Having problems with your Karcher K238CCK 1600 PSI 13 GPM Electric Pressure Washer with Car Care Ki ?

I have karcher k 2.3 i got the problem of my unit (power switch) and i already fix it but the problem is the oil i need the no. of the oil and amount to put a new oil. thnks!


Answers :

Repair Help & Product Troubleshooting for Karcher K238CCK 1600 PSI 13 GPM Electric Pressure Washer with Car Care Ki

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have karcher k 2.3 i got the problem of my unit (power switch) and i already fix it but the problem is the oil i need the no. of the oil and amount to put a new oil. thnks!


... Karcher K238CCK 1600 PSI 13 GPM Electric Pressure Washer with Car Care Ki

Am15 dishwasher problem: The pad will only turn on and off. Can't get it to cycle. Was on cycle 4 needed cycle 1. Got it to cycle 1, but now on and cycle does not work and when I push the off button it reboots to on. I put new pad on thinking it was the pad but same problem. Question: Is there a way to reset the board? should I be looking some where else? I cut the power at the breaker box to see if that might reset with no luck.


... Hobart AM15-2 Dishwasher

TV static I just installed a new dishwasher. When it is running, it causes static lines on the TV. Prior to the new dish washer, I did not have this problem. It is wired correctley, and not on the same circuit. As I stated I did not have this problem until the new dishwasher. I called the service people for the dishwasher, and they stated they could not help me. Have you got any ideas, or do they make some type of filter I can put on the line to the TV.


There should be a suppressor fitted to the mains terminal block on most dishwashers. if this is not the case you will have to get hold of one you plug in. regards ... Dishwashers

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

Dishwasher will not fill with water. I've already checked the float assembly, that seems to be working fine. The water just doesn't seem to run into the machine. Little history on an unrelated problem: I want to mentioned that not to long ago my brother tried to put a bunch of celery through the garbage disposal. The sinks and pipes got all clogged up and we had to take them apart to clear up. Immediately afterwards the dishwasher stopped filling with water. I don't see how the two can be r


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher ... GE 24 in. GLD5500L Built-in Dishwasher

I borrowed my neighbor's Karcher Model G 2650 OH (it's several years old). It had the yellow tip already on, but after awhile, I took the tip off to use a different tip,and pulled down the brass coupling at the end of the wand to insert the new tip. The problem is that the brass coupling at the end of the wand won't snap into place around the tip -- so I tried another, and another. No luck. And now the original tip that was on the wand won't snap back into place. HELP! I need to get my neighbor


... Karcher Pressure Washers

My 1750 huffy power washer was hard to get water pressure for about 10 minutes, once the machine was putting out pressure i noticed it was leaking oil from the bottom of machine need help with the problem


There is sticking valves in the pump ... Pressure Washers

Model idl530.just put new drain pump on and worked ok for two short cycles.now it will not run up at all .got one of the green lights flashing ,seems to me problem with main motor


... Indesit Dishwashers

Cloudy residue My dishes all come out with a cloudy residue that wipes off. There is plenty of rinse aid, and I'm not putting more than the recommended amount of dishwashing compound. It is a new washer, and was only installd 3 months ago. What is the problem?


The modern dishwashers dont use as much water as the older ones did,most common problem is the water temp. its a good practice to run your sink fauset in your kitchen until the water gets hot then start the dishwasher. now when it fills the water is ... GE Dishwashers

Got new camshaft for 5 hp honda motor need to know how to set timing to put belt back on thanks


Is that engine not push rod ... Honda Pressure Washers

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a 1994 3005 super hot pressure washer made by mi t m corp,i had pics of my thermostat system but my computer crashed i have a new gauge and probe ,module,and thermal stat i need to find a repair manual so i can put it back together,also i get pressure and then i lose it .is this my valves or unloader problems?


... Mi T M Mitm 3500 Psi Hotcold Portable Gas Pressure Washer

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

SMEG STX dishwasher does not complete the wash cycle, stopping after 3 minutes on all cycles displaying error code E1. The machine seems to start with the usual whirring noise but then stops after 3 minutes without pumping in water. The machine is a few years old now but has needed 2 new control panels already although this does not appear to be the problem this time. Any suggestions? Thanks DW


... Dishwashers

I just purchased a RMV2.5G27D Universal pump. Installation was easy, but I have two questions. 1. No where in the booklet does it say to put oil in it, does it come with oil already inside? There was no oil in the box but the instructions kept refering to 2.2 ounces of oil. 2. It had a red plastic plug opposite the water intake, included was a brass plug that fits into that area, does the plastic plug stay or do I put the brass plug in it?


The red plastic plug comes off, that is the plug that is only used for shipping. You should have got a ventable oil plug to replace that one in the box. The oil you would need is this ... Annovi Reverberi RMV2.5G27D Pressure Washer Pump

I have a Bosch dishwasher, model #SHU43C02UC/14, which has stopped working - no water enters the inside nor is there any drain cycle - just nothing. At the same time, I had to have the new control board put in as part of the Bosch recall. The tech comes out, puts in the new board - still nothing. He says something is wrong with the board even though the problem existed before the new board was installed. He takes everything back to his shop and tells me he's trying to contact Bosch tech support


... Bosch Dishwashers

I have been interacting with Daniel about my Dishwasher Smart Dispenser problem. The last thing he had to say to me was that I needed to replace my drain pump. Before doing this, I would like an explanation of why a new drain pump will solve my problem since my dishwasher is draining just fine...it is my Smart DIspenser that is clogged up and not working ?? See the discussion here: Dear go4t9ers, There is a new Comment for the I would like to run the Smart Dispenser Purge Solution on


Ok first this is the schematic for your entire machine http://www.s ... Dishwashers

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

IDL750 - Fuse trips when turned on. HELP! We had some electricians here to install a new electrical socket for a new fridge. They put the new socket in the same wiring as for my existing dishwasher!! The first time I tried to start the dishwasher cycle with the new fridge plugged in, the circuit box fuse tripped. Now, even with the fridge turned off, the dishwasher makes the fuse trip when turned on. Is there a fuse inside the dishwasher that has blown and needs to be replaced? or a ground brea


Hi.The first step is understanding if the problem is the socket or the appliance. Find an extension long enough to reach a different socket. Move the appliance to reach the power cord, and connect the dishwasher to a different power sock ... Indesit 24 in. IDL700 Built-In Dishwasher

I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.


You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer

Hi i have a diplomt adp 8324 dishwasher the problem i have got is when i put it on a normal spin wash it starts ok then cuts out with an error code saying el1 its also got 3 wavey lines with a x across it i havent got the manual for my dishwasher could you help me please. than you lee


... Dishwashers

We have a model GU1200XLT1 dishwasher. For over a year, we have a problem with debris being left on the dishes/glasses. We got sandy like debris in the left front section, top rack, after it has cycled. Mostly on the outside of whatever is in that part of the top rack. How do we get rid of this debris problem? Is there some filter that needs to be cleaned? We also have problem with mold/mildew inside dishwasher. I have cycled it with bleach, ammonia, or vinegar, which temporarily sol


... Whirlpool Dishwashers

Pressure washer will not stay running. Have put in new fuel, new plug, new oil. Will not start until I spray some ether in carb, then it will start and run for about 3 seconds, then stall. will not restart without another shot of ether. What should I try next? thanks


... Briggs & Stratton Gas Pressure Washer 20244

Im having a problem desiding how to hook my drainage pipe up from the dishwasher i cant put it next to the sink cause theres no room so i have to put it on the other side of the kitchen could i connect new pvc pipe to the drainage pipe underneath the floor or do i have to put it above the trap


You can put a new verticle pipe up from under the floor and put the drain hose in that. make sure the vertical pipe comes up to about worktop level and make sure there is a water barrier in it or you will get a nasty smell ... Dishwashers

2000 epw Northstar Item # 157942E 230v 2000 psi 3.5 gal/min #5 nozzle Problem: No pressure. Motor running...seems to be in bypass. Checked starter...but not finding power to the pressure regulator. May need a new starter/relay/contactor. Was working fine..May wish to order a starter and a possibly a pressure regulator...I have photo's of the complete set up if needed. Need to know part numbers to order and what company to order from. Thanks, Greg Scott


... North Star Stainless Steel Under Car Cleaner 16in
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1062 seconds