Having problems with your Karcher 1750 psi Electric Pressure Washer ?

Gun constantly stays on

\015 Pressure gun constantly stays on when washer is switched on.\015

Answers :

Repair Help & Product Troubleshooting for Karcher 1750 psi Electric Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Gun constantly stays on


... Karcher 1750 psi Electric Pressure Washer

Should the oil in the pump be milky you have to surge the trigger on the gun to get pressure then it stays until let off the gun then no pressure and repeat?


Milky appearance means water is in the pump oil.......sounds like your spill valve is sticking and needs maintenance ... Karcher 2500 PSI Pressure Washer

Have a Karcher kb4040 that continues to run constantly even when the trigger isnt pressed. Also water flows out of the detergant hose when im not pressing the trigger. Pressure seems down slighlty, not much. This happened after i ran water out of trigger gun with no lance attached, machine switched on. Seems to leak from trigger handle aswell. Many thanks in advance


This is two things. One is the back flow check valve to the soap line is leaking. The other is the pressure switch on the output side of the pump. ... Pressure Washers

Hello there.My Karcher pressure washer motor constantly runs with no pressure coming out of trigger gun.I have tried another gun with the same result.The motor should stop/start when you press gun.The model is a 350M plus VPS. Could you please help.thanks


The valve that admits more water to be compressed is stuck. It is likely the O-Rings on it need replacing. No water to the pump, no pressure!\015\012\015\012The motor will stop when pressure is up to the designed pressure. ... Karcher Pressure Washers

Complete lack of pressure and motor is staying on constantly.


... Pressure Washers

Whirlpool adg 7540 fills,washes, drains then stays draining, rinse light constant and programme selection light flashes and beeps


Replace electronic control. ... Whirlpool Dishwashers

Hi. I have a Siemens SE65E331GB Built in Dishwasher with an aquastop system. The problem is that it seems to be stuck at the end of a cycle. The pump is constantly running when stitched on. I won't top after a reset and it continues to run even if you open the door. The water supply light also comes on indicating that there is no water getting to the machine. I have tried resetting the aquastop as per the advice in other threads. This has helped in that the water supply light now stays


... Siemens Dishwashers

We have a model 4001 glass washer that won't stay constant with the heat Eric


Could be that the wash sprays are not going straight up or down to be recycled back into the wash tank. Thereby asking for more water to enter the tank from your supply which might not be hot enough at times. If the wash spray is not straight up or d ... Moyer Diebel 48 in. SW400 Dishwasher

I have an LSv66 Ariston dishwasher. When it is switched on, no matter what program, the knob just stays in the same position. It sounds as if the dump pump is running constantly.


The dishwasher overflow detection may have triggered. This causes the drain pump to operate.\015\012\015\012The overflow float is located at the base of the diswasher and maybe faulty. It is spring loaded float and should move down and up ... Ariston Technologies LL64WNA Built-in Dishwasher

How to fix/grease an unloader valve on yorur pressure washer .I pull my trigger on my pressure washer gun and it clicks with water stream coming out then goes to high pressure.this is a kacher reman unit.I was wondering if this is normal or does it constantly hold high pressure


... Karcher 2500 PSI Pressure Washer

Problem burner has problrms, it goes on but then goes off it does not stay on constant, what could it be the problem.


... Northstar Wet Steam & Hot Water Pressure Washer with Honda Engine 3000 Psi, 4 Gpm

When gun trigger is released the pump stays loaded and will not recirculate the water


You need to locate the bypass valve and lube it ... Northstar Pressure Washers

My Hotpoint BC1450 slimline dishwasher stays constantly on the 'Drain' cycle. Doesn't matter if I turn it off on the unit or at the socket. It has full salt and full rinse aid. Any suggestions antone? Thanks, James


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

I have the Bosch EcoSense dishwasher SHX6AP05UC 02. The lower flip tine rack will not stay up. The clips are in place, but it is really loose


... Bosch Dishwashers

DS-603 lights keep blinking, won't stay turned on.


Hi. I am unable to help you fix your problem, however I have just had this problem with my dishwasher exactly the same model. I was wondering if you have fixed this problem yet and if you have how. ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Lights on pots and pans blink constantly


Try disconnecting power for a bit. try the cord under the sink. if its hard wired (no cord) you can try the breaker.may reset itself.otherwise, you have a logic board issue.consult the manual first for explanation of blinking lights ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My dishwasher will not start the heated dry light flashes constantly


... Whirlpool 24 in. DP940PWP Free-standing Dishwasher

First green light on constant on indesit d167 but nothing happening


... Indesit 24 in. DI67 Free-standing Dishwasher

Motor runs constantly with low pressure.


What you described I would think that it a switch problem, I would go to Karcher.com and order an original part for this and start over with the electrical portion and then go from there. ... Karcher K2.26 Electric Power Washer

Pumps constantly, even when trying to fill. Won't shut off


... Kenmore 18" Built-In Dishwasher 1440

I have the kitchenaid dishwasher model #kudv03ctss0.the clean light stay blinking and when i hit the start it just blinks and then stops but the clean light stay blinking constantly.if i hit the cancel button i hear a um noise as if it going to turn on but nothing happens and the light stays blinking. what do you think might be the issue .


Dear friend,\015\012ngfam at you service! happy to assist!\015\012It's an electronic problem!The lights are called codes and need to be diagnoed by a factory service person!!We sell appliances for 65 years an ... Dishwashers

Trigger gun I just install a new hose for my Karcher 330?Hose is working, but the trigger gun is lose, no turn off went is released, the equipment is always on ?..did I missing a part inside the gun ?..


It sounds like you left out the spring in the hose.There are about 10 different models of K330 with several types of guns. Go here and search until you find ... Karcher K2.26 Electric Power Washer

My Karcher K730 MXS pressure washer was leaking water out of the rear of the gun handle. I bought a replacement hand gun and the new gun is doing exactly the same!


... Karcher Pressure Washers

My Karcher 411A seems to have lost pressure. Behaviour is this, when you press the water release on the spray gun you get 100% pressure for like 10 seconds and then it seems to dwindle down to 30-40% of its total pressure. When the pressure cuts down I can hear more noise coming from the gun sprayer aswell. So not sure if the problem is in the gun or the main pump unit ?


Sounds more like a clog on the intake side. Check the filter and the hose on that side. ... Pressure Washers

Kenmore Ultra wash III will no longer stay connected to faucet after filling...what part should I replace the hose or the faucet adaptor? When we turn the faucet on to start up the dishwasher it falls off...when we finally get it to stay connected with water on...it will fill but then falls off again...get it to stay on, it empties, but then after it has completed filling up again it disconnects from the faucet.


If your adapter that hooks up to the faucet has 4 little white plastic jaws inside it then it can be rebuilt. there is a kit that replaces those 4 jaws, the spring, the attaching clip and the internal seal.. usually runs around 10 buks or so. if i wa ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0400 seconds