase a Moyer Diebel U/C dishwasher for residential use. I have the option of purchasing a used dishwasher - it could be one of three models. Which one is the model he is trying to sell to me? 1. 501 HT 2. 501 HTN 3. 501 LT the owner states the voltage is 120/208-240 and heats between 150 f and 180f.He notes there is a 4 ft. cord at the back without a plug on the end of it but the model is rubbed off of the serial number tag.There are three switches on the lower right hand co


The way you mentioned the unit have a 4 ft. cord at the back seem like a 50l LT the best way to determent is open up the bottom plate and see whether there is a booster tank in the right hand side. \015\012Hope this can help you. ... Moyer Diebel 24 in. 501HT Built-in Dishwasher

DISHWASHER NOISE I HAVE A HOTPOINT DISHWASHER MODEL HDA3420Z02BB SERIAL # TT813162Y. IT IS ABOUT 10 YEARS OLD AND JUST TONIGHT DEVELOPED A CLICKING/ GRINDING NOISE AT THE BOTTOM OF THE DISHWASHER. I REMOVED THE LOWER COVERS AND IT APPEARS TO BE COMONG FROM THE MOTOR AREA OR I GUESS THAT IS THE PUMP ATTACHED TO IT. JUST WONDERED IF THERE IS A PATTERN FAILURE WITH THIS MODEL AND IF SO IS IT FAIRLY EASY REPAIRED?


A noise could be created by something getting down into the motor-pump assembly piece of glass, piece of bone, wire tie anything really. If this is the case and you can remove it before it causes further damage problem solved. At ten years old the ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Dishwasher I can't find my model . My lady kenmore ultrawash dishwasher,665. model# 1690192,serial# FX4510556. I need a manual for my dishwasher


Grazi, your part number for the use and care manual is LIT3368766. You may have to call Whirlpool, thats who made this dishwasher and inquire with them. Im not finding it on any parts suppliers...Catriver. ... Kenmore 24 in. 16304 Built-in Dishwasher

I need to find out the serial # of a Bosch dishwasher Model # SHX56B05UC. Any number will do. I trashed mine and now I find I need the serial number or one like it. Thanks you so much, Monty


Hi,One of the serial numbers for your modelTH43115371Thanks. ... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher

The washing, heated dry, and normal wash light just flash. I have unplugged and plugged it back in several time, i tried restting it by holding down the Rinse only button for 15 seconds. I pressed the high temp ater, heated dry, high temp water, heated dry buttons to try to reset. I also ran the hot water line that feeds the dishwasher until the water was hot. Nothing has helped. The machine is18 months old and therefor no longer under warranty.


Please provide the make and model number of the dishwasher.\015\012do you hear pumps running? what was the last cycle it was at when the flashing started. was there water left at the base of the dishwasher from the cycle that stopped? ... Dishwashers

I have an older under the counter high temp dish washer not sure the model number but it has the three switches on the lower left, has both upper and lower wands and it is high temp. Not for sure but it seem like the homing cam switch is not working you can manually turn the came to get machine working but when it shuts off it wont restart when you close and latch the door could you please help!


The cam switch may be faulty and may be available for replacement.\015\012\015\012Hard to find replacement without model no. but for the current model it is available ... Moyer Diebel Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2263 seconds