Having problems with your Karcher 2500 PSI Pressure Washer ?

Karcher K 2400 HH Psi pressure washer shoots water out of the chemical tube

\015 When pressure washer is on, water shoots out of chemical tube.\015

Answers :

Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Karcher K 2400 HH Psi pressure washer shoots water out of the chemical tube


... Karcher 2500 PSI Pressure Washer

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

Water shoots out intake - Karcher 2500 PSI Pressure Washer


... Karcher 2500 PSI Pressure Washer

I have a Karcher K2.65 Deluxe pressure washer. All connected up, turned it on but I have low pressure out of any of the attachments and water splashing out of connection between gun and extension tube


... Pressure Washers

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

I have a 3000 psi karcher pressure washer with honda engine, the problem is for a while the pressure would kick in and out, now only water hose pressure, the water supply is fine, what is the problem


Sounds like you need a seal and bladder rebuild < if you liver in a cold environmet for winters please dont forget to winterize your washres every year before winter ... Karcher G3025OH Pressure Washer

Water leaking from body of K4 .130 washer - Karcher PSI Electric Pressure Washer


... Karcher PSI Electric Pressure Washer

Karcher 620m runs but will not pump water - Karcher 2500 PSI Pressure Washer


The pump that connects to the motor could be bad/and or loose ... Karcher 2500 PSI Pressure Washer

I have a karcher 2400 psi pressure washer and it doesnt get water pressurized when pulling wand trigger.


The most comon problem with thease is a stuck bypass valve, this is the valve that alowes the water to bypass round the pump when the triger is closed, when they stick all of your pressure runs around the pump and not out of your nozzle,,\015\0 ... Honda Karcher G2400HH-R Pressure Washer

Shooting water but no pressure-suggestions - Campbell Hausfeld PW1550 1550 Psi Electric Pressure Washer


... Campbell Hausfeld PW1550 1550 Psi Electric Pressure Washer

My Karcher gas powered 3100 psi pressure washer has a constant water flow pulsing


... Pressure Washers

I recently purchased a northstar 4000 psi pressure washer. I had the same series pressure washer for the past 6 years and used a downstream chemical unloader quick connect to pull chemical. I attached it to the pressure washer and it is not pulling. I havent modified anything and I dont want to pull chemical through my machine.


The injector might be worn out or have something inside of the valve causing it not to ****. If you are using a new high pressure hose or a longer hose this may also have an effect over the injector not working. ... Northstar Professional Series Pressure Washer 4000 PSI

Why chemical dispenser is shooting out water - Pressure Washers


... Pressure Washers

Water shooting from front of pump.i have a karcher 4000-G 1800 psi refurbished power washer


... Karcher G 2600 VH Gas Pressure Washer

Water pours out of the trigger when in use - Karcher PSI Electric Pressure Washer


... Karcher PSI Electric Pressure Washer

Water is coming out of the soap suction hose - Karcher PSI Electric Pressure Washer


There should be a ball check valve in the soap suction hose lets soap in keep water out poke a paper clip in the hole a few times soap will build up there and make the ball valve leak ... Karcher PSI Electric Pressure Washer

Water surges when you pull the trigger - Karcher 2500 PSI Pressure Washer


Not enough water feed would cause pump cavitation. It sounds awful. \012It sounds like you either have an engine that is revving up and down which will cause the water to surge. This is most likely a dirty carburetor. You should notice a distinct ... Karcher 2500 PSI Pressure Washer

Water coming from bottom of unit - Karcher PSI Electric Pressure Washer


You will need to remove the mainc cover and see where the leak is. It could well be either the inlet pipe or the main pump seals. ... Karcher PSI Electric Pressure Washer

I need 0 rings for Karcher 4000 psi pressure washer. Where can I find them?


... Karcher 4000 PSI 36 GPM Gas Pressure Washer G 4000 OH

Leaks water from bottom when I start it up - Karcher 1750 Psi Elec Pressure Washer


... Karcher 1750 Psi Elec Pressure Washer

Water shoots out of chemical injector hose on pressure washer


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Troy-bilt 2200 psi pressure washer


I have a Troybilt Model 2200 PSI Pressure Washer in which I have used only 2 times in the past 2 1/2 years. Went to use it this past weekend and the pump in not working. Water shoots out of the side. I bought this brand and model as I thought Troyb ... Pressure Washers

The Hom Model No. 308653045 gas-operated cold-water pressure washer has a spring-loaded control on it and I am assuming that this control regulates the output pressure of the water from the pump . . . for example, 1500 psi to 2700 psi. Is it correct to assume that this control regulates the output pressure of the pump. If the control is a pressure regulator, how does one use it and, EVEN MORE IMPORTANT, can one under-adjust or over-adjust the control to a point where THE CONTROL OR THE PUM


... Homelite Pressure Washers

I have the Coleman powermate 2400 PSI pressure washer and on initial start it sprays and has great pressure. But once I release the spray handle it will not spray again, not even one drop of water. I have verified water pressure, bought 3/4 hose, and also changed the spray handle with no help. Pressure washer was bought new at Lowes, but did not use for first three years of ownership, should have tested it. Thanks for any help on this. Ted Miller


Sounds like the valve in the handle is sticking closed. May have a broken spring, or maybe a part is stuck..\015\012I say take it apart, and the answer will present itself.. Play with it with nozzle out too... Maybe something is stuck after st ... Coleman Pressure Washers

I have a 3.91M pressure washer and it does not have pressure. Water runs through it but no pressure.Its a 1700 PSI


... Karcher K2.26 Electric Power Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1309 seconds