Having problems with your Karcher 2500 PSI Pressure Washer ?

Water leaks out at water pump and i just replaced the o-ring

\015 I have a 020200 troy-bilt pressure washer and i just replaced the o-ring on the water pump and when i re-tightened the adjuster net on the screen I'm wondering if i tightened it too tight because my pump is leaking water\015

Answers :

You may have cut o ring when you replaced. coat with vaseline next time before assembly.
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water leaks out at water pump and i just replaced the o-ring


You may have cut o ring when you replaced. coat with vaseline next time before assembly. ... Karcher 2500 PSI Pressure Washer

The dishwasher is leaking at the connection where the water comes in at the bottom. There is a brass elbow, and the leak appears to be where the brass elbow connects to the plastic water intake...It has a fine screen and an o-ring. I have replaced the o-ring and it is still leaking What next


We seem to be seeing more of these types of leaks form the elbows , The washers are splitting . If you have run into this problem Please email us @ [email protected] We need to have the manufacturer made aware of this problem . To many hardwood ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Karcher k3.68m leaks from the pump area. If I turn it on without holding the trigger down on the wand it will not blow pressurized water. If the motor is idle and the water is turned on then it leaks a lot from the pump area. What part should I replace?


... Karcher PSI Electric Pressure Washer

I have a water leak on my smeg di612ca - i have replaced the drain pump with a new one as i thought this was the culprit but it still appears to be leaking water from the inlet of the drain pump into the base - any ideas? many thanks


... Smeg Dishwashers

Magic Chef DU55CA-01 unit runs but when pump kicks on for discharge cyle water leaks on the floor from the what appears to be the solenoid part. The leaking stops as soon as the pump turns off. What part needs to be replaced? The unit was in storage for some time would this just be an issue with it sitting for some time? What is the best way to determine the real cause of the leak?


Leaking from drain valve shaft seal. If you just replace the seal it may still leak. Replacing the pump is a lot of work and not really worth it to cure a small leak. ... Magic Chef 24 in. DU6550 Built-in Dishwasher

Whirlpool dishwasher leaking from bottom of door between inner and outer door. Replaced door gasket. float and float switch working. Pump working, tub draining properly. leaks without adding soap or dishes too. Will a bad pump gasket cause water to get between inner and outer door?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Had the Northstar 3000 psi Pressure Washer for 2 months and it started leaking oil from the pump during use. Took it to Northern and they are replacing the pump under warranty but said it was likely because I was using quick connects on my garden hose coupling and that was restricting the water flow making the pump overheat. They said never to use quick connects on the garden hose unless the opening is at least 5/8". Does anyone make such a quick connect? I hate having to screw the garden hose o


It is easy to check if your hose and quick connects are supplying enough water to the pump. Your pressure washer gallon per minuite requirements are printed on the machine and also on the pressure tips in GPM. Your post indicates 2.5 gpm but check yo ... Northstar Pressure Washer 3000 PSI

Leaking Hoover D821 dishwasher when pumping in fresh water. Panels have been removed. Leaking from plastic container on side of unit. What is this and how is it replaced?


... Dishwashers

XR2750...PROB=NO OUTPUT REMOVED BRASS PUMP FRM. ENG. PISTONS WORKING OK FOUND "O" RING IN CENTER OF PISTON ARRAY SPLIT-REPLACED NO CLOGS THAT I CAN SEE EXCEPT IN CENTER OF "O" RING IS THAT THE ONLY INPUT OF WATER TO PISTONS?


... Honda Maxus Prosumer MX5223 Pressure Washer

Dishwasher leaking. I was supplied a flat seal ring of about 100mm dia., 10mm wide & 1 mm thick for the machine when I bought the house. Water on the floor tells me something underneath is leaking for the first time. The machine is about 10 yr old and in very good order .This seal could be the problem so before I go getting service personel in I'd like to know if replacing this and the door seal are jobs a careful handyman can do ?


I would say you could do it with out a tech.More then likely you can find information on the web on how to do it step by step or hey use this site more then likely one of us has had the same problem. ... Dishwashers

I just finished a service call for my 5312UC/UC12. The tecnician says he saw water leaking under neath the machine but hoses were secure and no visible crack to the motor housing, The machines pump works but very little water is actually put into the tub, hence no dishwashing. This technician says that this is a repair that most technicians avoid because it takes a long time and costs alot and violated some sort of warranty. He recommend replacement after only 7 years!


This leekage may come from thermostads water isolation ring, just under rezistance leads. There must be a ceramic holder to fix it to rezistance. İf it is broken, thermostad may go down, or rezistance leads isolation (lastic washer) may leak wat ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

Unit is leaking. Just bought it used, runs fine but leaks water out the bottom of the motor. Can this be repaired ? Is there a gasket or o-ring or something to replace ?


It might be the pcv(positive crankcase ventilation) valve. Go to a parts store and ask for a new valve($5-$10) and also ask where it is. It's usually right on top in the back of the engine where you described. If the hose is all cracked then yo ... McCulloch FHH18A Electric Pressure Washer

Tub leaks, with a partially filled tub (2.5 inches measured from the lowest point over the pump assembly.) Promblem occured after the washer was idle for 3 weeks. Have just replaced the main water inlet valve. The fill tube is not the source of the leak, the top arm feed is fine also.


I am assuming leaking when it is running, not sitting idle. Leaking from the door? Fill and run unit for 1 minute with no detergent. Open door. Are suds present? Suds turn into water when they drop to the floor. Suds can flow over the lip of the tub ... Maytag MDB7100AWB Dishwasher

I have a 1750 huskey electric washer gun leaks when pressure water is on can i replace o rings


... Pressure Washers

Water leaks from underneath the unit. Water only leaks when the pump cuts on (pressurizes). It leaks down on to the hose connecting to the water inlet valve on the right hand side of the unit when looking at the door of the unit. When the unit is full of water and the motor / pump is not running the unit does not leak. This unit is a Maytag jetclean dishwasher Model DWU9200BAB about 12 years old


Please change the 'o'rings of drain line and the inlet and also check the drain hose and the inlet if there are any holes in it ... Dishwashers

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Repair manual Water Pump seal is leaking bad and needs to be replaced. I don't have a manual of this part so that I can order the parts I need.


... Blakeslee D-8 Dishwasher

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

MAYTAG MODEL # MDB6000AWB LEAKS WERE WATER INJECTOR CONNECTS TO THE TUB. WILL REPLACING SEAL RING SOLVE THE PROBLEM


... Maytag Dishwasher

Replacing part #190634gs water outlet cannot get it to stop leaking o ring looks new outlet is new


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

Leaking underneath pump is the main tub seal bad? I replaced the drain tube o-ring and that wasnt it.


It sounds like the shaft seal is bad. depending on if it is a tall tub or a standard tub. they are different set ups ... Whirlpool Dishwashers

Vulcan Dishlex Executive 14-10 Dishwasher leaking onto floor from right hand side when it was filling at start of cycle. Husband has checked the following: both pumps (main and waste) hoses, solenoid switch (inlet). Where can we find the float/level valve? Could this be the problem? What else to check? This is the second time it's happened - I don't use it that much. The previous time my husband replaced the inlet and outlet hoses. What is the proper level for water fill - never above the


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Dishwashers

I replaced the leaking wash pump and now the diswasher will not enter the wash cycle. It fills with water and then the CHINA light starts blinking. Ideas?


... GE Profile PDW8060GSS Built-in Dishwasher

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1505 seconds