Having problems with your Karcher 2500 PSI Pressure Washer ?

Does it hurt a pressure washer to run hot water thought it went they hook up the water for outside to hook it to the hot water i did not no it and i hook it to the pressure washer


Answers :

Most pressure washers have packings that can sustain a temperature of 140 degrees although it as strongly not recommended since the pump head heats up when in bypass mode(triggergun closed)best rule for pressure washer is never leave the trigger closed for more than 3 minutes even with a thermal sensor:):)
Repair Help & Product Troubleshooting for Karcher 2500 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Does it hurt a pressure washer to run hot water thought it went they hook up the water for outside to hook it to the hot water i did not no it and i hook it to the pressure washer


Most pressure washers have packings that can sustain a temperature of 140 degrees although it as strongly not recommended since the pump head heats up when in bypass mode(triggergun closed)best rule for pressure washer is never leave the trigger clos ... Karcher 2500 PSI Pressure Washer

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

Northstar Hot Water Pressure Washer (model #157322) While using the pressure washer the safety relief valve activated venting steam and hot water from it... I immediately shut it down and let it cool down. After it was cool, I turned on the water supply again and the relief valve was still spewing water from it. My neighbor said it was probably the "unloader" valve was stuck or damaged. I called around my area and it seems as though no one services my pressure washer.. Is there a manu


... Pressure Washers

Water pressure? I read somewhere that low pressure of the incoming water will make it so that the items on the top drawer will not be as clean. I don't see how this can be the case, as I thought that the way the washer worked was that the washer filled (at whatever speed) and then the machine itself pumped the water through the system at the appropriate pressure. Please clarify.


Mom...not true. The water fills the machine which then uses its own pump to spray the dishes with the water/detergent. If your dishes are not getting clean, use the recommended amount of detergent. Hard water will require a spot treatment like Jet ... KitchenAid KUDR01TJ Dishwasher

I have a Comet BXD 2525 G pressure washer pump which is giving me some problem. (Maybe) I hook the water up to pump and the pressure hose up to the pump, turn on the water and the water sprays out of the water connection at the pump. I check the hose to see if it was clog ok and the next was a the water connection ok. It's like the water is not going int the pump. When i start the pressure up the water come out of gun but no pump running like it should. The next thing i was going to look at i


The water inlet needs a gasket like all hose connections. If its gone the pump may be starving for water. ... Comet Pressure Washers

I have a Honda gc160 5.0 pressure washer. All fluids are fresh. Water is hooked up with plenty of pressure but the water pressure is up and down then goes completely out. No water will come out of the wand? Please advise. Thank you.


Needs new pump ... Karcher 2500 PSI Pressure Washer

2-yr old troy-bilt pressure washer with honda gcv160 engine. seems to run well, but when trigger is pulled get full pressure for less than 5 seconds before reducing to house water pressure. when left running, looks a black plastic pressure relief valve starts blasting hot water. appreciate whatever insight you can give. Thx


It sounds like an air lock. Try this: With the machine off, connect the hose to the washer and let it run for several minutes to get all of the air out of the hose, and to purge any air out of the pump. Shut off the water, and connect the high pre ... Briggs & Stratton Pressure Washers

No pressure Hi we dont seem to have any pressure in the washer can u tell me what is wrong..ie is it a prob with the pressure washer or water pressure from the outside tap.


... Pressure Washers

We have a Pressure washer 2600 PSI it is hooked up to the water line and we have a bucket of mix of 50% bleach and 50% water there is no suction coming from the line into the washer to mix with the water Why?


You need a soap nozzle to lower the psi is call downstream injection. ... Electric Pressure Washers

Hotshot over heating - PressurePro Pressure-Pro Hot Shot Series 4000 PSI Hot Water Pressure Washer


There r three devices which can cause overheating.1)-thermastat(stuck in close circuit2)-pressure switch and or flow switch stuck in close circuit. 3)-fuel solenoid stuck open located at fuel pump ... PressurePro Pressure-Pro Hot Shot Series 4000 PSI Hot Water Pressure Washer

Need a service manual for a hotsy 981ss hot water pressure washer


... Pressure Washers

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Two problems please: craftsman 2150psi briggs and stratton engine washer, will not start when hot. and secondly, i was washing with regular pressure, then noticed a pressure drop at the nozzle, then the unit shut down. no water leaks at the manifold. water supply was strong. any ideas?


Nozzle dirty, clean out with small diameter wire. ... Pressure Washers

I have a northstar pressure washer hot water. they say the coil is no good anymore. Is there a way to bypass the hot and go only cold water?


... Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI

Hot water coming out of a cold water pressure washer


This sounds like a heat transfer problemYou should check that the oil reservoir for the pump has oil in it. It sounds like it may be low. Also, if it is a gas model, the engine oil may be low. Remember the pump oil re ... Porter Cable Pressure Washers

Does my Karcher HDS580 hot washer need pressured water or can it draw water?


... Pressure Washers

Troy Bilt pressure washer 2600psi. Engines running fine with supply line, wand, and pressure line hooked up but no water or pressure is coming from pump. pressure line is limp. What is the problem?


... Troy-Bilt Pressure Washers

Low hot water pressure in old whirlpool washer forever to fill


If you have verified that it takes longer than 120 seconds to fill with water then you need to replace your inlet valve. You might be able to get away with just cleaning the screen but you should probably replace it. pn 8531670.\015\012However ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

I have a Sears (Briggs) 2550 washer mod # 580.752190, has been working great but when I got it out last week it wouldn't start with the water on, I turn the water off bleed the pressure out the wand and it started and ran great, I thought it might be the relief valve, I removed the valve turned on the water, a big stream was shooting out the hole where the valve goes, I started the engine and it ran but sounded like it was about half loaded. where do I go from here ? Thanks.


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have abrand new Black and Decker 1900 psi pressure washer. When I hook the water hose up to the machine and turn on the water, water sprays out out of the bottom without the machine being turned on. Thank you


... Pressure Washers

No water I have a sears pressure washer. I hooked up the garden hose and pulled the triger with the engine off. No water. I disconnected the spray gun hose, were it connects to the pump.Turned on the hose,no water.Could the pump be cloged?


... Pressure Washers

My honda pressure washer doesn't build pressure and the water gets hot


... Honda Pressure Washer PSI 3000

Brand new Northstar hot water pressure washer, 2000 psi, electric and Diesel fired burner. The burner will not come on??? It works ok as a cold water unit but the burner will not fire even with the Heat switch on and fuel in tank?? What could cuse this?


... Northstar Wet Steam & Hot Water Pressure Washer with Honda Engine 3000 Psi, 4 Gpm

Husky 500 2200 psi. starts and runs ok, but no pressure through the wand. hooked up garden hose to power washer turned water on and it comes through the hose ok, but start up and put wand on and no pressure.


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1757 seconds