Having problems with your Jackson JPX-300L Dishwasher ?

The motor does not turn at all I can heard a MMMMMMMM like somothing is stock.


Answers :

Repair Help & Product Troubleshooting for Jackson JPX-300L Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The motor does not turn at all I can heard a MMMMMMMM like somothing is stock.


... Jackson JPX-300L Dishwasher

I pressed the POWER button to turn on the dishwasher. I pressed the SELECT button, hit HEATED DRY button and the LIGHT WASH buttons. I then hit the START/PAUSE button to start the cycle. All lights came on as normal & I heard the machine trying to **** up water like it normally does. Within 5 minutes or so, the machine started to BEEP & BEEP every minute. When I came to the check why the beeping noise was on, I saw that all the WASH PROGRAM lights were all blinking. I hit the START/PAUSE


... Haier ESD210 / ESD211 Built-in Dishwasher

Hi, we have a Electrolux DX302WB/03. It has worked ok for a few years. The problem now is when we turn it on it make a noise like it is starting then a small amount of water noise is heard then nothing. The timer clock runs untill the finish time but there is no wash.


Check the water inlet flow. Clean the strainer attached to the machine end of inlet hose.Add water from the front to the wash chamber 10 liters and run the m/c. It should become alright if any air lock inside water pump. ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

Kenmore dishwasher 665.13843K601 ser. FU4806977 STOCK 13843K TYPE 575-0 Tried to turn it on won't start/ run/ perform any functions The following buttons light up but will not perform functions; Smart wash and heated dry also lights up like it should, pots and pans, normal, fast wash, high temp, sani rinse The following buttons do not perform functions or light up Quick rinse, Turbo ZOne, Delay Hrs., Cancel/Drain, Start/Resume I killed the power to it for 1 minute for reset but d


The touch pad is not working. Pull the front kick plate from font/bottom of machine and there is a 'TECH SHEET'. This has a complete diagnostic sequence for you to go through and verify the functions for you. ... Dishwashers

Bosch shu8806 Hello, I aquired a shu8806 recently and it doesn't work. It has power and water. I push wash cycle, indicator light comes on, shut door and nothing happens.  So the door switch seemed like a good place to start. Since I am an electrician I thought I would give it a shot. When plugged in, the wire from the motor is 120V but when jumpered to the neutral(common on the door switch), motor doesn't operate. Although, I have heard the motor turn over momentarialy when trying to run unit e


The pump may be clogged, or the motor start capacitor may be bad or some units have a fill switch wired inline with the motor so it won't start unless the unit is full ... Bosch 23 in. SHU 8805 Built-in Dishwasher

I have a Smeg dishwasher SA660 EB. Still like new . Hardley used but have problems with the timer switch not progressing past 5 and also had the thermostat replaced as a loud bang heard and the machine did not work. Since warranty on repair run out it sounds like water is leaking around the thermostat through onto electrics as loud bang noise heard again . I found the thermostat just pushes up into the rubber seal in the bottom of the dishwasher. I have taken out the rubber seal as this also loo


... Smeg Dishwashers

Dishwasher problem The cycle is done but still making a noise like its draining. Turned it off but when turned on again still makes sound like water is trying to drain out


... Thermador DWHD64EP Built-in Dishwasher

I have a Siemens Dishwasher. I'm not sure of the model but it is built in, has concealed controls and was purchased about 6 years ago at Best Buy. It sort of looks like the SL85. When started, it runs for a few minutes and then starts to make a horrible sound. ALmost a grinding sound but may also be like water trying to get through a small opening. The sound does not stop even after turning off the DW and even the power to it. Only turning off the water supply does it stop. Help?


... Siemens SL85A705UC 24 in. Built-in Dishwasher

We have a ASKO D3450, and it have worked perfectly well for 8 years. Today we have a problem with it. It look like the children-secure is activated becouse the AUTO-lamp is lightning. We try to turn it off, by turn off the power, hold the two keybuttons and turn it on again, press program; and then the AUTO-light should be turned off, but this dosent happend. When we close the door, the machine start to wash, but it seems that no program is activated, and the soap chamber does not open at all.


You have lost the control board.... ... Asko 24 in. D3450 Dishwasher

When I turn on the power washer, it turns on but it shuts back down. It sounds like it wants to turn on but it doesnt.PLease help. Its my friends powerwasher he uses at work. I cant get the exact model.


Some washers turn themselves off when low on oil, check the oil level ... Pressure Washers

Just turned the dishwasher on at the wall and tap after it's been sat off for a day. It's done one cycle (eco) and now doesn't seem to be doing anything but flashing. The two lights flashing are the power and eco lights. I have tried turning it off on the console but it turns itself back on and continues flashing. It sounds like it's whirring but I can't hear water. It did have a small leak when we first plumbed it in if that makes any difference?


... Hotpoint 18 in. DC27 Slim-Line Built-in Dishwasher

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

My ds603 wont work ... i turn it on press start it gives a beep but nothing happens, then the display will turn off ? I have also noticed that when i oren the drawer it doesnt turn on automaticly like


... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Hotpoint BF1620 dishwasher will not turn off only at socket. noise is like the continual pump of emptying dishwasher. tries changing programme, turning on off, keeps turning itself on and pumping


There is a malfunction of the washer controller. Hence the mode is not shifting off from the pump as it does not end the programme. Hence you will have to confirm the output of the controller if the drive is short or functioning by itself. Since even ... Hotpoint Dishwashers

Have a Westinghouse 905 dishwasher (guessing approx 5-10yrs old). When I turn it on it's starts is cycle as expected then stops after about 10mins and loses all power (can't turn it on or get any lights to light up for sometime almost like it needs to cool down) at this point the dishwasher is full of water. It is not the pump however as as soon as you can get power to it (sometimes some hours later) and turn it on the first thing it does is pump out the water. Any ideas??


It is likely the thermal relay is tripping. This could be because if you are feeding hot water to inlet the temperature of water is too high, or the dishwasher heater is faulty and overheating the water. Or it is also possible the thermal cutout is s ... Westinghouse Dishwashers

I have a Bosch she44c dishwasher that I used just this morning. This afternoon I went to turn it on and a fuse in the panel box tripped. Is there something in the dishwasher that could go bad that quickly or is it most likely something else? Every time I reset the fuse and turned on the dishwasher, it tripped again. Leaving the dishwasher off, it doesn't trip.


Hi,\015\012\015\012In some cases, the heat element lining wears out and the element shorts out to the chasis of the dishwahser, thus tripping your fuse.\015\012\015\012In other cases, the dishwaser leaks water, and shorts out ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

I have an Indesit IDL 42 dishwasher. It has entered a state in which it behaves like this: as soon as I turn it on, it starts swishing the water around (it doesn't pump it out) and it does that regardless of whether I press any buttons (I have tried Start, Reset, turning the program knob, no difference at all). When I open it in the middle of this cycle, the water drips, and there is plenty of water (about 1 in) at the bottom. I have checked the filter, it is clean. Can you please help?


... Dishwashers

XL30 Hi temp. Two problems: 1) Hi temp booster not working...worked on and off for awhile, now won't get up to 180. 2) Turned on today and water flooded out. Water overfilled machine, turned off and heard pump drain unit.


To attempt to solve the over filling, clean the probes in the back right corner. Use a green scrubby pad.\015\012\015\012There is also two probes under the front screen. Clean them too.\015\012\015\012As far as the booster not ... Dishwashers

Belling Dishwasher IDW450. When turn on power button it starts bleeping. About 25 times. The you can select your program, it sounds like it is draining but then doesnt do anything else. Cant hear any water running in. I have turned the power off and back on. Water is connected


When you say you have turned the power off and back on. do you mean the switch on the appliance. if so turn off the power by removing the fuse from the fuse panel for the dishwasher. wait about ten minutes, put the fuse back in and see if that res ... Belling 24 in. IDW603 Built-in Dishwasher

Acts like water is turned off to machine. turns on to run cycle but no water comes out. valve is on


Turn the water valve off, and remove the hose. Where it screwed on, there should be a filter screen. This is more then likely to be clogged up. Clean this and try again after you put the hose back on.With the dishwasher in the fill position, and stil ... GE 24 in. Profile PDW7800 Built-in Dishwasher

My Danby portable dishwasher has stopped working. It sounds like something is happening when you turn it on but then the dial will not turn and complete the cycle.


... Danby DDW1805W Designer Series Free-Standing Dishwasher

Heard grinding-like noise during last operation. Now fills, heats, drains, but does not wash. A humming can be heard when should be washing. Motor?


Probably. i wouldn't turn it on again till you get it fixed, if it's the motor that's humming like that, there's a possibility that it might catch on fire. ... Kenmore Dishwashers

Champion dishwasher we have a champion freestanding dishwasher at my church. after the cycle is completed, the pressure guage behind the washer still shows 25-30 and it contnues to spray water. not forced by the motor, but more like a stuck open fill valve. if i turn off the water and run it, then turn the water back on, the valve is closed and does not let water freely in. butif i run it with the water on, it will continue to spray in freely after the cycle light goes out and you open the door.


If you turn the unit off from the circuit breaker will the water still run?if so the guts inside the solenoid valve are worn.you can call champion and get a kit to replace the worn parts and its not difficult to do.hope this helps. ... Dishwashers

My dishwasher is going crazy -- keeps turning both drawers on, beeping like crazy, and sounds like it's trying to wash, even when the drawers are open! HELP! Laura


Bad Control Board is most likely the problem, as nothing else really would cause this and as long as you are getting water into the machine still. You should be able to order a new one though the place you bought it or through the manufacturer themse ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

It wont start . not been used in over a year. used 3 times. it sounds like it will almost turn on but not turn over


... Honda Pressure Washer PSI 3000
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0648 seconds