Having problems with your Karcher K 391m Pressure Washer ?

I have lost the pressure of water but the motor is still working.


Answers :

If the motor was ran without the water being attached to the washer it would crack the pistons which is what creates the water pressure for you.
Repair Help & Product Troubleshooting for Karcher K 391m Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have lost the pressure of water but the motor is still working.


If the motor was ran without the water being attached to the washer it would crack the pistons which is what creates the water pressure for you. ... Karcher K 391m Pressure Washer

My Karcher K2.36 stopped working. I had been cleaning the pathways and with no warning, no peculiar noises, etc the unit motor stopped working. The power was connected, the water was still coming from the wand albeit at low pressure. Thanks.


... Karcher Pressure Washers

Something is causing the DW motor not to fire (so water is not sprayed around). It fills fine. It drains fine. I've tested the motor - it also works. I've tried all the various cycle choices; all do the same thing. Water fills but is not pushed around the tub (absolutely no motion from the motor, whatsoever). There was some debri down in the bottom, but I've cleaned it all out, wiped everything clean, and still no motor activation.


Clean pump and spray arm holes and any filters...you may need a pump kit if you see damage in your pump ... Dishwashers

Hi- I have a Simoniz S1600 pressure washer and usually when I first turn it on, the motor turns on to build up pressure. Now the motor won't kick in no matter what I do. Water still comes out of the gun as a small stream but there is no pressure. There are no reset buttons on the exterior of the machine. Thanks!


... Pressure Washers

Pressure poor After stripping the water side of machine everything seems to be in working order, I have checked all valves and orings and the central water drive. The pressure hose and bayonet orings are ok with no leeks. Everything seem to be ok but still very poor pressure.


... Pressure Washers

Pressure Washer I have a Porter Cable pressure model no.PCH2401.It works fine for 5 minutes,then I can hear the motor loading down and then it stalls out. I tried to start it and it was very hard to pull on. disconnected the water supply and if was very easy to pull and started right up. I noticed the pump was very hot.This unit has a thermal relief valve on it,shouldn't it have released when it gets to a certain temperature .I was thinking maybe this is why it might be shutting the motor


Any leaks from connection at pump to gun and wand assembly if so the valve is detecting leakage and open up again without u squeezing trigger it builds up in the head.if your trigger gun is leaking internally then you will need to replace the gun thi ... Pressure Washers

Hi. We have a Bosch 4072 6301 which is about 9 years old and has always worked well. Recently is has begun to leave dishes unclean, particularily on the top shelf but also on the bottom. I have checked the water jets for blockages, checked the drain (as far as it is accessible). The heating element stills works as there is steam when the door is opened. If I open in the middle of the cycle I can see water coming out of the jets correctly, I can't tell if the pressure is correct. Any th


... Bosch 24 in. SGS4072 Free-standing Dishwasher

Dd603h my bottom drawer will not take in water - the top works fine. when i change motor the top still works fine and the botom still has a problem. it displays a watertap with a line over it sincerely - jesper sorensen


The watertap with a line means the inlet water solenoid is faulty.\015\012\015\012YOu will have to replace it with this par ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

I have GE GSD2300r00bb, it was working just fine the other day no unusual noise, today we tried to run it, just a little bit into the cycle, i heard a strange stalling noise that sound like the motor is stuck or something, i put a camera(in a ziplock bag) in the dishwasher to see if the blade is spinning, no spin, the water did squirt for about 1 sec then stop but still leaking out somewater. Is it the motor or the water pump. I just got this dishwasher about 1.5 yrs. Is this something i can fix


... GE GSD2300RBB Builtin Dishwasher

I have a maytag dishwashwer DWC7602AAB, Made terrible noises wouldn't do anything but spray alittle bit of water in the bottom and that was it. Purchased a new motor, still didn't work and just replaced the timer and still not working help


... Maytag 24 in. DWC7602 Free-standing Dishwasher

I have a Karcher 3.99 Pressure Washer. The motor appears to be working and water is passing through the machine when turned to the detergent application setting. However when the lance is tightened to turn on the pressure, no water is coming through. The Karcher is just over 1 year old David


Hi I have a karcher 3.99 the motor comes on and water comes out however thre is no pressure i have tested the lance on my brothers washer and this is ok what is wrong ... Karcher K 5.85 M Electric Pressure Washer

Kenmore Dishwasher doesn't rinse? It sounds to be working fine, however, at end of cycle, dishes are still dirty, and the front door on the inside is still dirty. Obviously there is a problem here maybe with water pressure or something. There is steam at end of cycle, can't tell about water other than that.


Try opening the dishwasher during the wash cycle stop it and open it if water is in the bottom it is filling whn you open do 1 or 2 times to check to see if spry arms are spinning if they are check to see if soap dispenser is working also use dishwas ... Kenmore Dishwashers

My tappan dishwasher is only 1 1/2 yr old and its not getting at least 1/2 of dishes clean. We have tried everything from changing to liquid soap, increasing water pressure at meter, not using while washing clothes. We used a dishwasher cleaner to remove calcium, and run hot water in sink before using. We know the wand, pump and drain are working. It is model TDB210RFB5 with 1.1A motor. Is the motor too small to clean dishes? I wish I could get my money back or exchange for an upgrade. Thanks!


... Electrolux Dishwashers

On an AEG Favorit 64570 VI we have an error 20. Manual indicates a drainage problem, however when we pour in water, it gets pumped out without a problem. No obstructing in the exhaust tube. Next we checked the pressure sensor, by taking it out and blowing into it. It clicked as pressure was applied to it, so the inner switch worked. Everything is clean, but still we get an error 20. What does seem strange is that the appliance does not take in water. Any suggestions are welcome.


... AEG 23 in. Favorit 86070Vi Built-In Dishwasher

Champion dishwasher we have a champion freestanding dishwasher at my church. after the cycle is completed, the pressure guage behind the washer still shows 25-30 and it contnues to spray water. not forced by the motor, but more like a stuck open fill valve. if i turn off the water and run it, then turn the water back on, the valve is closed and does not let water freely in. butif i run it with the water on, it will continue to spray in freely after the cycle light goes out and you open the door.


If you turn the unit off from the circuit breaker will the water still run?if so the guts inside the solenoid valve are worn.you can call champion and get a kit to replace the worn parts and its not difficult to do.hope this helps. ... Dishwashers

I have a Frigidaire dishwasher and there is not any water coming out of the top wash arm. There is good water pressure coming out of the lower washarm. I pulled out the dishwasher and can see the water going to the top washarm through the tube and it goes up very slowly. I took out the "check ball" below the lower washarm and it worked good. I put the "check ball" back in and ran the machine on "Upper Rack" and it still does not have any water coming out of the upper washarm. It doesn't seem lik


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check that there is no gunk or mold\015\012behind the filter screen and under the cover at the bottom. N ... Frigidaire PLDB998A Built-in Dishwasher

Maytag MDB 4000 AWB. Not cleaning. not getting water now. pressure was low when i was getting water. . Soap dispenser would not open as well. I replaced the motor on the soap door. cleaned the float switch. Tested continuity and cleaned out water inlet valve. Still not getting any water


... Maytag Dishwashers

Hi I have a Troy-Bilt Pressure washer 2200 psi model 20292. I've used it only 4 or 5 times. It ran great for an hour today then it lost pressure. Seems like the pump is not working. The engine runs fine but no pressure. The water runs through the nozzel and I blew air in the lines to make sure there is no blockage and found no blockage even in the pump lines. Any ideas. Tom


... Briggs & Stratton Gas Pressure Washer 20244

I have a model PW 2200 gas pressure washer. It suddenly lost it's high pressure the other day after working fine for @10 minutes. It's getting plenty of water, but the engine doesn't seem to rev up to give it the high pressure. The operating instructions say to check the oil in the engine, and the PUMP before starting, but I haven't found any place to check for an oil level in the pump????Any ideas, I'm very confused.


... Pressure Washers

Dishwasher is not getting water. The motor runs, but there is no water going in. Was doing it once in a while, but now all the time. I ordered and replaced the water inlet solenoid / valve thinking that had to be it, but wasted $45.00...still doesn't work!


Does valve make noise . water to valve ? ck float may be stuck something under it or switch under float ... Kenmore Dishwashers

Follow-up I've removed the lower arm, I'll spend some time and see whether I can get the pobem sorted out. My wife noticed the the detergent was smeared all over the door and repeated tries didn't get it out. Therefore, the water is not spraying. I can confirm the water is filling on the bottom and draining. The heater is working well. I am thinking there is no pressure to send the water through the tubing to the upper and lower arms. The motor is hot to touch (118 degrees with my temp probe). I


... Kenmore 24 in. 15199 / 15194 / 15192 Built-in Dishwasher

Homelite UT80720 motor works, won't produce pressurized water


... Homelite Pressure Washers

We live on an island in the Caribbean and we have a LG dishwasher (model LDF 8812) that has worked fine for a year, but has recently stopped washing effectively. At first, the top part dishes were coming out still soiled from food. Now the bottom part dishes are coming out soiled as well. We checked both the Owner's Manual and the Service Manual and none of the troubleshooting suggestions appear to be relevant to our problem. The water here is very hard, and the water pressure is low and fluctua


You really need to replace the O ring . Could cause leaks and low wash pressure without it.You may also try running a solution of WHITE vinegar and water through the machine every six months as it helps desolve any lime scale (which is going to ... LG LDF8812 Stainless Steel Built-in Dishwasher

Motor noise it fills with water, then the motor seems to make a noise instead of work. dishes are still dirty if we let it run.


It could be something caught in motor empeller IE. a bit of glass, or motor could be faulty ... Admiral 24 in. DDB1501AWW Free-Standing Dishwasher

We have a 2500 6.5 briggs & stratton pressure washer. Was working great, changed hydrants & hoses. Now it won't spray water. Yes we went back to the orignial hose & hydrant. Still won't work. Got any suggestions?


... Briggs & Stratton 3000 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1676 seconds