Having problems with your Jenn-Air JDB6510 Built-in Dishwasher ?

The flapper that holds the soap in for the next cycle will not open automatically . I have to stop the dishwasher and manually open it. Any suggestions.


Answers :

Verify the bottom tray is allowing clearance for the door to open, a reveresed tray blocks opening...
Repair Help & Product Troubleshooting for Jenn-Air JDB6510 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The flapper that holds the soap in for the next cycle will not open automatically . I have to stop the dishwasher and manually open it. Any suggestions.


Verify the bottom tray is allowing clearance for the door to open, a reveresed tray blocks opening... ... Jenn-Air JDB6510 Built-in Dishwasher

Soap dispenser The soap dispenser door does not open automatically as it should... stays closed throughout the cycle unless we stop the cycle, open the dishwasher door and then open the soap dispenser door any suggestions? This is a Maytag DWU 9200.


A wax motor controls the opening of the lid. Also a seal that fits around the latch lever may be deteriorating and obstructing the function of the lever. Follow the link below for images and part numbers with cost.\015\012Item# 1405...$20.30 ... Maytag 24 in. DWU9202 Built-in Dishwasher

Kenmore elite dishwasher runs until it is manually shut off by opening the door? My Kenmore Elite runs continuously until I manually drain (cancel) the cycle. Then I have to rewash with no soap to simulate the rinse and again manually drain (cancel) the cycle. This was a $650 dishwasher. I am not sure how to reset the controller or even trouble shoot for an error code. Any suggestions?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Working on a Whirlpool dishwasher DU915PWSS0 - The soap dispenser won't open automatically. We have replace the wax motor and have installed a new control board. When you pull up on the draw bar manually the dispenser door opens perfectly. I don't have a schematic and I don't have the test sequence so I can't run the diagnostic test. It's a blind assy process so you can't really tell if you have the draw bar over the wax motor and coupled. I need the schematic and or test sequence for the E


Please confirm if this is the model you have.\015\012\015\012I might have some access to th ... Dishwashers

Lg Dishwasher Model #LDF6810WW will not stop runningafter thr 2hr. cycle is up additionally, it has recently stopped opening the soap dispenser. Any suggestions? Recently I also had an "LE" motor error which went away once I repaired/respliced 4 wires on the front of the door panel, which were frayed due to that hot tar substance they are placed in at the factory.


... LG LDF6810 Built-in Dishwasher

Ariston LI 670 S dishwasher. I put in a new circuit board and dishwasher only goes through first cycle of whatever setting I put it on. Soap door doesn't open and next cycle doesn't start. Any suggestions? -Alfredo [email protected]


... Ariston Technologies Dishwashers

Bosch SHU9910 Dishwasher won't stop and drain. Does seem to be getting the dishes clean; just won't end the cycle; after 2 1/2 hours of constant running; open the door and manually shut it off but, of course, there is still water in the bottom. Suggestions?


... Bosch 23 in. SHU9910 Built-in Dishwasher

I have a Jade RJDW2470A dishwasher which was re-branded Jade. (It is a Maytag product.) It get's stuck between cycles and will run forever unless I manually advance the dial to the next cycle. It seems to get stuck around the "rinse" cycle and the soap door does not open until after I advance it past that cycle.


... Jade RJDW2470A Free-standing Dishwasher

I have a gibson dishwasher, age unknown, that developed a problem with the soap dispenser. During the wash cycle the soap lid doesn't open until late and a gooey soap mess is left on the door. Any suggestions? the dispenser is always open when the dishwasher is finished however the detergent if liguid is a mess on the door and the closest dishes or if a block - still a block in the bottom of the dishwasher -


Run it a few times with a soap tablet in the cutlery basket. The door is just sticking and doing this normally cleans them up. ... GE Nautilus 24" Built-in Dishwasher

SOAP DISPEN DISHWASHER SOAP DISPEN NOT OPENING I bought a brand new LG dishwasher about 6 months ago. I've had a few problems with it. First, it gives off a smell when it operates. Secondly, more often than not, the soap dispenser does not open. I have read the manual and have tried putting a lot less soap but it still does not work. Should I try switching to liquid soap instead?


Is the machine heating ok?, if so then the dispenser and or the electronic control board is most likely faulty. \015\012if the machine is still in warranty call your lg service agent and when the tech is on site, reque ... Dishwashers

KUDS30IXBL My dishwasher stops mid cycle. Technician said it was too many suds and cutting off. I use cascade and jet dry and nothing else. There has been no other soap in the dishwasher. After it cuts off on normal (soap dispensed) I restart on light/china with no detergent. Sometimes it runs through with no problem and sometimes it stops with all lights off. Any suggestions? I have already had technician out twice for other problems with this dishwasher that is only 2 years old and don


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Westoint Dishwasher I have looked in the manual under troubleshooting tips, but didn't find anything on the problem. The dishwasher goes into cycle,but during the wash cycle it stops,makes alarm and the wash and rinse ligts come on. And now I can't even find the product on this site.Westpoint Dishwasher WQP12-9240. Thankyou My dishwasher is stopping at stage 2 of the programme after beeping once. Quite often the detergent flap doesn't open. Am at my wits end and threatening to leave home!!!! Th


Hi again,\015\012\015\012That should be OK. Just get in touch with your sales rep or his boss. Somebody there will be able to look up the record of the purchase. If they ask for model & serial numbers, you have them. You will find ... Dishwashers

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

I have a GE Potscrubber 1230 Dishwasher, and the soap cup will not open duing the cycle, so that the wash cycle will not complete, but runs indefinitely until I open it, open the soap cup manually, and then run the cycle again. Is this an easy fix?


There is a wax switch in the cup that has failed.Replacing the cup is your only fix.Reply with the model # and I can help you locate a replacement.Thanks!! ... Dishwashers

Bosch dishwasher SHU3032 UC/14. The soap dispenser does not open. In the past I've used dishwasher magic or similar to clean the dishwasher of hardwater deposits and that solved the problem. The cover opens and closes manually. The springs seem fine. I removed the door skin and the linkages look good. I checked the resistance on the Wax motor and it is with in spec, approximately 2150ohms. I 've watched the cycle and the wax motor never seems to actuate. I put my meter on th


... Bosch Dishwashers

Hi my Candy dishwasher model CDI 1012/2 is filling with water then after a few minutes if bleeps and the error code meaning according to the manual is "Longer inlet time. possible cause Faucets is not open" The tap is fully open and the dishwasher is now full of dirty water. Could you please suggest an alternative cause?


... Candy Dishwashers

I have a 1999 bosch SHU 4300 dishwasher given to me. It worked great for about two weeks. Now it takes for ever *3-4 hours* to complete a cycle (if it does). I have opened the door to see it filled with sudsy soap after this long. I have checked the hoses and they are not kinked. Once the cycle of cleaning is over, If I reset it manually, it will rinse the dishes and empty just fine. But I have to manually get the dishwasher to advance to the rinse and dry cycle every time now.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch 24 in. SHU43 Built-in Dishwasher

My dishwasher has stopped cleaning plates properly. It makes everything wet but at the end of the cycle the detergent block is half dissolved at the bottom. I have just run a cycle and opened the door during this. The bottom is full of soap suds and water and the top spray bar is dripping water after I open the door but when I close and then reopen a few secs later the top spray bar has definetly not rotated. The water is also not hot, this dishwasher is a cold fed only machine so I guess the el


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Zanussi 18 in. ZSF4123 Slim-Line Free-standing Dishwasher

We have a Bosch dishwasher supplied with softened water - does a great job. However, on the most recent run, the soap door didn't open properly and the soap puck (we use those two part liquid/powder that dissolve) was only partially dissolved. Our stainless steel cutlery now has a hazy film all over it, something that handwashing and a subsequent successfully-executed dishwasher run didn't remove. It's expensive cutlery, less than a year old, and a wedding gift from my mother who lives next d


Sounds like the you need to see if your using a proper rinses / drying aget like turbo dry. Fill it up and you should be good for 40 washes. If it continues you may have a bad control unit. ... Dishwashers

I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi


... Maytag Dishwashers

My kenmore 17349 dishwasher is not cleaning properly. The door for the soap opens but all the soap doesn't get dispensed. 50% remains after the end of the cycle. We haven't changed soap and it used to dispense properly. It suggested to me the middle washarm was not spinning. As near as I can tell it is spinning.


... Kenmore 17342 / 17349 Built-in Dishwasher

I have a 4yr old Smeg freestanding dishwasher. Model is DF612SDX. The problem is that a wash cycle will start but about 15 mins in it stops and 2 of the programme option lights (on the left hand side of the programme options), start flashing. If you open the machine the soap dispenser has failed to open. This problem has been a bit of a slow deterioration as we've had a number of washed that have managed to finish and then noticed that although the dispenser has opened it must have been to


... Smeg 24 in. DWF612SS Free-standing Dishwasher

I have a Rebadged Siemens dishwasher model no. SE6TIE1GB / 13 TKD 795 / 2. When turning on, the dishwasher makes the "normal" noise of washing but after less than a minute it stops and refuses to wash anything. Ive tried pressing the reset button but no help. Worth mentioning, the night prior to that, I switched on the dishwasher before sleeping and when waking up at 5am, it was still washing so I manually turned it off and opened the door to find some water at the bottom of the tray.


... Siemens Dishwashers

Kenmore Elite - 9 Year old Dishwasher - A circuit blew and the dishwasher stopped in mid-cycle and did not drain.... I reset the circuit breaker and "manually" took the water out of the dishwasher. When I push buttons to restart the "95" shows up for the normal cycle. However, when I push start the "95" becomes a "--". Suggestions???


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Hobart Dishwasher We have an old smaller built-in dishwasher at our church (Hobart model WM5H). It doesn't stop spraying water if you open the door to remove a rack of dishes to put the next rack in like it is supposed to. One member thought it may be the Electrical Timer Switch? Would this be a fairly easy repair?


I guess I didn't understand your statement of the problem. If you know that the washer has gone through an entire cycle, and it is time to take out the RINSED dishes, yet the washer turns on when you do this, play with the door interlock and the doo ... Hobart Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2604 seconds