Having problems with your Karcher 2500 PSI Pressure Washer ?

Power washer will not start

\015 Power washer sat for a yer, now will not start.\015

Answers :

Clean the carb. Change the plug. Get some start fluid but use sparingly. Run the water (pull the washer trigger) while you are trying to start the engine.
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

I have full power to the washer, but as soon as i hit start to begin the cycle, i lose all power. i then have to unplug it and then plug it in again and then i get power back agin. as soon as i hit start again i lose all power to washer again. im thinking maybe the mother board is shot????


... EuroTech 24 in. EDW154E Built-in Dishwasher

So I found this power washer for sale. The seller claims that the washer generates a good stream of water, not just full power. He also mentions that after a few minutes the engine starts to bog down like it is working extra hard. Does this sound like a pump issue? Could something be clogged or would the pump need to be replaced? Or should I avoid this power washer?


Don't buy a power that doesn't work.There are many expensive parts on a power washer. If it was cheap and simple to fix, the seller would fix it and the washer would not be for sale.Would you buy a car that doesn't work? Especially ... Pressure Washers

Washer wasnt use in over a year when i started using it it work ok not to much power though and then it increased power and then starting blowing alot of black smoke from exhaust. when i tried to start it again after putting new gas it starting back firing and then would shut off.


... Karcher 2500 PSI Pressure Washer

Bosch SHX33A: lights come on properly in response to buttons, it has power. Close door, it makes the normal startup sounds, then water flows in. Normally, at this point washer starts into normal cycle. Instead, it just sits there and nothing happens. Forever. Not a matter of patience: we've left it in that state all night long. Have flipped power circuit and started over, everything else I can think of to kick-start it, no change.


Hi\015\012\015\012The issue seems to be with the motor or the door latch\015\012assembly going bad and should be replaced. The washer won't start the cycle if\015\012motor is not working, as its filling with water so I believe that the do ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Power washer won't start - Briggs & Stratton Power Products 1539 Pressure Washer


Have you checked for spark? You can remove the plug, touch it against the block and crank it and see if you have any spark (best done in as dark a place as possible). If you don't have spark, start by replacing the plug.\015\012\015\012 ... Briggs & Stratton Power Products 1539 Pressure Washer

I own a KUDS01FLSS3 KitchenAid dishwasher. The lights on the control panel do not come on and a cycle can not be started. There is about an inch of water in the bottom of the dishwasher basin and it looks like the previous cycle did not complete. I have checked the wall outlet that the washer is plugged into and the washer is receiving power from the wall. And ideas? My next thought was to take the door off and check the power supply running to the door panel and control panel.


Servtek06 writes:\015\012check connections @ control board/module. May be Control Board/Module. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a McCulloch FH160B power washer and it no longer builds up pressure. I haven't used this very much at all. I tore it apart and cleaned everything I could find. When i pull the trigger for the spray nozzle, I get line water pressure. When I release the trigger, the power washer sounds like it starts to build up pressure. When this was working correctly, the pump would shut off when the trigger was released. Any suggestions?


... McCulloch Pressure Washers

Power washer I have a karcher power washer and it haves a 7.0 robin motor on it... When i start it up the motor just goes in to high speed... I looked to see if all the springs are on the arm and they are ....All i can think of that the governer on the motor is not kicking it back... If you could help that will be great....Thanks Jerry


... Karcher 2500 PSI Pressure Washer

My Honda 2600 psi power washer will not pull to start. It was running great then I allowed the neighbor to borrow it. He ran the washer till it was out of gas and proceeded to refuel and at this point it would no longer start. The pull cord is out about 4-6 inches out and I am concerned about taking the casing off myself. Fearing that it may throw more off on the unit. If i take the casing off are there any spring loaded parts that will dismount? What should I do? Spark Plug? Turn


You should be fine to take the recoil off, there shouldn't be anything that shoots out at you. You might want to check the oil level on the engine, many of the Honda engines won't start unless there is enough oil in them. If your oil level is fine, c ... Honda Pressure Washer PSI 3000

Power washer My generac 6670gp power washer surges frequently. Especially when I try to increase the volume. I let the water run through it for a couple of minutes prior to starting it. It actually seems to pulse just coming out of the hose without the moter running. Am I doing something wrong?


... General Pressure Washers

Why will water not flow through hose into the spray gun with the washer not started as well I started the power washer and the water still does not come out.


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

I have a zanussi ZSF2440 dishwasher, when it turned on by the power button on the front you can choose a cycle and start it, Once the cycle is started it fills up with water but doesn't stop until it over flows setting off the flood protection, which cuts the power, so all the lights on the display go off and stops the water flow and drains the dishwasher and keeps draining the dish washer while the flood protection is on. It seems as if the dishwasher doesn't know when its reached its correct


... Zanussi Dishwashers

I can't get my home lite 2200 psi power washer too start. I replaced the spark plug and put in fresh gas. Still won't start


... Pressure Washers

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

My K5.20M power washer won't start. Am looking


Make sure\015\012your extension cord is able to provide 13 amps or greater of current.\015\012The longer the extension cord the more current it requires to supply\015\012the 13 amps to your power washer. If your unit has a long extension cord i ... Karcher Pressure Washers

Washer fails to start. Power o.k. and water supply on. Filters cleaned. When set to start makes regular sound as if trying to start cycle. Any advice please?


Hi.Check if the water is flowing inside machine or not.If the tub is not filling, test the water level device (usually a float switch located on a side inside the tub).Ensure that the switch is not stuc ... Zanussi 23 in. ZDT6252 Built-in Dishwasher

I have a Whirlpool ADG7966 which started malfunctioning yesterday: the delayed start option locked the washer and does not change or allow it to start the cycle. I already turned the machine off/on and also tried doing it from the home power "switchboard". Any help reseting this is most welcome! Thanks for your attention - Nuno.


... Dishwashers

I cant start my power washer. the pull start is locked and wont release to start engine.


When the pull start gets locked, you have to release water pressure from the wand. I had the same problem last year. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.


You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

Washer will not start. acts like no power. front


... Dishwashers

Washer will not start. acts like no power. front


... Whirlpool Dishwashers

No control panel lites. Washer started then stopped as if power shut off.


Hello John - Let's try resetting the dishwasher by either\012unplugging it or flipping the household circuit breaker to the off position. It\012is important to wait roughly ten minutes and then turn on the unit. Confirm that the door is properly lat ... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0762 seconds