Having problems with your Karcher ?

Putting the small spring back in the gun of my karcher K 3.98 power washer

Where does the small spring go inside the gun

Answers :

Repair Help & Product Troubleshooting for Karcher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Power washer I have a karcher power washer and it haves a 7.0 robin motor on it... When i start it up the motor just goes in to high speed... I looked to see if all the springs are on the arm and they are ....All i can think of that the governer on the motor is not kicking it back... If you could help that will be great....Thanks Jerry


... Karcher 2500 PSI Pressure Washer

Where does small spring fit in gun of karcher pressure washer kb4040


Most Karcher guns I have worked on have had a spring behind valve between hose pipe inside gun. ... Pressure Washers

Karcher power washer electric K3.97 gun has two springs can not find where one goes.


Have a look on karcher web site\015\012www.karcher.com\015\012click on europe \015\012then click in international\015\012go to service then spare parts ... Karcher K2.26 Electric Power Washer

Why will water not flow through hose into the spray gun with the washer not started as well I started the power washer and the water still does not come out.


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Remove the lower wash arm (1) by turning the nut (4) clockwise (right) lift the arm off, there is a bearing (3) (small thin plastic washer) under the arm, be sure not to loose it. Lift the tab on the back of the feed tube cap (2) and swing it to the right and lift up, this may need a bit of pressure to release it This is for my Whirlpool dishwasher DU1100XTP. I'm putting it back together and can't remember if the plastic washer goes on top or underneath the feed tube cap. Also how do I remo


This is not a tuff job plastic washer goes on top . and torx screws . you use a proper torx tip for the screw size . ( you can go to sears parts .com and put in model # and see a good break down of the wash arm s and t ... Dishwashers

I tried to repair my karcher spray gun. I have a small spring and a small white plastic piece which the spring fits onto to find a home for. I'm sure its to do with the trigger handle but I can't see where it fits. Can you help, a diagram would be helpful.


... Karcher Pressure Washer Gun 91120200 91120200

Where does the small spring fit in the handle of my karcher pressure washer


... Pressure Washers

Took gun assembly apart on Husky 1750 Power Washer. Spring fell out, where does it go? Looking for gun assembly schematic.


... Pressure Washers

Karcher K386M-I was using the washer and the pressure hose popped off the outlet of the unit. I put it back on and it popped out again. The second time I noticed the oring was gone. It was on there when I first put the hose on. Why does the pressre hose pop off.It was on tight?


... Pressure Washers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

Washer wasnt use in over a year when i started using it it work ok not to much power though and then it increased power and then starting blowing alot of black smoke from exhaust. when i tried to start it again after putting new gas it starting back firing and then would shut off.


... Karcher 2500 PSI Pressure Washer

How to re-assemble Simoniz S1900 Spray gun - Can you show me how to put the spray gun back together? I have 2 springs-don't know where they go??


... Pressure Washers

I bought a house with a Bosch dishwasher in it and soon found that the top spinner holes are blocked with bits of old labels. I have removed the spinner and separated the concentric tubes but I do not see how to push the debris back along to the inlet. Do I need a power but very small jet to put into the holes along the arm? Would drying it then putting the suction of a vacuum over the inlet hole be useful?


This is very common if the filters are not cleaned regulary if you remove the arms and soak them in hot soapy water for around half an hour this should loosen the debris also tap them on the side of the sink this will remove more stubborn debris ,ref ... Bosch Dishwashers

Karcher B302 gun leaking = taken gun apart but I can't find where the small spring goes! Can you help please ? Diagram would help!


Jeane_m\015\012I can e-mail you a diagram. Can you e-mail me?\015\[email protected] ... Karcher K2.26 Electric Power Washer

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

I have a frigidaire dishwasher 4000 series aqua surge with speed clean. The small spray arm on the ceiling of the washer came off. I found it sitting on top of some cups in the top basket. There is a loose part inside the retainer in the ceiling that moves back into the retainer when I try to put the spray arm back on. How do I fix this and how do I get the top basket out to work on it?


The top arm snaps into place. Simply unscrew the retaining clip from the ceiling of the washer. Inside of there, you will find a small white plastic clip. Make sure the two prongs are pointed down and poking out through the hole in the bottom of the ... Frigidaire PLD4555RFC Dishwasher

I have a weekender h1610 power washer i took the spray gun apart and cannot remember where this little spring goes


Email me pictures of the spring and the part that it came from and i will try to help u ,,, [email protected] ... Pressure Washers

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

Karcher B402 pressure washer Motor runs as soon as power supply connected, on/off switch does not seem to make a difference and no pressure at outlet? Was working fine, stopped for half an hour, came back and wouldn't work. Thanks Bob


Bob I had this happen to my Karcher, the pressure seals have blown. $Au200 for service and replacement from karcher dealer. tyhey would not sell the parts for a DFY ... Pressure Washers

How much oil do i have to put in the machine - Karcher K2.26 Electric Power Washer


You should never have to change the oil on this machine, if you did take it apart and the oil spilled out you would fill the oil back up to the middle of the wobble plate. The wobble plate looks like a large fender washer that has a groove cut in the ... Karcher K2.26 Electric Power Washer

A small spring came loose from electric pressure washer gun, where must it go


... Black & Decker Pressure Washers

HAVING LEFT MY KARCHER B602 OUT OVER WINTER ,IT STARTED BUT LEAKS FROM INSIDE THE CASEING. TOOK CASE OFF AND FOUND PLASTIC PIPE HAD COME OFF PUT THIS BACK ON STARTED MACHINE AND PIPE CAME STRAIGHT OFF. WATER WILL FILL SOAP BOTTLE IF PIPE IS HELD ON WITH WIRE, BUT STILL NOT MUCH PRESSURE FROM GUN. ACN YOU HELP WITH THIS PROBLEM.


... Karcher Pressure Washers

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

Power washer loses pressure. Engine runs fine. Taking the nozzel off, squeezing the trigger, and then putting the nozzel back on sometimes remedies the problem. How do I fix it? Thank you.


Your bypass valve is jamming. All you do is take it out, put a smear of o ring grease around the o rings then put back in, make sure you push it all the way in and should fix the problem. ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0961 seconds