Having problems with your Karcher 2500 PSI Pressure Washer ?

How do I clean the unloader valve on a Karchner model G2600VH Cannot get steady pressure from the outlet of the nozzel have clean filter checked for leaks and replaced all nozzels still having issue with flux in pressure.


Answers :

Check the tips and Videos at http://www.ereplacementparts.com/karcher-2600-11944040-pressure-washer-parts-c-33388_33389_34001.html
I am waiting for the mfg to provide me details on how to clean the unloader valve at this time.
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I clean the unloader valve on a Karchner model G2600VH Cannot get steady pressure from the outlet of the nozzel have clean filter checked for leaks and replaced all nozzels still having issue with flux in pressure.


Check the tips and Videos at http://www.ereplacementparts.com/karcher-2600-11944040-pressure-washer-parts-c-33388_33389_34001.html ... Karcher 2500 PSI Pressure Washer

Model- kudm25shwh1 leaking under door when draining. I have replaced the gasket-for the tub, door seal, tub spacer. checked the top vent (cleaned the gunk out). checked the screws on the main sprayer. unit is 9 yrs old. is it time to replace?


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Low oil pressure while car is in idle..check gauge light comes on. I had the oil pump replaced and the sludge cleaned up. The check guage light still comes on when car is in idle and epecially when the car is hot.


Sounds like your oil pump replacement was left too late.sounds like a worn engine due to oil starvation with the previous low oil pressure and sludge problem.to verify the oil pressure you need to fit an oil pressure guage. to ... Mi T M Pump Oil

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

Hello, I have a Craftsman Clean N Carry® 2150 psi Gas Pressure Washer w/4.0 hp Briggs and Stratton Engine. My problem is that I can't get any water to come out of the nozzel. What can I check to fix the problem? Also, where can I get a book to look at for parts and problems?


... Pressure Washers

My karcher K2.98 pressure washer does not build up pressure. I checked hose and inlets and cleaned filter. Motor running fine, but no pressure.


... Karcher Pressure Washers

I have a Karcher K3.48M electric pressure washer which used to shut off when you weren't using the cleaning wand. This no longer happens and there is alot of water running out of the bottom of the unit. (This didn't used ot be the case) I expect a leak somewhere inside the unit, but I'm wondering even more if there is a pressure switch which has failed that cased the leak. In other words, if I find and repair the leak and there is a failed pressure switch, it will likely only break again. I can'


Hi you will have a 8 digit number on a silver plate on the machine with a number like 1.141-470.0\015\012Then go to www.karcher.com then on the left click on Europe, then you ... Karcher PSI Electric Pressure Washer

On 2/18/09, I had a part replaced (due to a recent recall issue) on our Bosch dishwasher, SHU43C06UC. I had not had any problems with my dishwasher - ever - and, since the replacement, my dishes are not being properly cleaned. The Sears repairman who replaced the part tells me that the part he replaced has nothing to do with my present issue and, because my DW is no longer under warranty, I would have to pay for any further services he may provide. 1) What do I need to do to troubleshoot this di


Http://www.boschappliances.com/safetyrecall/dishwasher/default.aspx?pid=BCH0905OIQ001 ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a karcher 4.6 pressure washer that developed the usual fault.... drop in pressure and leaking from the cylinder head. I have replaced the cylinder head and the attached control chamber. The pressure is now good again and the leak is fixed. Unfortunately now when the trigger on the lance is released the the machine does not switch off automatically. I have bled the machine by letting water run through it


... Karcher Pressure Washers

Troy Bilt pressure washer model 020209 will not build pressure-have checked all screens and intake in pressure hose and garden hose from house to pump. water leaks at gun handle- took it apart and oiled piston- was ''grabby'' but now snappy but still leaks. Engine starts fine and runs fine. Please help.


A leaking gun will kill all the pressure. You may need to repair or replace the gun ... Briggs & Stratton Pressure Washers

I have two DeVilbiss issues: First, on my pressure washer, I no longer get pressure on "high" mode from the hose. I prime the pump but it doesn't seem to be creating enough force for a high pressure. Second, on my generator, the gas from the gas tank leaks out. The tank is plastic or poly and don't know if it's a gasket issue.


... DeVilbiss Pressure Washer Hose 3600 Psi 25'

Wgvb2122 pressure washer builds pressure until you pull trigger, then no pressure. Replaced seal kit on plungers, same thing! Replaced unloaded assembly, same thing! Every thing seems to be as it should be and clean. Any ideas before I shoot this machine?


... Pressure Washers

I have a Karcher 550M pressure washer and was using today when all of a sudden the water started to pour through the handle hence lost the pressure of the water. Is this a rubber washer issue or the gun needs replacing or simpler than that. To be honest although I have had the washer for about 3/4 years now It is hardly used. Also can I fix it and where would I purchase the allen key to replace. Thanks Brian


... Karcher Pressure Washer Gun 91120200 91120200

Asko dishwasher- about 1 year old. Dishes are clean but very wet at the end of cycle. The bottom tub is filled with water (looks clean and warm). The dishwasher is leaking and water on tile kitchen floor. I checked for a float device inside and do not see one. What do you think problem is? How can I check hoses to see if clogged- do I need to pull washer out? Is that hard?


... Asko 24 in. 1895 Built-in Dishwasher

Replaced cylinder head due to loss of pressure and leaking. Pressure now back to normal and no leaks but machine does not switch off automatically when lance trigger released...


You may have a faulty unloader valve first remove the fitting the you attach you high pressure hose to inside inspect the checkvalve it may be stuck in the open position free it up reinstall and try again .try not to leave pump over pressurized for m ... Karcher Pressure Washers

Our Kitchen Air KUDIo1Ilbl6 DW is 6 years old. The dishes are no longer getting clean. It sounds different in the washer. I question the pressure is high enough inside the unit. I ran vinegar through the unit, did not seem to matter. The temp is 140 the pressure from our well is the smae as when we installed about 55 psi. I checked te screen it seems to be clean. Any thoughts


Hi\015\012\015\012If you are observing that the dishes are not clean, then you'll need to follow certain steps to be sure where exactly the issue. First thing to check for is the detergent cup and spray arms. Check if the dishwasher's sp ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

What does a failed pressure switch look like? I have removed my pressure switch (part 8071024). It is clean without apparent damage. The point at which the small, black hose connects has a plastic "button" inside, which appears as if it should move but it does not move at all. Is it seized? I think my issue is very similar to issue "Dishwasher Flooding Out" article on your site from (Oct 2007). This is a very helpful site, and thank you for any input on this question.


... Asko 1385 Dishwasher

We are having a problem with our LG Dishwasher. The machine is washing for about half an hour and then will stop and report an E1 error. According to the user manual this means "Water leakage in Hose connection" or "Water is leaked by damages". We have checked the diswasher's water connections and can't see any water leaking out. We have also cleaned the filers and checked the spray arms but that has not made any diffrence. Any suggestions what this error means and what we can try to resolve it


... Whirlpool 24 in. DU940QWD Built-in Dishwasher

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

Unable to start gas engine on a NorthStar pressure washer


Disassemble and clean the carb. If it ran briefly with the starer fluid then gasoline is not coming through the carb. ... Northstar Pressure Washers

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Whirlpool Gold Dishwasher - GU2700XTSB The top rack of the dishwasher is not cleaning. The bottom rack dishes clean fine. There are no clogs in either the bottom or top spinner arms, the plastic tube feeding water from the bottom pump to the top rack spinner arm is clean, the spinner arms all rotate freely and do not bind. Water pressure is correct and water temperature is correct. There are no lime or hardwater deposits or clogs. What could be the issue?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

I have a Whirlpool DU9000XR-9 dishwasher that was leaking. No leaks were coming from the bottom of the tub or any connections, etc. I replaced the door seal where it closes on the tub. There is still a leak on the bottom of the door. Can you point me to a possible issue(s).


... Whirlpool Dishwashers

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks.


There are screws on the inside of the door on a lot of those\015\012try to tighten them down a little sometimes that can cause a leak. ... LG 24 in. LD-12BW5 Free-standing Dishwasher

Maytag MDB 4000 AWB. Not cleaning. not getting water now. pressure was low when i was getting water. . Soap dispenser would not open as well. I replaced the motor on the soap door. cleaned the float switch. Tested continuity and cleaned out water inlet valve. Still not getting any water


... Maytag Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1677 seconds