Having problems with your Jenn-Air 24 in. JDB1090A Built-in Dishwasher ?

No lights on the control panel nothing works is there a re-set,


Answers :

Repair Help & Product Troubleshooting for Jenn-Air 24 in. JDB1090A Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a GE Profile CDW9000 series that all cycles and setting appear to work on ok BUT several of the blue lights on the control panel don't work?are burned out. As a result its hard to know what the settings are..The selection lights for 1 of the 5 clean cycles is out, the 8 hr delay light is out , as is the heated dry light and the start / reset light.My question is can these be replaced ? individually? or is it a single unit ? if so any helo with what the parts are called/ numbers and hard c


... GE 24 in. Profile PDW9800J Built-in Dishwasher

3 sec light on control panel blinks .. dishwasher wont star. None of the other control lights come on. I have reset the breaker in the main panel to attempt to reset any internal breakers with no results. When I attempt to set anuy of the options, the 3sec light blinks then returns to a solid light.


Go to maytag website they have all kinds of help there ... Maytag 24 in. MDBH950AWS Built-in Dishwasher

My kitchen aid dishwasher will not start I replaced the interface control board thinking that was the obvious problem. When you go to set the dishwasher to start some of the settings don't always light up then when you push the start button the lights will flash then start but it's not flashing and won't start. I get lucky once in a while and get it to flash then start. I don't know where else to look. I don't want to start replacing parts one at a time till I get lucky. My model # is KUDIO1F


Check all cables especially the ribbon cables from the user interface to the electronic control assembly as steam from dishwashings will create small amounts of corrosion and inhibit signals to and from these 2 components,unplug each,inspect,and reco ... KitchenAid Dishwashers

I have a Kenmore Elite dishwasher with electronic controls. When I set the controls press the start pad and close the door it will not start. The light on the start pad just continues to blink. This happened about six months ago and the Sears serviceman pressed two of the control pads simultaneously and this reset the controls. Everything worked after he did this. What are the two control pads that you press to reset the controls?


This is difficult to find out. Try different combinations. Otherwise get the information from the SEARS serviceman. ... Dishwashers

Regarding Maytag Dishwasher, model # mdb4651aww3. Most of the lights on the control panel will not light up. You can't change cycles or set the delay timer etc. You can hit the start button and it runs a perfect cycle, and ends up with clean dishes. You just have no idea what cycle it runs.


I have same problem with my Maytag. Had a repair guy come out and he said it's the 'controller card', not the button touchpanel. The controller card is $127 and not in stock and there's a 'several month wait'. I'm not going to wait, going to buy ... Maytag 24 in. MDB4651A Built-in Dishwasher

PDW9280J10SS dishwasher has been in use for about 3 years. The control panel is not working properly. I use the up/down arrows and it turns on heated dry etc. When I push the heated dry button, it changes the lights to the different cycles (which is what the arrow keys used to do). The normal wash light won't come on, the only setting that seems to wash a full cylce is antibacterial. It seems like something burned out. What should I be looking at as a possible cause/fix. Unfortunately, I don't h


... GE 24 in. Profile PDW9280JSS Built-in Dishwasher

I have a Type S9J1S - SE64A630GB dishwasher which is not progressing beyond draining. With power on it seems to be constantly draining. There are no lights displayed on the control panel strip, and I cannot force it to re-set. This suggests to me that it is an electrical control-panel problem. Any assistance gratefully received!


... Siemens 24 in. SE64A630GB Built-In Dishwasher

Dishwasher won't start and it is plugged to working outlet. Control panel lights do light up. When I turn the setting dial to start, nothing happens. It looks like the last cycle never finished as there is water on the bottom. Any thoughts what might be wrong?


... Whirlpool DU912 Dishwasher

Model du1055xtp03 cannot operate the control panel condition,the unit light come on, but will not operated the setting


... Dishwashers

Cookworks wqp8-9239 slimline dishwasher. Start the cycle on setting 1-4 and half to three quarters of the way through it stops and starts beeping with the first 3 buttons of the control panel flashing. The manual says when lights begin to glimmer the machine is out of order? can i ficks this without sending for repair man?


... Dishwashers

ELS63010/S-No 91210714 Electrolux Dishwasher On Controls Top Red Light is flashing.I am unable to get back into normal program mode,and i am not certain if machine is filling. How do i get into setting mode


... Electrolux 23 in. ESL624 Built-in Dishwasher

Kenmore dishwasher control panel will not light up to determine setting


... Kenmore 24 in. 16039 Built-in Dishwasher

No lights on the control panel nothing works is there a re-set,


... Jenn-Air 24 in. JDB1090A Built-in Dishwasher

Installed a new control panel on my PLD4375RFC0 dishwasher and when power was turned on the PF light flashed then went off when the door opened. However, the screen remains blank even when pressing buttons to apply a setting. Have cut power and turned back on several times with same results.


... Frigidaire PLD4375RFC Dishwasher

I have a Frigidaire 1500 series with fully electronic control dishwasher. When I try to start it all the lights come on the display but not water enters the dishwasher. I have tried various settings including delay start but still the same outcome. The over-fill protector in the bottom of the dishwasher moves freely. What else should I try?


... Frigidaire Dishwashers

My Siemens L34A dishwasher will not respond to turning the power on and off, nor any dihswashing settings. It appears to be 'frozen' with the lights on the control panel permanently on, I have tried to reset it by turning it off at the breaker switch, but with no luck.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Check continuity to the door switch if that appears to be fine\015\012then it is the control ... Siemens 24 in. SL34A006UC Built-in Dishwasher

WHY ARE THE LIGHTS BLINKING ON MY DISHWASHER - Maytag Jetclean Plus MDB4630AWB Full Console Dishwasher with 5 Wash Cycles, 12 Place Settings, Heated Dry Option, JetClean Plus Wash System, Control Lockout and Energy Star Qualified: Black


... Maytag Jetclean Plus MDB4630AWB Full Console Dishwasher with 5 Wash Cycles, 12 Place Settings, Heated Dry Option, JetClean Plus Wash System, Control Lockout and Energy Star Qualified: Black

Whirlpool quiet partner 980 series. Washer will not run a wash cycle. Can set a wash program up on control panel and the red indicater lights are appropriatly on.


... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

Model GSB6400NDC0 replaced control board, now all lights flashing on LED with error code Er. Buttons flash when held. Dishwasher will not register settings or work at all.


What is the part number you replaced?\015\012It is possibly the wrong one.\015\012\015\012Thanks ... Dishwashers

Center light on control panel is on. symbol looks like a lock. cannot set washer to start.


Its in child lock mode. push and hold the lock button for 4 or 5 sec it should unlock. ... Dishwashers

Maytag dishwasher mdc4650 dim panel lights and control panel buttons don't work to change any settings


... Maytag MDC4650AWB 24 in Builtin Dishwasher

Maytag dishwasher mdc4650 dim panel lights will not start and control panel buttons don't work to change any settings


... Maytag MDC4650AWB 24 in Builtin Dishwasher

The start button on KitchenAid model #kudp01flbl6 will not engage, although all of the other lights in the control panel light when pressed. The cancel button will turn off the other lights in the control panel as well. This diswasher is 5 yeras old and lightly used in a household of just 2 professional adults. I've had service come and he uncovered a "burned' conection in the electronic control assembly p/n 8564542, which looked to me to be P8. A new electronic control panel was installed


HI. I need you to clarify somethign for me. You mentioned that you have replaced the " electronic control panel". Are you reffering to the interface board or the actual plastci panel? I understand that the part number "8564542" in in reference to the ... Dishwashers

Leak from a De Dietrich Integrated Dishwasher has caused 3 red lights on the left of the Control Panel to flash and also a Blue Light on the right hand side of the Control Panel to flash. On resetting the Appliance Controls, the machine starts pumping out and then closes down, with the Control Panel lights flashing again. Help


Pull the built in unit out and tilt towards the rear right leg and the water will drain on to the floor. The Dishwasher then restarts but the anti flood sensor will reactivate after 2-3 more washes. Do not know final fix yet. ... De Dietrich Dishwashers

I have a Whirlpool dishwasher model #DU920PFGQ4. The controls locked light is flashing, and when I press the air dry key for 5 seconds it won't unlock, however the cancel/drain light starts flashing. When I press the cancel key the controls lock light will stop flashing, but will resume as soon as I release the cancel key. I have tried disconnecting power for 24 hours, but as soon as I plug it back up it does the same thing. Nothing else on the control panel will work.


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0628 seconds