Having problems with your Karcher 1550PSI Pressure Washer ?

My power washer looses pressure every few seconds, it seems almost to be panting, is there anything I can do to fix this problem.


Answers :

Repair Help & Product Troubleshooting for Karcher 1550PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My power washer looses pressure every few seconds, it seems almost to be panting, is there anything I can do to fix this problem.


... Karcher 1550PSI Pressure Washer

When i turn on my k499m pressure washer the motor seems very week and the pressure is non existant has anyone ever come across this problem before i havnt tried anything to fix it yet but the water is flowing into it ok it just seems as if their is something wrong with the motor or pump


I have come across this before, it can be that the motor has burned out and in that case it can be better to purchase a new machine. \015\012\015\012It could also be the capacitor which is not a very expensive item to replace. What the ca ... Karcher Pressure Washers

I have a Maytag MDB7600AWB dish washer. I have a door leak, dripping from the right side. I can not see anything that would allow it. It seems like it could be coming from the inside of the door. Also, there is heat and condensation on at the top of the door, above the leak. It could be that steam is coming from the top right and dripping down the door. Could you give me some idea about fixing the problem.


HI,Check for the following troubleshooting steps:Some leaking around-under-from the door on dishwashers can be traced back to a split in the spray arm. If the lower spray arm develops a split in it, the spray arm can turn too ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

I have a dishlex global 300 on which I removed the front cover a black wire came loose and I didn't know where it came from thanks to jyackle5 I have fixed that issue. The problem I have now is the eco light flashes and that's it (nothing else functions). I removed the front panel as the bottom door seal had blown and junk oosed behind the front panels I washed the junk out and cleaned the hole washer while I was at it the bottom of the washer (where the heating element is) over filled so I tipp


Easy fix, Use a bit of force and pull the dishwasher out.Get a few towels and tilt to the left. Water will drain out. Push back in. wait 10 mins and turn on.\015\012\015\012\015\012\015\012Regards ... Dishwashers

If while pressure washing I let off the wand trigger it looses pressure and I have to turn of the washer motor and wait for the pressure to return.(seems like some kind of vapor lock problem)When the pressure returns I hold the trigger and restart the washer. If I let off the trigger we go through the same process again. this is a g3050


Hi and welcome to FixYa, I am Kelly. \015\012 This is most often caused by the bypass / un-loader valve located on the high pressure output side of the pump. The valve will either have a stem type valve with a knurle ... Karcher 2500 PSI Pressure Washer

I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi


... Maytag Dishwashers

Dishwasher sounds like it is running normally, (no grinding sounds or anything)but there doesn't appear to be any water coming into the machine. we checked to see if there was a kink in the line or if perhaps it was a plumbing problem but that does not seem to be the case. I know the circular disk in the front of the machine needs to be down and it is, so can you figure out without seeing for yourself what could be the problem and if so is it worth fixing since I can probably replace it for und


Hi there,\012Well first of all you can check out the following -Water-inlet valve - The water-inlet valve lets water enter the machine. If this valve is defective, you need to completely replace it. It's usua ... Dishwashers

In our KitchenAid dishwasher, there is often a puddle of standing water in the bottom of the washer after the cycle has finished. It never seems to drain and I have to "bail" it out. Is there any easy fix for this problem?


Check the drain to make sure its not plugged with food (the most common problem). If the drain is good then check the hose to make sure its not plugged anywhere inbetween the dishwasher and drain under sink. If all those check out, chances are your ... Dishwashers

I had a draining problem, clogged line, fixed. Does the small in line rubber valve under the dishwasher in the transition piece to the hose have any real need to go back? and which direction it is cupped slightly. Also are there any assembly instructions? I cant seem to get it back quite right, or a white washer has split. not sure which.


... Whirlpool 24" Built-In Dishwasher - Black-on-Black

Hello, I have a Maytag Stainless Steel MDBH975AWS dish washer. After water fill, it is very noisy almost like a grinding sound. Is there a common problem? Is there an exploded parts view somewhere so I can disassemble the grinder portion to see if there is a loose part?


Impeller is jammed onto shaft ,remove motor with 1 bolt ,remove impeller by putting a plastic pen in bottom of motor turn impeller counterclockwise inspect for clearance or obstruction.either replace impeller or do like I did and put a spacer,poor de ... Maytag Dishwashers

DU915 undercunter diswasher. the spary tower became disattached from the nozzle cap cannot seem to get anything else apart to try to re-connect found no loose washers or nuts in the bottom of the diswasher


... Whirlpool 24 in. DU900PCD Built-in Dishwasher

Hi, I have a Dewalt pressure washer 3100 psi. I want to know why the pressure washer works okay for 1 hour then it stop working completely. the oil is fine, the spark plugs are okay, and when I tried to start it again it does not work. Can you please tell me what could be the problem? This pressure washer is almost brand new I have used it for only like 30 hours for 2 years that I have it. I used it couple times lately but same problem it works for 1 hour then it does not work any. I will


There are two common issues that will cause what you are describing. What you need to do is run the machine until it dies as you are describing. Then pull the spark plug and check for spark. If you do not have spark you have a failing stater. It is v ... Dewalt DPH3100 Gas Pressure Washer

Hi, I have a Miele G681 dish washer with an intake/drain light problem. I've read all posts about similar problems I could find both on this forum and others but I'm afraid I still can't figure my problem out. The intake/drain light starts blinking mid way into the dishwashing process. The dish washer fills up, rinses, drains, water is hot, everything seems to function just fine. Some time after the tablet drops from its door mounted container, and the time estimate reaches 46 minutes r


... Dishwashers

My glassware almost seems like it has breadcrumbs stuck to it. I have run several empty cycles but the problem persists. Is there a filter I am supposed to be cleaning or something? I can see in the leftover puddled water on the recessed exterior glass bottoms what almost looks like sand particles or breadcrumbs, although I know it's not. I had the same problem at my last house with a different brand of dishwasher. How do I get rid of this if it doesn't flush out the system, even on an empty cyc


The problem may be the hot water supply. if you run out of hot water quickly in your house, this may be related. you will need to flush out the water heater once or twice. good luck ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Hi i dont know the model of the dishwasher.. but the controls are fairly staright forward... a little knob for temperatur control and an on/off button.. and a light that lights up green when dishwasher is switched on... now the problem is as happened recently, when you switch the washer on greenlight is on and washer can be heard doing something but after a minuit or so the washer stops and the green light flashes. open up the dishwasher no sign of water or that it has done anything at all... th


It sounds like your washer is not getting enough water to start. If your washing machine is filling too slowly or not at all, then you probably have a clogged screen on the back of your washer. To check this: \015\012\015\012 ... Whirlpool Dishwashers

I have a Bosch dishwasher, stainless steel front- with buttons on the inside top( same as display, and the washing cycle won't start. Water seems to be running into the washer, as I can hear it, but the cycle never starts. Recently, I had clogged garbage disposer issue that has been resolved. The dish washer drains into the disposer, and I had free standing water left behind in the washer for 2days during this time.. Could this be the issue? Can you help me figure out this problem? Thanks!!


... Bosch 23 in. SHU 8805 Built-in Dishwasher

My LG dishwasher upper rack has stopped cleaning. The uppermost arm is seemingly getting no water at all and the arm on the underside of the upper rack is getting some water, but not enough to turn it. I have already disassembled and cleaned all the way down to the diverter assembly and it has not fixed the problem. I think this is a problem with a the (?) diverter pump or perhaps a sensor that sends water to the upper arms. I am trying to figure out how to further diagnose the problems. The


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... LG LDF6810 Built-in Dishwasher

My Dishlex global 300's rinse light is flashing after 5 mins use. About 2 inches of water stays at the bottom of the washer. Bought this second hand and it has not been used for a few months. Do I need to fill the reservoir under the washer or lean it at 45 degrees to dislodge anything in the sump. If you have had the problem of the washer starting its program and then stopping after 5 minutes and the rinse light flashing I would appreciate your advice. Cheers Hyph


The flashing rinse light is an error code. I am assuming that your control board is good because the lights are working. I'm also assuming that this model has two pumps. One for filling and one for draining. The rinse light flashing is probably i ... Dishwashers

Hello, I have a Craftsman Clean N Carry® 2150 psi Gas Pressure Washer w/4.0 hp Briggs and Stratton Engine. My problem is that I can't get any water to come out of the nozzel. What can I check to fix the problem? Also, where can I get a book to look at for parts and problems?


... Pressure Washers

I have a karcher 650m, when assemlbed the off on switch wont work, when dismantled the switch seems to work, tried greasing the switch, anybody know how to fix this problem??


... Pressure Washers

Our Maytag dishwasher arms in the middle and bottom of the washer won't spin during wash cycle? What do we do to fix this problem? The washer has been stored for 1 year. Thank you.


Does it sound like the motor is runnig??? just no water circulating??? if so sounds like a bad impeller/ seal kit. ... Dishwashers

Hello all, We have an Ikea Whirlpool DWF 416 that is a couple of years old and has never caused any problems. From today the door has stopped shutting properly. The electronics and internal mechanisms seem to be working fine, since when you turn it on the cycle starts - but only if you hold the door shut. Has maybe a catch gone? Any ideas for fixing a door-shutting problem like this? Thanks in advance! Dave


The catch is no longer working. Contact IKEA for the replacement part. I'm sure it's available through EBAY or something, but probably not guaranteed or as reliable. ... Dishwashers

Hello, My Kenmore elite dishwasher model 665.17282.400 seems to have a problem. The CLEAN light is flashing and can't do anything else with it. Do you know what thew problem is, or how to reset it. I tried cotting off the power to the unit but to no avail. Please help ASAP


Try pressing the heated wash then heated dry one after the other about 5 times. this should reset the unit.\015\012\015\012\015\012--------\015\012in some machines there is "Hi temp scrub " and "air dry" so press this ... Kenmore 24 in. 17282 Built-in Dishwasher

I own a build-in LG Stainless Dishwasher (modle: LDF1178ST). It stopped draining water during its recent startup due to its idle (no operation) for about a year:). I can only feel the hose full of water by touching the drain hose between the washer and the sink desposal. It's hard to check other part of dish washer since it's built in our cabinet. Could any dishwasher expert help to advise how to trouble shoot or fix this problem. Thanks, Alex Chen 571-220-7484


There is a float in the bottom of the dishwasher that tell the motor to turn on and pump out the water. I would check the float first to see if it is hung up and not raising to tell the dishwasher that there is water in the base. Check the check valv ... LG Dishwashers

Intermitttent beeping on bottom drawer of dish washer no error code only cycle to work all the way through is rinse cycle. Have turned off power supply over night did not fix problem. When you press pause button restarts for about five minutes then beeps again. No problem with top drawer. All inside cleaned using correct powder and rinse aid.


Panel control board Call Encompass Parts 1-800-638-3328 ... Fisher Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1526 seconds