Having problems with your Karcher 2500 PSI Pressure Washer ?

I have Honda small engine model GVC160 5.5 hp I t

\015 I have Honda small engine model GVC160 5.5 hp It only runs with choke closed and when you push the choke lever in the engine dies. I find no full air mixture screw to adjust.\015

Answers :

Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have Honda small engine model GVC160 5.5 hp I t


... Karcher 2500 PSI Pressure Washer

I HAVE AN EXCELL PRESSURE WASHER-MODEL EXPRO 2530-HONDA ENGINE GX200QX2-IT HAS A CAT PUMP MODEL#2SFX30GZ1. IT IS VERY HARD TO CRANK UNLESS YOU DEPRESS THE HANDLE ON THE SPRAY WAND WHILE CRANKING.ONCE STARTED IT WORKS FINE UNTIL YOU RELEASE THE HANDLE AND THEN THE ENGINE QUITS.IT DOES NOT GO INTO BYPASS MODE.


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Hello, I own a Honda Pressure Washer (Porter Cable Model) with a Cat pump 2600psi and 6.5 hp. An Excellent machine for the past 7 years. Last fall I noticed it was not producing the full pressure but still Engine was running strong. This past weekend. started it up and used it for about 1 hour still with minimal pressure at full throttle. Then pressure was totally cut off. I stopped and started the engine the engine and it had minimal pressure again. Same thing happened again. I stopped the engi


... Honda Pressure Washers

EX-CEL PRESSURWE WASHER MODEL EXH2425. HONDA 5 HP GC160 ENGINE. THE ENGINE STARTS EASY. RUNS WITH GREAT HIGH PRESSURE. WHEN WAND IS RELEASED ENGINE WILL QUIT IN 30 SECONDS OR LESS.


... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

Honda small engine carb. cleaning


Honda jets thread into the main venturi where the float bowl bolt goes. you jut need a blade/ flat screwdriver to thread it out. becareful they are only brass and thread it out and the emulsion tube should come out as well fairly easily. you may need ... Karcher 2500 PSI Pressure Washer

Need owners manual for husky power washer 2.3 GPM 2600 PSI with Honda GVC 160 engine Model HU80722


... Pressure Washers

Sorry for the mix up of the model cant find mine to put on here its a 74 honda TL 125 I replaced the clutch cable and did all the adjustments both at the lever and at the engine but still slack so after screwing around with that and looking at the owners manual i decided to take the engine cover off that the clutch lever goes into that the cable conects to and thought something might be goin on in ther. So as i took it off the cover and looked at everthing and it looks good but what looks little


... Honda Pressure Washer PSI 3000

My pump is gone on my pressure washer. The honda engine is GC 160. The pump is a model VRX2527G. How do I pull the pump off the engine to replace it. I removed the four bolts from the pump housing, but the pump is still tight to the shaft. Please explain the removal process.


Hello,Your pump sits on a keyed shaft, versus a taper fit. This is good, since tapered shafts will require a puller to remove the pump.Since the pump is already bad, you have a few options available to you. 1) W ... Honda Pressure Washers

I have a craftsman w/ honda model # 580752060 pressure washer. Started washing & after about 10 min. lost all pressure, no water comes from nozzle while engine runs. Cut off engine & nozzle sprays


You have a clog somewhere ... Craftsman 2600 PSI Honda Powered Pressure Washer

For pressure washer Model WP-2402-SWHB, SN 10132043: With Honda engine running, or no engine running, no water will pass through the pump.


Hi If no water is passing through your pump on mains water pressure and not sucking from a barrel then it will be either a blocked nozzle,blocked unloader on the side of the pump or a blocked water filter. ... Pressure Washers

Honda Trash Pump Model WT30X Stalling - 8hp engine runs for approx 5 seconds that shuts down, restarts after I hear a relay click ? oil is fine - so I do not believe that it is an oil pressure sensor. Are there any other sensors ? Does water have to be pumping through it??


Their is an oil level sensor that lasts around 3 months of use. unplugging it would solve your problem But replacing it is a night mare. and if your oil runs out It's all over. if not the oil sensor, and your spark is constant Check your fuel system ... Honda 8 HP Engine

I have a Generac pressure washer, model #01450-0, with a Honda 5hp motor. The motor runs fine, but the pressure hose pulsates as if the pump is intermittently making pressure, and the pressure out of the sprayer is about half of what it should be. A friend suggested replacing the seals in the unloader. I bought an unloader kit, replaced everything and it still runs the same. It will build a small amount of pressure, spray for a few seconds, then the pressure dropps to almost nothing. Any help ap


Take a small diameter wire and poke thru the discharge hole of the spray head to clean out.\015\012Second time in 6 months that I had the same problem. The problem is alway in the spray head. ... Pressure Washers

No pressure i bought a used 2800 psi pressure washer has a 190 honda engine i can't fine the model number it has no pressure i pulled it all apart the only thing that i found was the pressure adjustment was stuck i freed it up.


... Pressure Washers

For Mi-T-M pressure washer Model WP-2402-SWHB: Honda engine runs fine, but only a trickle of water comes out of pressure line when trigger engaged.


... Pressure Washers

How i can add pump oil on karcher powor pressure washer model G2600VH honda engine


... Karcher G 2600 VH Gas Pressure Washer

Pressure washer serial#0493, model # 3504cwhbd, I need the name of the pressurer washer company,it has a 13HP Honda engine and stainless steel carage


... Pressure Washers

I have a Northstar GX series pressure washer with a Cat pump model 3SP30G1. Honda engine starts right up but no water from wand. Water source into unit seems sufficient still no water out. Any ideas?


... Northstar Professional Series Pressure Washer 4000 PSI

Have a honda 5.0 hp engine on a pressure washer model belive is a de 1504 not sure of make, starts if you use starting fluid but then dies, getting gas to the bowl at botttom of carb but not to carburator


Hi there mburns44 i believe your problem is either that either the Air/Fuel mixture is too rich and causing it to flood or you have clogged jets. carburators are tricky and often times need to be cleaned or adjusted by a professional. I hope that thi ... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

I need to know what kind of oil the pressure washer takes, I noticed it has a place for oil on the engine and another neat the pump. The product is a honda pressure wave 220 PSI Model NO 2225cwh-2


... Honda Maxus Prosumer MX5223 Pressure Washer

I have a model 5000g. it might have 15 hrs. total running time on it. when i tried to use it last it would not build pressure. i took the pump apart and cleaned and regreased it. everything looked good. ive got good pressure to the pump but just a small spray out the wand. when running there is no real load on the engine. it has always been kept inside in a warm enviorment.


... Karcher Pressure Washers

I purchased a Honda Power Washer Model PWH2600 two weeks ago. I cleaned half my deck when the motor shut off unexpectantly, and now the cord will not pull to restart the engine. Any ideas what I can do for the cord to pull normally?


You just bought it so it is under warranty. I would take it back to the place you bought it for service. If the starter rope will not pull then the engine may be locked up. Check the oil level and make sure it is full before returning it for service. ... Honda Pressure Washers

My Honda pressure washer engine model GC190 is leaking gas from the carburator when running. How can I repair this problem


... Honda Karcher G2400HH-R Pressure Washer

Karcher 2500 with Honda GVC160 5.5 engine. The carb is clean but it lopes unless the choke is partially closed and then it is better. Gas flow seems OK. Starts OK. When holding the governor it runs smoth. Any ideas?


Make sure the governor linkage is clean and works freely. A lot of times when you put a load on the machine, use it it stopps the fluttering. ... Karcher 2500 PSI Pressure Washer

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

I have a Karcher 3000 psi with Honda GC190 6.0 engine. At 25 months, home use 2 summers, engine cam came apart & timing belt cut in half. Mechanic say he has seen this frequently with Honda engines. Is this true?


Honda engines are know to be very well and durable. ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0624 seconds