Having problems with your Karcher 2500 PSI Pressure Washer ?

2001 saturn l200 crankshaft position

\015 I have the 2.2 liter motor in a 2001 l200 sedanand and am replacing the timing chain myself. on alldata.com they saidbefore i pull off the crank shaft pulley i need to put it at 60 degreesbtdc before pulling it off. they do not mention how to get it there orhow to come up with a plan on getting it there. any ideas on how tomanually set this?p.s. the cartoon on the website has one of the webs of the crankshaft pullley strait up and down that is all i can make out. \015

Answers :

Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2001 saturn l200 crankshaft position


... Karcher 2500 PSI Pressure Washer

I have an LG dishwasher lds5811ww -- for about 1.5 years. Purchased it at Best Buy. The soap dispenser is not emptying completely anymore. The upper rack is in its uppermost position. I suspect that the top two spray bars are not turning around because they have not changed positions when I suddenly open the dishwasher while in operation. The spray nozzles do not appear clogged. Any suggestions?


If your dishwasher is cleaning poorly, check these:\015\012\015\012Water-inlet valve\015\012Internal filters\015\012Drain valve\015\012Spray arms\015\012Water temperature\015\012Detergent cup\015\012Water-inlet valve Most cleaning problems are ... LG Dishwashers

Zanussi ZSF 6126. With door shut and knob turned to position A (or any position) only the WASH LED comes on. DRY and END are extinguished. No water enters machine. Supply is OK. Filters are clean. Any clues please?


... Zanussi Dishwashers

Are the top rack adjusters on the Whirlpool GU2400XTP dishwasher an owner-serviceable item? Do most Whirlpool parts stores sell the top rack adjusters for the Adjustable 2-position top rack? My dishwasher is five years old and one of the adjusters has broken. The two-position rack seems like a good idea but the plastic part doesn't look like it was built for high-temperature durability.


... Whirlpool GU2400XTP Built-in Dishwasher

I have a Frigidaire Ultra Quiet III dishwasher that seems to get stuck at about the 7:00 position on the cycle. I can push it forward beyond this stuck position, but see that others have had a similar problem. any solution?


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Several people have posted this problem with the Frigidaire Ultra Quiet 111, but I have seen no solutions. When it is set to wash without extra heat, it cycles normally. But when the extra-heat wash and extra-heat rinse are selected, then it gets stuck first mid-wash at the 7 o'clock position, and if it is manually advanced then it gets stuck again during the rinse cycle just before the 9 o'clock drying position. Both the wash and rinse thermostats have been replaced without solving the problem.


Hi,\015\012\015\012I know that you are going to think that this is dumb... but the only thing that it can really be is the timer....\015\012\015\012 ... Frigidaire 25 in. FDP750RC Free-standing Dishwasher

I recently had the e4 error code on my new world dw60 dishwasher. I have since opened it up and replaced the heater element, which appears to have resolved that issue. However, in the process of doing this I incorrectly installed the flood switch back into place, meaning that it was in its closed position (i.e. the position it would be when activated by a flooded base) when I went to turn the dishwasher back on. I have since opened it back up and correctly installed the flood switch, but I ca


... Stoves 27 in. DW60 Built-in Dishwasher

Kenmore dishwasher type 573-D, model 665.16034402. Items on top rack don't get washed. Items on bottom rack are washed fine. Appears top sprayer and maybe middle sprayer aren't getting water. At rear of washer, top rubber flapper valve (which feeds middle sprayer when top rack is in raised position) is stuck open, bottom flapper valve looks OK. We use top rack in raised position so this doesn't seem to be the problem.


... Kenmore Dishwashers

Pressure washer has been sitting up for about 2 years.. worked perfectly before I parked it.. lol.. But, I put a new spark plug on, cleaned the filter, sprayed carb cleaner in it drained the gas tank and added new gas.. But it still does the same thing.. It starts in the choke position, runs awhile, and then shuts off. While its running, I tried to put the switch in the run position and it kills. Just wanted to see what an expert would say about the matter before I Brake it down. thanks


... Briggs and Stratton 020275 Elite Series 3400 PSI Portable Gas Pressure Washer

No water entering the dishwater. water supply is hooked up and water supply valve is in the open position. Could this be a water pump problem or is there a cut off valve entering the back of the washer that could be in the closed position?


No cut off on washer check float switch make sure its free check water valve make sure wires are on it and water getting to it ... Kenmore Dishwashers

Drain pump runs non-stop. Continues when dial is in Stop position. When disconnected for hours, drain pump starts immediately when power restored. In any wash cycle position, drain pump runs and cycle never commences. Small amount of residual water in drain line when impeller cover removed. Board? Switch?


Sounds like the flood switch has activated.\015\012\015\012You will have to drag the dishwasher out from under the counter after turning off the power to it. Tilt to one side so that any water collected under it is expelled. This will fre ... Miele 23 in. Novotronic G841 Built-In Dishwasher

On my 6 hp dewalt pressure washer, the unit runs really rough in the off choke position, when i move it a little bit away from the off choke position, it runs really close to the way it should. any recomendations?


Clean all the fuel system:lines,carb,etc.. also a new coil will be better. ... Dewalt 3700 Pressure Washer

The door latch is stuck in the closed position how can I reset the door latch to where it is in the open position?


... Jenn-Air 24 in. JDB1080AW Built-in Dishwasher

Our Amana ADB1500AWW dishwasher leaks at far left and far right edges ( at bottom points) of the inside door panel due to a design flaw. ie - In the fully open position ( door in horizontal position) the far left and far right edges (at bottom) of inside plastic door panel are stressed beyond what the plastic can withstand consequently the edges of the panel crack as far as 3 inches from edge to inside. This crack is very small and cannot be seen until the panel is removed and then full insp


... Amana 24 in. ADB1500AW Built-in Dishwasher

Kitchenaid dishwasher door does not stay up in the open position.


On each side of the dishwasher, near the ground, is a nylon cord and pulley apparatus that keeps the door from flopping down when opened. It probably needs some adjustment of the tension on the cord. ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Help removing a stuck crankshaft on a Honda GC160


... Karcher 2500 PSI Pressure Washer

Door latch in closed position


Put two small screwdrivers in each side of the latch and lever upwards (best way) or otherwise take the door outer panel and fascia off so you can get at themto stop it reoccuring, bend u catch on cabinet slightly downwards ... AEG 18 in. Favorit 54750Vi Slim-Line Built-in Dishwasher

Door Open but latch in closed position - HELP!


You need to operate the door release handle at the same time as applying pressure to the latch you can see just inside the door (imagine which way it would move if the thing was working as designed), the tech has possibly simulated a door closed posi ... Neff 24 in. S5456 Built-in Dishwasher

Does not start when control dial is positioned to on


... Dishwashers

Kitchenaid dishwasher model# KUDC10IXWH7. Door latch on door is stuck in closed position . door willnot shut


... KitchenAid Dishwashers

Our Bosch SHY66C05 door latch is stuck in locked position


You have to pull back the spring or replace the lock. the repair is pretty easy.let me know what happen. ... Bosch 24 in. SHY66C05 Stainless Steel Built-in Dishwasher

Top Draw locked in out position?


Sounds like the lid activators havent released. could be the lid activators are faulty or your lid activator control board is faulty.is it a single or double draw? please reply if u need more help to fix the problem ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Opened door during cycle, latch now stuck in closed position, can't re-close


Twist a paperclip around some pliers so you have a circle opening. then hook the paperclip around the latch and pull outward with the pliers. once the latch is facing outwards the door should close again ... Bosch Evolution 500 SHE45M06UC Built-in Dishwasher

Bosch 2006 SHU43E door will not lift from horizontal position to close"


The bosch is only on a hinge there is either something in the slot for it to retract into or one of the hinges is bent and won't let it up. there are springs on the sides of the dishwasher but you have to pull the unit out to get to them to make sure ... Dishwashers

Lid on top drawer is in the down position and drawer will not ope


You have a bad pair of Lid actuator for the top Part 528112 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0135 seconds