Having problems with your Karcher 2500 PSI Pressure Washer ?

Borrowing this washer will not **** up the cleaner

\015 Wondering how to get it to syphon the cleaner. Is there a putton or nob?? Can't see one. or what is the secret?\015

Answers :

On some models make sure u twist the filter to the max
It should have come with several different nozzles. The siphon will only work with the low pressure one. It is usually black, and will have a larger opening compared with the others. Use this one to apply whatever you are siphoning, then switch back to one of the others to rinse.

Hope this helps.

Mike
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Borrowing this washer will not **** up the cleaner


On some models make sure u twist the filter to the max ... Karcher 2500 PSI Pressure Washer

I have a Karcher Electric K3.68 MR Reconditioned pressure washer that I've had for about two years and used about three times. The model number on the tag is: 9.559-635.0 and the Serial number is 000863. The washer pulses when I'm not sqeezing the trigger, It no longer will dispense cleaner when I turn the washer head to that position and now there is water flowing out of the bottom of the unit.


... Karcher Pressure Washers

When the patio cleaner is attached,the Karcher 5.68 pressure washer now keeps stopping and starting.It works fine on high pressure lance.It worked fine when bought from new a few days ago. We tried attaching the patio cleaner head to a larger machine with the same results.


... Karcher Pressure Washers

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

I started working with the Karcher KB4040 pressure washer and all was well for 1-2mins, then it sputered a bit and all power died. All hoses were still attached properly, it hadn't blown a fuse in my house and the fuse in the plug of the washer is working fine.When I switch it on I get nothing. Do you think the motor has packed in? I borrowed the machine from my neighbour who's away on holiday, so don't know much about age of the machine. Any advice much appreciated.


If the water is in anyway impeded, like kink in hose the unit turns off and goes into protection mode. That it it shuts down for a pewriod of time depending on how hot it may have got.\015\012When its rested try it again ensuring you definitely ... Karcher 1750 psi Electric Pressure Washer

I have a kitchen aid dishwasher that is not dispursing the water enough to clean. I have cleaned the entire unit with commercial cleaners and have added vinegar to the washer without dishes. And still it seems to not clean. It fills properly but the washer arms do not spin with any power.


You need to remove the wash arms by turning the nut in the centre of the arm and remove,then unblock the holes that are in the arms and replace them,test if the arms now turn and you can see a differance then also check there is salt in the salt disp ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Cleaner hose will not **** cleaner it blows water out of th hose ona 2700 psi craftsman presure washer


... Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

My Honda 2600 psi power washer will not pull to start. It was running great then I allowed the neighbor to borrow it. He ran the washer till it was out of gas and proceeded to refuel and at this point it would no longer start. The pull cord is out about 4-6 inches out and I am concerned about taking the casing off myself. Fearing that it may throw more off on the unit. If i take the casing off are there any spring loaded parts that will dismount? What should I do? Spark Plug? Turn


You should be fine to take the recoil off, there shouldn't be anything that shoots out at you. You might want to check the oil level on the engine, many of the Honda engines won't start unless there is enough oil in them. If your oil level is fine, c ... Honda Pressure Washer PSI 3000

Task Force Electric Pressure Washer 2000 PSI will not spray cleaner from tanks


... Task Force 2000 PSI Electric Pressure Washer NEW 6127

Pressure washer leaks oil through air cleaner


Thanks solution was great. ... Karcher 2500 PSI Pressure Washer

My pressure washer won't **** up and dispense cleaner from tube


... Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

Pressure washer will not start, cylinder has fuel in it. i think it was filled with diesel. i change the fuel, and the spark plug. still no start. if i spray it with carb or brake cleaner it runs fine.


Pull the fuel hose from the carburetor and let some drain out. Drain the carburetor float bowl. Are there H an L mixture adjustments? Preset each 1-1/2 to 2 turns CCW from CW stop. Get it running with spray if you have to, then adjust the mixtures fo ... Pressure Washers

Top rack dishes have a white gritty residue on them. i use washer cleaner and jet dry and it does not help. i don't know if there is filter to clean or not . what do i do?


Check whether the top rackspray arm is moving freely. Check the jet holes and remove clogs if any.Hope the bottom rack is good in wash quality! ... KitchenAid 24 in. KUDG25SH Built-in Dishwasher

I have a go kart with a honda power washer motor that I just purchased.It lacks power at start and stalls alot.Put new pull in,sprayed carb cleaner,adjusted carb,new air filter,need to know if it need a fuel pump and were to get one


Hondas are gravity feed no pump needed .You might need to clean the card though. ... Karcher 2500 PSI Pressure Washer

I have a troy built pressure washer 2200 psi. I let someone borrow it and when they brought it back water is spewing out the bottom. Do I need a new pump or what


... Briggs & Stratton Pressure Washers

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

Washer fails to dispense cleanser when hose placed din cleaner solution


... Psi Blue Max 2200 High Pressure Gas Power Washer

I have a preesure washer with a honda motor. will only start with air cleaner removed


The air cleaner filter may need to be replaced. Also, it sounds like the carbeurator needs to be cleaned. Get a can of aerosol carbeurator cleaner and spray four or five quick bursts into the air cleaner while the filter is off. Run the pressure w ... Karcher 2500 PSI Pressure Washer

John Deere 3300 PSi pressure washer shutting off while in use.Everything appears fine Oil level,Gal level,Air cleaner ok etc.. May run 2 minutes or 12 minutes then spudders a bit then Bang "Off" as if i turned it off.May or may not restart after a couple of pulls.


John Deere will replace the cap for free; they acknowledge the vendor who supplied Briggs & Stratton gas caps provided faulty caps. Call 1-888-228-3068 then 1 (English), 2, 1 and a technician will ask you for model number and Serial Number ... Dewalt 3800 PSI Pressure Washer

I have a craftsman pressure washer. it sat for a year but it did start and it ran fine. then my sister borrowed it and it started but while it was running she tipped it to move it to another location and it just stopped. i've checked all fluid levels, gas, etc. and are ok . i can't start it. is there a safety breaker/fuse that automatically shuts it down and has to be reset?


... Karcher 2500 PSI Pressure Washer

STEAM CLEANER WON'T EMIT STEAM - Pressure Washers


... Pressure Washers

Rain? I left a borrowed durabuilt 1300 psi pressure washer outside when I had to stop the job due to rain. I figured it'd be fine as long as it was unplugged but when I tried to run it, i smelled something funny so I shut it off. Did I break it?


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I have a HDS 950 er915 I have the pressure washer working but can't get the steam cleaner to ingnight the spark is working all the time even when just on pump but it will not inject oil even on full heat setting with burner switch on


The fuel pump is controlled by several things. A flow switch, a thermostat, a pressure switch. All must be working for the heater to work. Also you said inject oil. I hope you mean diesel fuel or kerosene. It won't burn oil. ... Karcher Pressure Washers

I have tried to use my Karcher washer model 411A using the suction tube which is immersed into Patio cleaner bottle but it does not work what am I doing wrong


You have to lower the pressure at the lance for the detergent to be drawn into the hose. It works on a venturi principle.on the lance you will have to twist or pull back the end for it to go into low pressure mode.the easiest way t ... Alfred Karcher Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0570 seconds