Having problems with your Karcher 2500 PSI Pressure Washer ?

Pull rope wont retracxt all the way

\015 It is a Karcher pressure washer iats difficult to star bause you cant get a fukll pull of the rope\015

Answers :

Coil spring inside needs to be recoiled or tab is broken or off the hook
\015\012pull the rope assembly off and inspect/ repair or replace
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Pull rope wont retracxt all the way


Coil spring inside needs to be recoiled or tab is broken or off the hook\015\012pull the rope assembly off and inspect/ repair or replace ... Karcher 2500 PSI Pressure Washer

Sears 2500psi briggs and straton rope wont pull


... Briggs & Stratton Gas Pressure Washer 20244

The rip cord wont pull to start pulls once and then wont pull real hard to pull


Try squeezing the wand when you are starting the motor.\012it will let the water pressure go through. ... Honda Pressure Washer PSI 3000

I have a Troy bilt 2700 psi pressure washer and I can't get the pull start to pull all the way. It pulls part way and is stuck. The last time I was running it it shut down on its own and I haven't been able to restart it since. Thanks


... Pressure Washers

I have a kohler command pro 8.5 on a porter cable pressure washer. Yesterday it started just fine. Today I pulled the start rope and there was no resistance and the engine did not turn over. The pull rope rewound just fine and I tried again with the same result. After several tries it caught just a little near the end of the pull and the engine started. What is the cause of this problem?


... Porter Cable Pressure Washers

I 'm trying to pull the rope and it will barely--honda pressure w


The rope may be bound up in the recoil. Take the recoil cover off(the piece where the pull rope goes into) and try to pull the rope with the housing off. If it pulls freely try turning the engine by hand, you may want to remove the spark plug to rele ... Honda Karcher G4000RH Pressure Washer

The cable in my Husky Gas Power Washer wont pull start


... Honda Pressure Washers

I cannot pull the rope on my gas pressure washer locked up, do all the hoses have to be hooked up and water running for the rope to pull


The engine might have failed unbolt the pump and see if its the pump that locked up or the engine ... Briggs & Stratton Gas Pressure Washer 20244

I have a 2500 craftsman power washer with a Briggs and Stratton engine. I used it about a month ago and it worked fine. Took it out yesterday and I could not pull the rope to get it started. I took out the spark plug to release the compression but I still could not pull the rope out it is locked any advice.


It sounds like the pump is seized. Make sure any pressure has been released by pulling the trigger on the gun. Sometimes this will allow you pull the cord. If the pump is seized, a new pump would be in order. ... Briggs & Stratton Pressure Washers

I havehonda gs 160 5.0 hp petrol powerwasher,it madea noise and just stoppe going,the pull cord wont even pull what is wrong?


Did you figure this out ... Pressure Washers

Honda gx160 wont pull start with spark plug in.


... Honda Pressure Washers

My neighbor just gave me a Troy Bilt 020207 power washer. It is 2450 PSI and 2 GPM. He snapped the pull cord rope. I looked at the pull cord cover and it seems to have 3 rivets holding it to the main housing. How do you recommend to repair or replace the pull cord?


Sounds like a briggs engine, DONT remove the rivits, go down a little further and remove the 4 3/8 bolts that hold the blower housing on.Turn it upside down, prewinf the pulley in the direction that it turns when the rope is being pulled. When it sto ... Briggs & Stratton Pressure Washers

Water wont drain after wash!! Dishes wont dry all the way also


HI, usually, if the dishwasher dose not drain properly, it will be the fault of a defective or, malfunctioning pump. i will list several problem areas to check. Inspect each area properly and, replace any component that is faulty or fouled. ... Kenmore 24 in. 15932 Built-in Dishwasher

1999 honda foreman 450s pull rope not pulling is motor locked and what do i need to do


If you have a good angle to push down on the piston and it won't move it could be one of two things: the piston is at bottom-dead-center or the con-rod is seized to the crankshaft. If you can't move the crank with the pull rope it's probably the lat ... Pressure Washers

Troy bilt 2600psi 2.3gpm model 160 pressure washer, I hooked everything up like normal, It cranked up fine, when I pulled the trigger on the gun it stalled. When I try to crank it back up the cord wont even pull like its stuck any suggestions would really help me tks..


This sounds like the pump has dead headed. I.e. the unloader valve is sticking. Unhooking all of the hoses should eventually allow everything to free up. Once it is free what you should do is add about 3 ounces of oil into the water inlet connecti ... Pressure Washers

I cant pull the cord in my pressure washer it feels like it stuck thiere is no pressure in it it wont pull


Take the sparkplug out and see if you can pull the cord then. If fuel comes out of the sparkplug hole the carburetor is leaking gasoline in to the engine filling up the cylinder causing the lockup. The carb has to be rebuilt. Another problem mice lik ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Engine starts first pull but wil die when i pull the trigger all the way down


... Honda Black Max 3000 Psi Pressure Washer

My Ge profile Triton Dishwasher wont start when I lock it just keeps beeping and the" normal "light flashes there was something stuck in the turnstile and it stopped and beeped all night when I took it out it was left this way I have turned the power off and on and I still cant reset it any ideas it just wont reset


... GE Dishwashers

Pull rope broke. attached back but cant figure out how to make the rope recall work


The recoil spring has to be pre-loaded about 5 turns, even when the rope is fully returned. When you pull out the rope, you increase this tension, but if you are starting from zero, there won't be enough spring tension to fully recoil the rope. ... Honda Pressure Washers

The pull cord on gas pressure washer wont allow me to pull it as though it is tangled up, But when i removed the housing, it woorks just fine


Sometimes the housing gets bent slightly. A lot of the housings have little taps or prongs that get slightly bent. I would take the housing off make sure it not bent or warp, to make sure there is nothing to block the free flow of then cord flowing. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have an almost brand new husky pressure washer (one of the big ones). It has been a life saver so far. just the other day it shut its self off. its gas powered so of course i checked the gas and oil. then tried to start it back up. but when I try to pull the pull string it wont come out more than about 3 inches. i payed 400$ cash for it to use on the trucks. does anybody know how to fix that? thanks


IT SOUNDS LIKE YOUR FLY WHEEL IS BAD OR NEEDS TO BE ADJUSTED ... Pressure Washers

Honda 2800 p s i 6.5 gas powder gx 200 the pull rope will not pull. it may be seized ! if so can I get info on how to fix it, thanks


... Pressure Washers

Engine will not turn-over. It is a Honda 11 HP, OHV on a Karcher Pressure Washer. It was running fine for about 45 minutes. All of a sudden it stopped. When I tried to start it again, the engine is bound up so that the pull rope will not pull out at all. It has plenty of gas. The crank case is full of oil, not over full.


Pull the spart plug out and see if you can pull it. Sometimes the carb will flood the engine to a point that they get hydrolic lock.If it does free up then I suggest cleaning the carburator before trying to start it again.If it does not free up the y ... Karcher 2500 PSI Pressure Washer

Pull rope on troy built trimmer pulled all out and won't go back no spring tension is there any easy fix????


... Pressure Washers

Wont start cycle unless i open door all the way and shut it . when cycle starts it stays on that cycle until i open and shut door again. is their a way to reset


... Maytag 24 in. MDB8751A Jetclean II Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0417 seconds