Having problems with your Karcher 2500 PSI Pressure Washer ?

Have a Karcher 3000G pressure washer, low pressure. How do you remove the unloader valve?


Answers :

Ask the professor. He knows everything about everything. I'm working on my degree now. Go to Youtube like he does. LOL
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have a Karcher 3000G pressure washer, low pressure. How do you remove the unloader valve?


Ask the professor. He knows everything about everything. I'm working on my degree now. Go to Youtube like he does. LOL ... Karcher 2500 PSI Pressure Washer

Karcher pressure washer unloader valve sticking? I have the pump shown on page 3 of Karcher manual number 91392030. I removed the unloader valve, but am not sure if I have the entire assembly. I got the top seal and a spring. The bottom seal may be jammed in the pump.


... Karcher G3025OH Pressure Washer

Poor pressure karcher g 2500 pressure washer with a 5.5 honda engine. No high pressure, hose pulsates as does water out of the outlet. have removed the unloader valve twice and cleaned it to no avail


I had this same problem on my pressure washer.the pump had some broken parts in it .i found my replacement pump on EBay. ... Karcher 2500 PSI Pressure Washer

How do i remove the unloader valve on a karcher 4000 PRESSURE WASHER


... Karcher Pressure Washers

Clean and unloader valve on Karcher hd3500 pressure washer -intermittent pressure on and off. Cleaned inlet screen. Think unloader valve is is under pressure knob? Will cleaning help?


Hi:Cleaning it is not enough. You need to make sure the o-rings are in good shape and grease it with a very very good waterproof grease. ... Karcher Pressure Washers

My Karcher 4000 SHR Pressure Washer pressure pulses when operating. I have checked with Karcher Technical Support and all their trouble shooting procedures except checking the unloading valve. Where is this valve, how do I get to it and how do I lubricate it?


It sounds like your unloading valve is crudded up with mineral deposits and stuck in a partway open state. look for a plastic cover with a silver snap on top; pry off the silver snap and lift off the plastic cover; next remove the two screws on the ... Honda Karcher G4000RH Pressure Washer

I have a G2500VH pressure washer that has started to pulse when the trigger is squeezed. This happens if I use the 0,25, and 40 degree nozzles BUT if I use the one for low pressure(detergent use) it will hold pressure fine. I have changed the unloader valve, checked all the valves and seals ad they seem to be fine. What could be the problem?


Do you mean pressure on and off with the hp tips and smooth and steady with chemical tip? ... Pressure Washers

I recently replaced the water seals, V-packing & all six check valves in a CW-3504-4MGH pump on a MiTM 3504 pressure washer that had very low pressure. Usually this would fix most pressure problems on most machines, but in this case it had little to no effect. I suspect that the unloaded is the culprit in this case, but since I have had little experience in repairing unloaders (let alone adjusting them). I would appreciate feedback from anyone that has experience in this area. Thanks


Check the wand tip for a tiny piece of debris like a tiny rock or something stuck in the tip. ... Mi T M Pressure Washers

Karcher G3050OH Pressure Washer Spill / Unloader Valve (Bypass)


You should put 'locktite' on the male thread and screw it in all the way and lock it there. That is how it works ,the spring keeps the valve at the bottom closed during high pressure operation. When the gun is released the part with the o-ring is for ... Karcher 2500 PSI Pressure Washer

How do you locate/clean an unloader valve on a Karcher HD3000 pressure washer


... Karcher G3025OH Pressure Washer

Unloader Valve - Karcher Pressure Washer


Where is the unloader valve locaed on a Briggs Stratton pressure washer? ... Honda Karcher G4000RH Pressure Washer

We have a Karcher G2500VH pressure washer. If you start the engine with the trigger pulled on the spray wand it will run at full pressure until you release the trigger. after that, when you pull the trigger it will not have any more pressure than the water hose feeding it. Does it have an internal unloader valve? What is the part number?


Hi, Karcher calls the unloader valve a spill valve, this is a link to a full drawing/parts listing , and your fault description might well be a sticking /seized unloader(spill ) valve hope this helps ... Karcher 2500 PSI Pressure Washer

I have a Karcher HD 3101 pressure washer. The out pressure is not working. Is there a unloader valve that needs to be cleaned?


Yes, the unloader needs to be lubed. Send me a email at [email protected] with a discription of what you just listed and I will send you a pdf file on how to repair it. ... Karcher G3025OH Pressure Washer

I need to check the unloader valve on my Karcher 3000psi pressure washer. I was directed to your site for help. I just need to know what to unbolt to get to the valve.


... Pressure Washers

I was given a low hour, 10 year old, CH PW205002LE 6.5 HP gas vertical shaft 2000 PSI/2.5 GPM pressure washer with a Lavor pump. It did not work - no pressure. I found a broken o-ring on the brass unloader valve and replaced it with a ring as close in size as I could find as the part break down doesn't state size. Everything was very clean. I coated everything with silicine grease and reassembled, seating the brass piston? as deep as it would go. I had to press the trigger in order to get the mo


My personal experience is that 40% of all the sellers I dealt with on e*** exaggerated their products or worse. If you decide to go the e*** way be sure you put it on a good credit card so you can get your money back if it's a bust. Don't use your ba ... Campbell Hausfeld Pressure Washers

Karcher K3.91, lost some pressure and pulsing when trigger is release. stripped it down and checked all six valves and there all sealing as they should. i took apart the unloader valve cleaned and inspected and thats fine. there is NO water leeks anywhere or oil. preasure washer is 2 years old and gets used once a week for ten minutes. i really dont understand why its playing up


... Pressure Washers

Northstar Hot Water Pressure Washer (model #157322) While using the pressure washer the safety relief valve activated venting steam and hot water from it... I immediately shut it down and let it cool down. After it was cool, I turned on the water supply again and the relief valve was still spewing water from it. My neighbor said it was probably the "unloader" valve was stuck or damaged. I called around my area and it seems as though no one services my pressure washer.. Is there a manu


... Pressure Washers

Karcher K 2400 HH Pressure Washer no pressure


Http://www.landanorthwest.com/documents/instructional/spill_valve_instructions.pdf ... Karcher 2500 PSI Pressure Washer

Need help getting to an cleaning stuck unloader valve on a Karcher G 2400 HH Pressure washer. Thanks


The cart body makes this process a little confining but it can be carried out without removing the pump from the motor.\015\012\015\012Diagram courtesy of: ... Honda Karcher G2400HH-R Pressure Washer

How to remove stuck unloader valve on craftsman pressure washer


... Craftsman Pressure Washers

Where is the unloader valve on G 4000 RH - Honda Karcher G4000RH Pressure Washer


... Honda Karcher G4000RH Pressure Washer

How do I remove the spill valve on a k2400HH - Karcher 2500 PSI Pressure Washer


... Karcher 2500 PSI Pressure Washer

DeVilbiss/Excell XR2600 unloader acting up(low pressure) I removed the onloader cleaned and replaced now it loads up too much, engine wants to die but still has low pressure after initial burst?


... Pressure Washers

Karcher pressure washer HD 6/13 CX low pressure


... Pressure Washers

Karcher pressure washer HD 6/13 CX low pressure


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1279 seconds