Having problems with your Karcher 2500 PSI Pressure Washer ?

Hi i have a honda gx340 11hp washer it has.nt being used in over 2 years i had to change the valves, got it going now its blowing black smoke and running very low on power thanks shane.


Answers :

Hi,

It would generate smoke if there is too much oil is left in the filter. Check air cleaner and it would fix the issue.

Let me provide you with Service Manual ( Generic ) for all the Honda Engines.

The link would be :-

http://www.electricgeneratorsdirect.com/manuals/NGK%20Generator%20Honda%20engine.pdf

There would a proper troubleshooting chart and steps that you need to take care off.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi i have a honda gx340 11hp washer it has.nt being used in over 2 years i had to change the valves, got it going now its blowing black smoke and running very low on power thanks shane.


Hi,It would generate smoke if there is too much oil is left in the filter. Check air cleaner and it would fix the issue.Let me provide you with Service Manual ( Generic ) for all the Honda Engines.The link would be ... Karcher 2500 PSI Pressure Washer

Washer wasnt use in over a year when i started using it it work ok not to much power though and then it increased power and then starting blowing alot of black smoke from exhaust. when i tried to start it again after putting new gas it starting back firing and then would shut off.


... Karcher 2500 PSI Pressure Washer

Miele G842SC - opened the door while the dishwasher was running, the washer kept running and when I shut the door it stopped working. I have un-plugged the power and tryed to re-start but no luck. The Canada center says it is going to be 2 week for a repair and I have to wait to the day of to find out when the repair person is going to be there. I cannot believe the lack of service and support for this product.


... Miele Dishwashers

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

The fuse in the plug keeps blowing. Initially it would run for a while - sometimes 3 or 4 cycles - before blowing. It now blows the fuse the second that I plug in to the socket, even with the on/off button on the front of the dishwasher set to off.I'm keen to take it apart, but it's full of water as it blew mid-cycle. Is there a clever way to empty the machine without the power being on, or do I need bits of hose and sponges?A schematic blow up would also be extremely helpful.


Lower the outlet hose into a washing up bowl, it should then Drain. Check the heater to see if it is earthing you get to it by removing the right hand side panel. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

GU980 dishwasher I have a buzzing sound when the washer is in drain mode. The manual indicates there might be something in the Power Clean Filter, and that it will go away when the object grinds up. I called Whirpool, and they said the same, and to run for 2-3 cycles to make go away. 2-3 cyles later, noise is still there. I noticed a nub off the rack that looks like an end peice of metal broke off from rust. My guess is it's stuck in the PCF, and will not grind up. I removed the nut, lower spray


The nut holding the inpeller has to come off it is probally frozen\015\012if it snaps off then the pump assy willl have to be replaced or at least the motor, you need to get below the impeller to see what is down there though, or let it run as ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Continuous alarm after a power failure an alarm started going off in the door of the dishwasher. the push button panel is not functioning. I opened the door panel and found an electronic control circuit board. It is this board that is making the noise. I unplugged the black and white pair of wires on the lower right side of the board and the noise stopped. this must supply power to board. Anyone know what this problem is?


I posted this under "Ben's" problem as well, but I had the exact same problem. I know which black and white wires you're talking about. I don't know what causes this, but getting new parts did fix it. The black box that all those wires go into on ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

The power is going to the dishwasher. The on off buttons work. No error codes. The salt light is lite (has been for 5 years) but now I get zero response when shutting the door (after selecting any of the 6 run options). There is no noise, no water, nothing happens. How do I repair this dishwasher so that it will run again?


Door switch failure. This will shut down all other start options. Inspect and possible replacement. See if you can activate it with something with door open. Give it a good close look... ... Dishwashers

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

Control panel will not light up, the dishwasher was running and now it has stopped mid cycle and will not do anything. I just replaced the control panel (black plastic with buttons, not control circuitry). was running the diswasher and it seemed to be working fine, then stopped. water is standing in tub, I checked the float, I don't think the float is the problem. There is power to the outlet, no tripped breakers. But control panel will not light up.


I have a kitchenaid dishwasher model # KUDC10FXBL1 I went to start it and none of the buttons were working. I have checked the breaker and the wiring and everything seems to be in order. ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

We have a kitchenAid dishwasher -- just installed last year new-- we cannot get the rinse aid low light to go off. We have filled it up to where it can no longer hold anymore and the light is still on. I have tried to cut the power on/off and it still remains on. Any suggestions on how to get the light to go off? thank you.


Check to see if the "Heat Dry/Lock" button is lit up. If it is, press the button and hold it for four seconds to unlock your dishwasher controls.Close your dishwasher door firmly and press the "Cancel" button. Wait two minutes for your Ki ... KitchenAid Dishwashers

After a power outage, that occured while the dishwasher was running, the lights come on and there is a high pitched noise. Then all the lights go off and the motor sounds like it is starting. However there is no water and the heating elemant comes on. The lights on the front; china/crystal, normal wash, clean and heated dry, all come on as if the computer is confused and trying to run them all simultaneously.


Sounds like the board was fried from a power surge ... GE Tritonr XL GSD6260JCC Dishwasher

Gibson Furnace Hi and thanks for reading my question. I have a Gibson furnace with electronic ignition. When I turn on the power to the furnace it starts running with the batteries removed from the thermostat. It blows but does not produce cool or or stop running. The circuit board has a small red light that is flashing but does not seem to have a pattern. I would appreciate any input that you may have. Also are the relays located ont he circuit board itself?


... Dishwashers

We have a Bosch dishwasher. The manual says for models SHV46C13, SHX43C0 so I guess it is one of those. It stopped working and when I opened it there was a bunch of cloudy soapy water on the bottom. The power was not coming on at that point. I have noticed that lately when I go to push the on button, the light will go on and when I shut it it doesn't start. After a couple times of turning it off and on it will run normally. This has only happened a couple times though....


... Bosch Dishwashers

I have a ge dishwasher eterna series quiet power 3. the dishes are dirtier when they come out than when the go in. we rinse the before they go in the have black or white grains on them.thank you


... GE Dishwashers

My Frigidaire Model FDB2810LDC1 dishwasher will not stop running. Seems to complete a normal cycle and different cycles can be selected with normal time countdown but at end only rinse agent low light remains lit and sounds as if pump is still running. If opened, water appears to be streaming from rotator arms. Have cycled power but symptoms remain.


... Frigidaire Dishwashers

Tecumseh Snow King HS40 engine only runs on full choke, no power


I did and thanks - just picked up one that does the same thing and i plan to take your advise \015\012\015\012Thank you Jerr ... Karcher 2500 PSI Pressure Washer

Power washer blowing white smoke


... Pressure Washers

I have gcv 160 5.5 hp power washer my problem is that the high pressure pump is not working properly when the engine is running the output pressure is very low so i would like to know could be the possible cause of that problem


look for a black plastic cover with a silver snap on top; pry off the silver snap and lift off the plastic cover; next remove the two screws on the top plate then pull out the piston inside - if unable to lift out, start unit and watch it pop ... Karcher 2500 PSI Pressure Washer

My low detergent light is on while my wife uses tablets when she runs the dishwasher. I tried turning the power off to reset but it still stays on.


The low detergent light comes on because the dishwasher recognizes the powder or liquid wash detergent.\015\012\015\012In the Tablet form the dishwasher things you do not have enough becasue the tablets are condensed tightly. I use the ta ... GE Dishwashers

It won't run. It has power but won't go thru cycle, won't do anything.


The anti flood activates when water (even a small amount) appears on the bottom of the machiene. This is usualy a leaking pipe but can also be caused by a clogged pipe. Most machiens do have a plastic pipe that (from the flat water tank) feeds water ... Dishwashers

I have a 3 year old GLD6200 that gets used once per week While running it this morning I heard a sizzling sound, i turned around just in time to see the control panel flicker and go dark. This was followed by a little smoke & a very distinct motor-burning smell. My first though it that it's toast - suggestions?? In searching for info on line I must admit I am dismayed at the number of negative comments about product quality & customer service after a break-down. Hope thats the exception and not


... GE 24 in. GLD6200L Built-in Dishwasher

My Kenmore portable dishwasher quit working in the middle of the wash cycle. It has power going in, but no longer runs at all. I need a service manual or a troubleshooting guide. Is there a circuit breaker somewhere on it that needs to be reset? Charlie


This seems to be that the Anti Flood system has triggered. This device detects water leaks / spills to the bottom of the washer and automatically puts the washer in pump out mode and shuts off the water inlet. The device is made up of a pollystireene ... Dishwashers

Low pressure, seems to run fine. there is less than 1/2 power pressure


You might wanna shoot some air into the motor vents to remove any debris or dust that has settled in it. If that's the problem it should restore some power.If you can remove any parts for more access to the motor, do so so you can get a ... Briggs & Stratton Pressure Washers

Power washer Briggs & stratton model 2200 from sears. Just pulled out of my shed. Runs fine but water pressure is really low. I cleaned everything that may be blocked. Water pressure from house is ok.. I'm lost Help thank you.


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1293 seconds