Having problems with your Jenn-Air Dishwashers ?

Would like to change the door cover from white to stainless, have the part but cannot find the screwa o tke off the door cover


Answers :

Please provide the full model number of the dishwasher.
Pull out the machine. Unplug it and remove the water lines.
\015\012Tilt machine on it's back. Take the door cover and pull it out, Then flip it around to the stainless steel side and slide it back in place.
Repair Help & Product Troubleshooting for Jenn-Air Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Would like to change the door cover from white to stainless, have the part but cannot find the screwa o tke off the door cover


Please provide the full model number of the dishwasher. ... Jenn-Air Dishwashers

Put dishwasher on and 3 hours later went to unload. opened door to find END light had not come on and both 55 degree buttons were lit (I'm sure I only depressed middle 55 degree button button), 65 degree button was unlit. There was still some water in the bottom of the appliance. went through the procedure in the manual but cannot change the current state of the appliance i.e. the 2 lights on. HELP PLEASE! Model is TECNIK FD7811


... Tecnik Dishwashers

Leaking at bottom of front door with suds and water coming out. Cannot find the model number. Seals on door (3 sides) are fine. Cannot see a seal for under the door.


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012dafhrw ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

My husband removed the inner panel from the dishwasher door to see why the "door open" light was on after he changed the front panel from white to black. He shut the door without the inner panel and now we cannot open the dishwasher!


It would be helpful to have the full model number of the dishwasher.\015\012\015\012The trick would be to drag the dishwasher out from under the counter and open the foot plate and the spring assembly. Hopefully you may be able to lift th ... Kenmore Dishwashers

CDA CW497 Integrated Dishwasher. Please advise how to connect the door as I do not have the installation manual and have changed all my kitchen doors, but now cannot get the door on the dishwasher.


Please note the link to download this manual has now changed to http://www.cda.eu/Downloads/Manual/2176/cw497_im.pdf ... Dishwashers

I have a Bosch SHU8805UC/14 dishwasher. I took the front door panel off to install it better but ended up with two extra pieces that look like either part 935400 Door Guard, or 935526 Support. I cannot seem to find any place on the inside of the door where these pieces would fit. The dishwasher works fine but seems like it got noisier after I put it back together without these two parts. Can you help me locate the proper place for these 2 plastic parts?


Hello, \015\012\015\012Welcome to FixYa.\015\012\015\012I believe the parts you are referring to are likely the blocks in each corner of the outer door panel. These have been a sticking point for many I tech over ... Bosch Dishwashers

Whirlpool DU980QPDQ3: As per FixYa solution, I was successful in removing the inner panel of my dishwasher door in order to clean it. Since reinstalling the inner door panel, including the cover and drawbar for the detergent dispenser latch, the dispenser door will not open during the wash cycle. I have checked everything and cannot figure out what is wrong. I have only been able to locate disassembly instructions, but not the detailed assembly instructions that I need to get the dispenser do


Here are a few videos that may help\015\012Click on the link http://www.youtube.com/watch?v=MDideDjjuEU\015\012\015\012Click on the link ... Dishwashers

Broken maytag door latch assembly Maytag quiet series 300: the latch is not working, door is closed and cannot open, seems something snapped inside, how can I open the door ? and change the broken part ?


To open this latch, the handle works as a lever to push inward when you push up on the handle. If your handle if broken, it has probably ceased to work as a lever (the pivot pins have likely broken). You want to push in on the handle to open the latc ... Maytag 24 in. MDB3700 Built-in Dishwasher

Miele G842SC - opened the door while the dishwasher was running, the washer kept running and when I shut the door it stopped working. I have un-plugged the power and tryed to re-start but no luck. The Canada center says it is going to be 2 week for a repair and I have to wait to the day of to find out when the repair person is going to be there. I cannot believe the lack of service and support for this product.


... Miele Dishwashers

We have a leak around the door. It looks like it is around the bottom of the door. We can not find any reason for this. We have checked seals and everything else we can think off at no avaiel. Model 15919. We have found pieces of black stuff on the floor like maybe a protective cover that is deteriorateing . Other then that, everything else is fine. Thanks Dan


... Kenmore 15919 Built-in Dishwasher

How do I remove the main conduit on my GE Triton XL dishwasher? The cover inlet that traps food from going down the drain somehow came off and clogged up the drain. I got the drain cleared but cannot get the cover back on and need to move the main conduit (pipe connecting lower and upper arms) before I can get it on. Anyone know before I spend too much $ finding someone to fix it?


... GE Dishwashers

We have an older model kenmore dishwasher. There are three panels with this dishwasher and we can't find our manuel to tell how to change the panels. Can you please help us by telling us what we have to do to change the panel on the door to another colour?


... Kenmore Dishwashers

Inglis dishwasher the colour pannel on the door bulged and fell out. How can I put it back? We lost our user's manual that would describe how to change colour pannels and I am sure I could figure it out from there. could you explain the procedure or tell me where to find the user's manual on line?


Inglis dishwasher works well until it drains. It doesn't know enough to stop draining and begins to make a whining noise and will not stop. Like it doesn't know to go to the next stage. How do I fix this? ... Dishwashers

Soap residue on dishes. DIshes are clean except that there is soap scum on them and on the door. Have checked water temperature and water flow and cannot find any problems. Vinegar removes the scum


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Bosch 24 in. SHX46A05 Stainless Steel Built-in Dishwasher

Dishwasher fills with hot water. Float OK - water feed stops when full. Motor humms but no water spray (in all opperating modes). Cancel selection (with cancel button) and close the door. The water drains then the unit shuts off. Water feed OK. Drain Cycle OK. Looks like spray pump hung but do not know. Cannot find a reset button (as with disposal) or way to free hung pump motor. I did see glass pieces in the drain. Possibly a small piece hanging the motor.


If you found broken glass inside the machine some has likely migrated to the pump. about the only way to fix that issue is to remove the pump and either replace it or disassemble it and clean it out. ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

My CDA cw496/1 integrated dishwasher starts beeping continuiously 10 mins into the cycle. So I open the door and the water is cold and the getergent tablet has not dissolved. I cannot change the cycle option either so I suspect there is a problem with the PCB? Any advice would be appreciated.


... Dishwashers

I have a F&P dishwasher model DW60CDX1 (around 5 years old) which we cannot start a cycle. The dishwasher turns on (power button and all programme indicators light up) but when you press a programme button nothing happens - the lights don't change. We have switched the power off at the powerpoint and on again a few times but this has not rectified the problem. It was playing up before this in that sometimes the programme would not start when a button was pressed but I just closed the door mor


The micro switch in the door which senses the door closing has probably failled. This is accessible once the inner door cover is removed. Switch should be under $10 from electrical store. Or buy through appliance manufacturer. ... Fisher and Paykel Dishwashers

There is water under the doors during every cycle but I cannot find why. There is also water under the machine causing the anti flood to activate.


The door gets bent outwards when loading and unloading so it doesn't make a good seal (gradually over time).... open machine and gently lift (pry) up on the inside base of the door. you will probably see that it is bent down a bit (it doesn't take mu ... Dishwashers

I have a Dishlex Glendale Deluxe and need a new seal for the bottom of the door. I cannot find what model number it is to source the part. Do you know what the part no. or model no. would be?


I have a Dishlex Glendale dishwasher and the model no is 10014380092 if that helps you. ... Dishwashers

We have a Bosch SHX43C05UC/40 dishwasher. It did not come with a user manual and I cannot seem to find one online. The dishwasher is great in all aspects except I do not know how to disable the beeping alarm at the end of a cycle. It continues to beep for hours on end until the door is opened. Does anyone know how to disable the alarm? Thanks,


... Dishwashers

When switched on the pumpbutton stays red and the program selection does not want to move, one program remains blinking green. When door is closed pump starts running non stop. Cannot find any reset button


Thanks to a manual that was sent to me I understould I had to press the button P for a long time, that resets the machine. Thanks for your service! Carolijn ... Candy DFI Plan Built-In Dishwasher

The soap dispenser cover for the main wash section has broken. I think that is why the dishes are not getting clean because the soap is washing away with the first rinse. I cannot find where to get a replacement part.


... KitchenAid 24 in. KUDK02CRBS Stainless Steel Built-in Dishwasher

I have a Karcher 395 and want to replace the broken inlet elbow, but I cannot figure out how to get the plastic valve assebly free from the cast metal cover to change it. Seems as thought the valve assembly is pressed into the housing. To force it out may damaage the whole assembly.-


Take a socket that is the same size as the black plastic and tap it down through the hole until it comes out. I have done several of these this way. ... Karcher 2500 PSI Pressure Washer

I have a model 665.1576 or 1676 my paperwork does not have the number on it and no part number on he machine, but I ordered parts from the catalog which matched. about 7 years old, stopped draining, so I changed the Seal kit, pump base seal, impeller, plus drain cover gasket but not the pump gasket could not find it, reinstalled, pump works but much slower and times out, have to hit drain button to get all water out. Keith


... Kenmore Dishwashers

The door won't close; the latch seems to be broken. Note: I cannot find the cost for your service, so I don't want a response until I know how much it costs. Thank you!


You will be charged around $6 to $8 for this service. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1223 seconds