Having problems with your Karcher 2500 PSI Pressure Washer ?

ONE OF THE SPRAY HEADS IN PATIO ATTACHMENT SEEMS BLOCKED


Answers :

Simple. find the smallest drill bit to fit the hole and run bit thru it. wala.
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

ONE OF THE SPRAY HEADS IN PATIO ATTACHMENT SEEMS BLOCKED


Simple. find the smallest drill bit to fit the hole and run bit thru it. wala. ... Karcher 2500 PSI Pressure Washer

NEFF S4443 top spray bar not rotating, no water. Bottom spray bar rotates and sprays water. Checked and replaced fine/course mesh filters. Will pump to empty and refill on pre-wash (rinse). Seems the pump may have two outlets one feeding the bottom spay bar (nearest from of machine) and one just behind which feeds the upper spray bar. Running without spar bars attached (including mechanism feeding to bar, water is only being forced out of the from outlet. Any ideas before I start taking it apart


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

When the patio cleaner is attached,the Karcher 5.68 pressure washer now keeps stopping and starting.It works fine on high pressure lance.It worked fine when bought from new a few days ago. We tried attaching the patio cleaner head to a larger machine with the same results.


... Karcher Pressure Washers

I have a KUDS03CTWHO KitchenAid dishwasher. It started not cleaning the upper tray well a few weeks ago and now the lower one is not getting cleaned very well either. I have disassembled and cleaned the 3rd level , upper and lower spray/wash arm assemblies as well as the feed tube assemble. These were not blocked or glogged. There appears to be less spray coming out of the upper and 3rd level spray arms they before but as I said there is no blockage. I also cleaned the bottom filter. There has b


\015\012Hi\015\012\015\012The issue seems to be with the float switch\015\012assembly that is bad and should be replaced. Please check this ... KitchenAid Dishwashers

Bought suction hose for karcher in order to use water from bucket. Have attached hose but there is no water being sucked from the bucket . One side of hose attached to washer the other dropped in bucket is this right? The end in the bucket has no suction, and a depressable valve that seems to be impeding the water suction. Do I remove this valve ?


... Karcher 26408500 Pressure Washer 25Foot ExtensionReplacement Hose

Attaching the spray wandto the unit it doesnt seem to want to thread to the attachment


... Karcher PSI Electric Pressure Washer

My kitchenaid dishwasher kudl03fvss0 is leaving disher dirty, specks of debre are allover the dishes, and the door is has debrie on it. seems like the dishes are either not getting sprayed well i have checked to make sure nothing is blocking the spray arms on the top and bottom and i use a rinse aid any ideas?


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Dishwashers

My Kitchen Aid KUDS01FLSS2 dishwasher does not spray water thru the wash arms nor do they seem to turn. Additionally, one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" when rotated by hand. The spray arm assembly appears true on visual examination. The unit fills, cycles and pumps out in an apparent normal way. While on this site a while back I was advised to clean the unit and referred to a downloadable repair manual that was, in fact, not


Hi.The fact that "one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" would suggest a tubing problem. However there are more faults that will result in no spray. Testing in this case can be ... KitchenAid Dishwashers

Favorit 40850 dishwasher. The crockery in the upper basket is not being washed. It seems as if the spray arm is not rotating. As far as I can see, there is nothing preventing the water transferring from the body to the tube supplying the spray arm and nothing blocking it


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... AEG 24 in. Favorit 40850 Free-standing Dishwasher

The dishwasher doesn't seem to have nearly enough water in it. The upper sprayer arm doesn't seem to be spinning when running (I open the door and look really quick) and the lower one looks like it barely spins and barely sprays water. The dishes are barely wet and the soap is just laying on the bottom. The water is on, there are no kinks in the supply line. It sounds like it is running, and pumps pumping, but being brand new I am not sure what it should sound like. It certainly doesn't sound li


I would lift the drain pipe higher. approx. 1/2 the height of the dishwasher . also rechack incomming water supply. Make sure no blockages and the like. Try again. ... Bosch Dishwashers

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

Noticed dishes on top shelf not entirely clean. Ran machine empty and opened many times during wash. Noticed that Lower Spray Arm works as expected, but Middle Spray Arm turns only 1/8 or less, then Lower Arm spins again. Schematic with Use and Care manual just says pump motor switches from one to the other in certain cycles, but I don't see this happening. Looked for obstructions to water flow and pressure seems normal. Is control for this function part of the pump, or in the control panel?


Something could be in that checkball, see page 5 ... Frigidaire 24 in. GLDB653A Built-in Dishwasher

Last couple of days bottom rack of dishwasher not been clean on 65o wash, having emptied and run the machine empty etc it seems that whilst there is water being pumped through the roof mounted vents and to the "spinner" attached to the upper tray, the spinner attached to the base of the machine is not getting a) any / b) sufficent water pressure to make it spin...im guessing the feed is blocked?


... Bosch 24 in. SGS43C02 Classixx Built-in Dishwasher

When we do not use the dishwasher for a week or more water seems to back up into the tub. The water has a foul smell to it and can be as much as an inch or so deep. The dishwasher drain hose is attached to an insinkerator disposal. By the way this dishwasher is only a couple of months old and we have had to have it serviced three times. No one has been able to explain the water accumulation and it can not be demonstrated unless the washer sits unused for a while.


... KitchenAid KUDS40CVSS Builtin Dishwasher

Whirlpool MBD121RF dishwasher. Fills and drains but does not wash (spray water - as far as I can tell). Nothing seems blocked. Both pump and timer are expensive to replace and the unit is 15 years old.


... Kelvinator MDB121RF Dishwasher

Maytag diswasher MDB6600AWW Sprayer arms don't spin. Dishwasher makes all the right noises, except for spraying. Water fills properly and heats up. Water drains properly. Found paper on the back of access panel. Ran Manual Function and Field Service tests, no problems indicated. Disassembled all the pieces inside the bottom of the dishwasher. No obviously damaged parts. Shaft for motor turns freely. It seems like the parts that attach from the impeller to the motor shaft don't


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

How does one remove the lower spray bar from a Kenmore 665.13832K dishwasher? I thought it just lifted up and out but this does not seem to be the case.


... Kenmore Dishwashers

The dishwaasher was not cleaning. the top and middle spray bars seemed starved of water. I removed the lower spinner and covers until I got to the pump cover and can't see how to remove the cover. I found bits of food and junk that were stuck on the intake. How to I get the pump cover off? I have found one screw but can't see how the clip in released.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Kenmore 13732 / 13734 / 13739 Dishwasher

RE: SIEMENS SE26230GB/12 DISHWASHER Machine runs for over an hour on both wash and rinse program - just seems to circulate dirty water around. Is there a filter other the accessable one which may be blocked thus inhibiting pump out?


... Siemens Dishwashers

The dishes on the top rack are not getting clean... Nothing seems to be blocking any of the spray arms... I have cleaned the dws interior. It quit cleaning properly about a month ago


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Whirlpool GU2400XTP Built-in Dishwasher

The rubber hose from the solenoid to the rectanglar shaped box on the side of the unit where the water goes into the unit. the rubber hose has water comming out when unattached for the side of the unit, however when reattached water gurgles and sprays out of the rectangular shaped box that takes the water into the unit. unit seems to operate fine, just leaks really really bad from the attachement point outside unit.....


... Whirlpool 24 in. DU927QWD Built-in Dishwasher

The pump doesn't seem to put out enough water pressure to turn the various revolving heads/nozzles in the washer - all washing heads are operable (ie unblocked) while the S shaped nozzle at the base and the small round nozzle at the top/ceiling of the cabinet do revolve slightly or slowly - but the two main nozzles spout water but not enough to revolve Is this a defective pump or a partially blocked pump ? - or something else - I have checked everything else and they appear to be functioning


It will be helpful to know the make and model number of the dishwasher to diagnose the problem you have.\015\012\015\012Generally this is attributed to a blocked chopper assembly in the wash circuit but hard to be sure if your model has o ... Dishwashers

When the cycle is finished the dishes arent washed, in particular the ones on the top rack. Ive removed the arm that carries the water to the top sprinkler to see if its blocked and it seems to be OK.The dishwasher is just over two years old and is an LG LD1415M......Thanks


Being from the US, I have not worked with this LG dishwasher, not any down under.\015\012\015\012But the first thing to do is use only a name brand dishwasher detergent powder. Don't use gels or tablets, ever. Many cleaning problems are resol ... Dishwashers

I took my top spray arm off and after unscrewing it there seems to be a black type of seal that was decaying inside and it was quite slimy. Do I need to replace this and will it work without it and where do I get a new one from.


... Fisher and Paykel 24 in. DS603H SS Free-standing Dishwasher

The dishes on the top rack are not getting clean... nothing seems to be blocking any of the spray arms... I have cleaned the DWs interior. It quit cleaning properly about a month ago


Hi you will need to remove the lower spray arm, then remove the filter and check the sump for any blockages. If nothing is found you will need to replace the wash pump. Normally if you clear the area around the chopper blade this will solve the probl ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1064 seconds