Having problems with your Karcher 2500 PSI Pressure Washer ?

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every

\015 2500 PSI pressure was used for about a year and then would not start again after being used 30 prior. I've changed out the gas and replaced the spark plug...still a no go. The spark plug is soaked every time I pull it out to check it....is this normal? Any suggestions would be great...\015

Answers :

Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every


... Karcher 2500 PSI Pressure Washer

I have a Troy Built 2500 PSI pressure washer with Honda 160 CVG motor. It won't start. I've replaced the gas and spark plug. Every time I pull the spark plug out it's soaked. Not sure


... Pressure Washers

Won't start I have checked the spark plug and I have good saprk. I have checked the fuel sysstem and the primer bulb injects fuel. I have removed the head and cjecked for engine damage and all cycle correctly. Vaves opne on time piston shows no dmagae. side walls are smooth and not damaged. This engine was working fine but the pressure washer needed some O rings replaced. I have tried to start it with and without the pump attahced. Evrything on the engine looks fine. I removed the spark plug and


... Briggs & Stratton Briggs Stratton 2550 Psigaspressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a mid 60's 6 hp Tecumseh engine on a Troybilt tiller. I used it to till my front yard and it ran fine. I let a friend use and it quit on him after a few minutes. It will not start. It has spark at the spark plug. I have thoroughly cleaned the carburetor by taking it apart, soaking it in cleaner, blowing out all holes and passages. I made sure the tiny holes in the power valve at the bottom of the fuel bowl are open. I have taken this carburetor apart five or six times over the years an


... Karcher 2500 PSI Pressure Washer

My Maytag dryer blower and drum won't move...I re-plugged in the dryer and the plug-in sparked and then it the dryer stopped working...Is there a fuze to replace ?


You have a dead short to ground. ... Dishwashers

My 580.752000 pressure washer now starts and immediately shuts down. It is as if it is full choked and stops due to over rich. Sooty spark plug and muffler replaced. Also new carb installed. Still problem persist. Possible cause?


Craftsman Model No. 580.752000 pressure washer idles fine but the engine stops immediately under load. ... Craftsman Pressure Washers

I have a Baldor 6000W generator with a gx340 11hp engine. I have drained the tank and carb and put new gas and sea foam in it. Also I have replaced the spark plug and fuel filter. The engine will start/run as long a I spray starting fluid in the carb. But it will not continue to run without it. Also I just checked the oil level and that is good. Please help!!!


It sounds like the engine is not getting enough fuel for it to run. First check that you have the fuel tap in the on position. If the fuel tap is on then the carby might be blocked or the needle & seat are not working properly. Turn the ... Honda 8 HP Engine

Hi my scorpion squirt pressure washer won't start spark but no fuel at spark plug fuel is going into the carby


... Pressure Washers

HOW DO I FIX MY HUSKY MODEL HU80520 PRESSURE WASHER, IT WONT STAY RUNNING AFTER REPLACING THE SPARK PLUG? WHAT IS THE RIGHT SPARK PLUG FOR THIS UNIT?


... Pressure Washers

Dishwasher 66513752K601 keeps blowing the thermal fuse. (Bi-Metal W10258275). I have replace the Thermal fuse several times. After i replace the fuse for some reason after a few months or less it will blow it out again. I have also replace the front panel assembly after it stopped working correctly. I would like to know how to test the dishwasher to find out the root cause of the fuse issue. I don't want to be replacing the fuse every time and don't have the $$ to buy a new dishwasher. Everythin


... Dishwashers

Model EXVRB2321 would run only with full choke, now wont start after cleaned carb,tank,what is the plug gap,I got a champion EZ start5843spark plug, replaced fuel line pvc boot, getting juice to plug and compression is 60 to 62 lbs psi.


... Briggs Pressure Washers

G851 SC Plus started to trip GFI plug. Called Miele and they said there was nothing wrong with the dishwasher and the GFI was faulty. Unplugged from GFI and plugged into regular plug and it worked for a few days. Eventually stopped running. How wrong Miele was, it had everything to do with the dishwasher and not the GFI. It was only warning me a problem was coming. Appliance man came out, noticed water in bottom pan and order new pump, said seal probably gone. Came back, replaced the pump, put d


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

No fuel to spark plug


Hi have you checked all the fuel line inc filter for blockages regards ... Honda Pressure Washers

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

My indesit DIF 04 dishwasher has stopped working the start button, soak button and eco wash buttons are flashing continously, the machine will not turn off I have plugged it out from the socket but once plugged back in the same lights start flashing again


... Dishwashers

Engine starts, but when i push in the choke, it kills. i just replaced the spark plug, drained the gas and oil and replace with new gas and oil. Starts fine when choked, but when i push in the choke, it dies.


... Honda 50 W Ar Pump 2500 Psi 25 Gpm Pressure Washer

Pressure washer will not start, cylinder has fuel in it. i think it was filled with diesel. i change the fuel, and the spark plug. still no start. if i spray it with carb or brake cleaner it runs fine.


Pull the fuel hose from the carburetor and let some drain out. Drain the carburetor float bowl. Are there H an L mixture adjustments? Preset each 1-1/2 to 2 turns CCW from CW stop. Get it running with spray if you have to, then adjust the mixtures fo ... Pressure Washers

Growing dishwasher i just replaced my disposal and didn't realize that i had to knock out the dishwasher plug until the dishwasher wasn't draining. i popped the plug out and the dishwasher drained, but now won't stop growling. i tried to re run the load but it's like it's stuck in drain mode now. help please


Ok i will tellyou the secret. your unit is in drain mode .there is water in the base of your dishwasher and it has to dryed out to come out off drain mode. when you dryit then hit cancel and the unit will work. to get the water out you have to take ... Bosch 24 in. SHX36L05UC Stainless Steel Built-in Dishwasher

Will not fire.blower runs.have 120voltage.to all switches blower and ignition sparks blue. I think its a no fuel problem what can stop fuel flow


Empty tank. ... Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI

KitchenAid dishwasher: KUDS01FL - I have had to replace the fuse every year and now I can't even get through on cycle with the fuse going. It is now dead again! It almost makes it through the full cycle and then stops (fuse blows)- no power - and there is some water left in the bottom which I have to physically remove. I spent a fortune on repairs every year since I bought it and would like to try to avoid another charge. I appreciate any help that you can offer. Thank you, Carol


I would check the pump. It may be slightly jammed or have debris which is causing it not to fully move or cause it to move very hard popping the breaker. Also with a jammed or broken pump, that can also cause water to be left in the bottom of the mac ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Stored for a year. i changed the spark plug and the fuel. i also cleaned the carb. water runs through the pump. but it wont stay running. it wants to start but only runs for a few seconds. i think it might be a fuel flow problem but im not sure.


Sounds like the float my be partially stuck closed. It allows enough fuel to run a few seconds then the engine uses it faster than the float lets the fuel back in. I would remove the float bowl and flip the float up and down a few times to make sure ... Honda Pressure Washer PSI 3000

After replacing my garbage disposal, my dishwashr stopped working. I did forget to remove the stop plug from the disposal unit. But even after doing this the unit still does not work. It does turn on but no water drains out. In addition when using the sink it appears that some water may be getting into the dishwasher.


The drain line from the dishwasher MUST be secured HIGHER then the drain port in the disposal.If this is not the issue,the dishwasher drain solenoid is not functioning correctly. ... GE Nautilus 24" Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0847 seconds