Having problems with your Karcher G3025OH Pressure Washer ?

Water wont turn off on handle sticking on trigger feels like there is no spring


Answers :

Purchase a new wand from your home center.
Repair Help & Product Troubleshooting for Karcher G3025OH Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water wont turn off on handle sticking on trigger feels like there is no spring


Purchase a new wand from your home center. ... Karcher G3025OH Pressure Washer

Door panel comes apart by about 1/4" of an inch everytime I pull on the handle,it feels like the stainless steel panel will separate from the door but it is only loose. there are a couple of springs inside the door but there are no screws or latches to adjut, is there a solution for this problem?


The dishwasher door generally has issue because of the Latch/Spring/hinges/door seal going bad. \015\012 \015\012In your case as you are referring to springs at the inside of the door, I would like to tell ... Miele Incognito G818SCVi Built-in Dishwasher

The handle on the door popped loose and feels like a spring was broken. how do I fix it?


... Maytag 24 in. MDB8750AWS Jetclean II Built-in Dishwasher

My ds603 wont work ... i turn it on press start it gives a beep but nothing happens, then the display will turn off ? I have also noticed that when i oren the drawer it doesnt turn on automaticly like


... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

If while pressure washing I let off the wand trigger it looses pressure and I have to turn of the washer motor and wait for the pressure to return.(seems like some kind of vapor lock problem)When the pressure returns I hold the trigger and restart the washer. If I let off the trigger we go through the same process again. this is a g3050


Hi and welcome to FixYa, I am Kelly. \015\012 This is most often caused by the bypass / un-loader valve located on the high pressure output side of the pump. The valve will either have a stem type valve with a knurle ... Karcher 2500 PSI Pressure Washer

I have a bosch 110 plus pressure washer the problem i have is i turn on washer squeeze trigger and works fine when i release trigger and press again it wont work and trigger seems to have pressure on it


... Bosch AQUATAK 110 Pressure Washer

Hotpoint dishwasher FDL570G.R is filling with water but wont wash the dishes,we've checked pipes,cleaned filters etc. but still wont work.It makes noise like its heating but wont do anything after that,it will just drain when we turn it off. It is only 4 months old.


... Dishwashers

Trigger Stuck When I turn on the water it shoots out and won't stop. There is no pressure with the trigger. There is a small metal pin that seems to stick everytime I apply the trigger. I have tried W-D but no results yet. HELP Steve


... Northstar Pressure Washer Trigger Spray Gun 4000 PSI, 8 GPM

Husky Powerwasher 1800 Handle trigger springs


... Pressure Washers

Candy CDI1012 start button will not hold down, so I can't start the dishwasher. (feels like no spring in the button).


... Dishwashers

The trigger handle lost it's spring


... Homelite 308760019 Trigger Handle

Troy bilt 2600psi 2.3gpm model 160 pressure washer, I hooked everything up like normal, It cranked up fine, when I pulled the trigger on the gun it stalled. When I try to crank it back up the cord wont even pull like its stuck any suggestions would really help me tks..


This sounds like the pump has dead headed. I.e. the unloader valve is sticking. Unhooking all of the hoses should eventually allow everything to free up. Once it is free what you should do is add about 3 ounces of oil into the water inlet connecti ... Pressure Washers

Last night I turn on my dishwasher adl 945. It started to work but after few minutes i noticed that the dishwasher stoped and it looks like in the middle of program. Now the dishwasher wont even to turn on. Do you perhaps know what is wrong? .


... Dishwashers

I was replacing the hose and a little spring popped out of somewhere. The spring has a clear plastic end also. The whole thing is about an inch and half long. I believe it goes with the yellow trigger handle but cant find where it goes


... Karcher K2.26 Electric Power Washer

I was using the washer and it was running fine for a couple of hours and then it quit like there was a current sensor or something tripping. I would turn power on and press trigger on wand and then it will run for a few seconds and then quit again. I have to turn the power swich off then on again and then it does the samething.


Your preasure regulater ,remove and clean you will be back in action ,can I borrow it to clean my shop.lol ... Northstar Electric Wet Steam & Hot Water Pressure Washer 1700 PSI

When triggered, the handle of the pressure washer will often not engage the water/pressure. At other times after using the pressure washer for a while if you release the handle to give your hand a rest often it wont restart again.


... Honda Pressure Washer PSI 3000

Bosch wont Hello i have a Bosch DLX Series dishwasher and i put it outside and covered it while i did my kitchen remodel.. 6 months later kitchen is done and i move the washer back in. It turns on and it sounds like its running but it wont take in water from the hose. which is on and connected. any suggestions thanks very much...Steve


Faulty inlet valve or water in the bottom tray which will activate the float swich and pump out any water. See that this moves up and down freely. Turn electrics off first. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Just replaced the white plastic in-setting of the top sprayer that was broke and while i tightened the "nut/screw" that keeps the spray arm up there it almost feels like it is too tight to turn freely. Should I oil it with something or is there some other reason that it is not as loose as i think it should be to turn (which it's not during the cycle)? thanks for any help.


... Champion 24 in. UH-150B Built-in Dishwasher

Hi I have a brand new Honda Power washer GC 160,2600 psi 2.3 GPM my husband taught me how to use it last night and I think I have followed all of steps: 1. hose free of kinks 2. connected to machine 3. purged pw handle of air and made sure water from house coming through 4. pulled out choke 5. turned red button to "ON" position 5. pulled T handle enging starter and it sounds like it will start but doesnt what am I doing wrong??? yes it does have gas in the fuel tank.


... Karcher 2500 PSI Pressure Washer

Hy; I have a karcher 580 I had to replace gun complete so I bough a simoniz xe01-001 at simoniz.osirus.ca/ for your info 69$ complete ***.I install NOW I get pulse up & down ONLY when trigger is press I turn valve down i only get 10% of pressure if i turn valve up that is when it start pulsing pressure up & down it wont keep pressure up ... Bob...


Most likely problem is that the tip is too small causing Unloader to bypass or restriction/debris in tip. Install clean tip of proper size or 1/2 size larger (example from 2.5 gpm to 3 gpm ) to prevent slow pulse. If tip is clean and /o ... Karcher 2500 PSI Pressure Washer

I tried to repair my karcher spray gun. I have a small spring and a small white plastic piece which the spring fits onto to find a home for. I'm sure its to do with the trigger handle but I can't see where it fits. Can you help, a diagram would be helpful.


... Karcher Pressure Washer Gun 91120200 91120200

It wont start . not been used in over a year. used 3 times. it sounds like it will almost turn on but not turn over


... Honda Pressure Washer PSI 3000

No water pressure. feels like it is developing pressure in the pump but wont deliver more than a small stream and then enging cuts out like it is bogging down


Sounds like it could be just a main jet bloked in your lance. Please remove the jet and see if you have a good water flow when pressing the trigger. ... Honda Maxus Prosumer MX5223 Pressure Washer

DISHWASHER WONT GO INTO WASH CYCLES,WHEN I PUSH START GOES CANCEL/DRAIN,CAN HERE PUMP RUNNING THEN IT WILL TURN OFF,THERE IS NO WATER IN THE BOTTOM,SEEMS LIKE STUCK IN DRAIN CYCLE


... Whirlpool GU2300XTS 24 in Builtin Dishwasher

I have a dishlex dx203 dishwasher wont turn on.. Like the lights work but it will not actually start up?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1316 seconds