Having problems with your Karcher 2500 PSI Pressure Washer ?

What type of fuel to be filled in 5.5 honda (R) Over cam


Answers :

If engine has a place for oil, then use ordinary gasoline.
If engine does not have a place for oil, then you use 2-cycle mix with the gasoline

If you have a power washer, there are normally 2 places to put oil.
1) in the pump head >> use SAE20 or SAE30 >> fill it about half way.
2) At bottom of engine is a screw-out plug >> use 10-W30 oil >> fill until it comes up 1/2 or 2/3 up on dip stick.
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What type of fuel to be filled in 5.5 honda (R) Over cam


If engine has a place for oil, then use ordinary gasoline.If engine does not have a place for oil, then you use 2-cycle mix with the gasolineIf you have a power washer, there are normally 2 places to put oil.1) in the pump hea ... Karcher 2500 PSI Pressure Washer

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer

I have a troybilt xp 2600 with honda engine,when i turn on the fuel petcock valve fuel drips directly in back of air filter.anyone familiar with this type of issue?


This sounds like a foreign object in the fuel inlet valve. You will need to go through the carb and clean/replace parts as needed. ... Pressure Washers

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

What type of oil is needed for a Honda GC160 Power Washer? Honda 2500 PSI x 2.3 GPM.


The type of oil recommended for that engine is SAE 10W-30 and the capacity is 0.61 quarts. This and more can be referenced at the website at the end of this solution. I was able to find the owners manual of your particular engine. http:/ ... Honda Pressure Washer PSI 3000

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

Got a lound buzz type noise that I thought was a bad solenoid on the water valve. Tub also filled up & overflowed1 Replaced water valve ($30), but now dishwasher wont run thru cycles or fill with water to wash--seems to be stuck on drain even though digital counter counts down. What should I check next?


You may have dislocated the connection that controls the AquaStop circuit.\015\012\015\012This is linked to the inlet hose. Either the connector linking the inlet tap to the inlet valve is loose or the float switch has triggered.\01 ... Bosch 24 in. SHU53 Built-in Dishwasher

Pressure washer will not start, cylinder has fuel in it. i think it was filled with diesel. i change the fuel, and the spark plug. still no start. if i spray it with carb or brake cleaner it runs fine.


Pull the fuel hose from the carburetor and let some drain out. Drain the carburetor float bowl. Are there H an L mixture adjustments? Preset each 1-1/2 to 2 turns CCW from CW stop. Get it running with spray if you have to, then adjust the mixtures fo ... Pressure Washers

Honda 2700 psi GC160 pressure washer will start with starter fluid in carburetor but wont stay running? Changed sparkplug cleaned carburetor, Added fuel cleaner then let set and drained all fuelandadded new. Seems as if their is no fuel going from the tank to the carburetor?


... Pressure Washers

How to check fuel pump for honda gc160 - Honda Pressure Washers


... Honda Pressure Washers

Model No. DU850SWPU3 AND SER. FT 4101406 TYPE 280-0. When cycle is complete and in off position the dishwasher fills with water. I find the bottom of the dishwasher standing full of water when I get ready to fill with next load of dishes. When I remember to turn off the wall switch this does not happen, however once in a while I forget to turn off the wall switch. The next day I find the bottom of the dishwasher full of water again. I then have to go through the cycles manually a couple of tim


If by turning the wall switch off, and only then it stops comming in, it means the board is faulty. There is a leak in the electronic system allowing to solonoid to stay partially open. Strangs that it doesnt flow onto the floor. ... Whirlpool GU2400XTP Built-in Dishwasher

I have a Karcher 3000 psi with Honda GC190 6.0 engine. At 25 months, home use 2 summers, engine cam came apart & timing belt cut in half. Mechanic say he has seen this frequently with Honda engines. Is this true?


Honda engines are know to be very well and durable. ... Karcher 2500 PSI Pressure Washer

I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.


You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer

Oil fill for Honda GX390 reduction case


... Honda Pressure Washers

Primer leaks gas after fuel tank is filled


... Pressure Washers

Rx2600 Honda Power Washer Fuel


... Honda Pressure Washers

I have a troy built power washer powered by honda. It runs for 10 - 15 minutes and then dies. I have replacced the ignition coil, spark plug, rebuilt the carburetor, checked fuel flow and placed the unloader valve and it still dies. Once it dies and the pressure is released it repeats the problem. Any suggestions?


... Honda Pressure Washer PSI 3000

I have a go kart with a honda power washer motor that I just purchased.It lacks power at start and stalls alot.Put new pull in,sprayed carb cleaner,adjusted carb,new air filter,need to know if it need a fuel pump and were to get one


Hondas are gravity feed no pump needed .You might need to clean the card though. ... Karcher 2500 PSI Pressure Washer

Honda GX340 engine will start, but will not continue to run. Checked fuel and spark plug.


... Honda 8 HP Engine

1997 Honda integra type r, installing a tacho! i know its the blue wire on the distributor but theres 3 blue ones, can someone either give me a link to a picture or and easy way to determine thanks :)


... Honda Maxus Pressure Washer MX5222

Excell pressure washer honda motor---have fuel flow---fresh---only runs when carb cleaner sprayed--then dies..........


Sounds like the carb is badly clogged internally. If you can remove it yourself, you can soak it overnight in a can of carb cleaner. But keep in mind some of the internal passageways in the carb are as fine a human hair and soaking may not work, it ... Karcher 2500 PSI Pressure Washer

I'm looking for a recoil starter for my generac pressure washer with a 4 hp honda engine mod # 01195-0 ser# 5016610 type 3600 cp


... Honda Pressure Washers

Cam replacement and timing on a Honda GC160 motor


... Honda Pressure Washers

The pressure washer i rented won't start after having used it for a couple of hours and filled it once with new fuel and then running it again for 30 minutes. i refilled it and now it won't stay going. it will start, and then it sputters and stops


If its a rented washer get the guy to come out and fix it,,,iv had rented things before and found out that some preson before me has put dirty fule into the thing,,, it sounds like a blocked card to me,,, try cleaning all the jets out ... Honda 8 HP Engine
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0737 seconds