Having problems with your Karcher Pressure Washer 1800 PSI 15 GPM Model K348M ?

Simoniz piece # 9.036-694.0


Answers :

Repair Help & Product Troubleshooting for Karcher Pressure Washer 1800 PSI 15 GPM Model K348M

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have two rubber pieces that fell off dishwasher door. is from door hinge and what might they be. pieces are black oval and about 1 inch long. the disherwasher door has little resistance when opening and closeing with out these rubber pieces.both black rubber pieces have split.


... Kenmore 24 in. 16039 Built-in Dishwasher

Miele dishwasher optima G 2420. during instalation and test for water hardness display shows 'P' then '1' then '0'. is this a water hardness of '1' or of '10'


... Miele Optima G2470SCSF Dishwasher

A glass shattered in a thousand pieces in the dishwasher. I cleaned and vacuumed everything except the very bottom that I can't get to. I took out 8 screws, removing the round rotator piece at the bottom, but that still doesn't get me into the very bottom where I'm certain there is still glass. Question #1 - Will leaving the glass down there hurt anything? Question #2 - If yes, how do I get the rest of the part off without damaging it? I have a 10+ yr old Model DU920QWDB3 Thank y


The glass should just go down the drain from there. I doubt any piece that made it into there should damage anything as they are would have to be pretty small and as big as any food particle that could fit into there so you should be fine. If you rea ... Whirlpool Dishwashers

Kitchenaid dishwasher - small pieces of food are left on otherwise clean dishes. Water level comes to about 1 inch below heater coil. I ran it without dishes (or soap) and added about a quart of water so that level came to about 1/4 inch below heater and that's when I noticed food pieces on drain surfaces (nylon filter under bottom spray arm unit and circular plastic "trap" surrounding it). Spray arms holes are clear and water is hot.


It sounds as if you figured the solution out. The holes in the spray arm(s) get plugged by small debris, (tooth picks, seeds, bits of plastic like candy wrappers, etc) and the water does not reach the dishes to wash and rinse effective ... Dishwashers

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

My potscrubber 600 dishwasher isn't working. the thing on the bottom doesn't raise up (the 1 part ) and the other piece doesn't spin. The water doesn't seem to come up freely. I unders


... Dishwashers

I have an Arthur Martin ASF 2655 and the timer continues to turn from 0 to 1 to 2...... how do i reinitialise it


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

Simoniz piece # 9.036-694.0


... Karcher Pressure Washer 1800 PSI 15 GPM Model K348M

Bosch dishwasher SGS45EO2GB/45 does not complete washing cycle. It stays at 1 min left with pump running. I have reset the machine twice at which stage the pump empties the machine and the display shows 0 mins. However, have tried it agin and same problem. Any ideas, please?


... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Simoniz piece # 9.036-694.0 PA 6.6 30% GF CIP max 130 bar max 40o C


... Karcher Pressure Washer 1800 PSI 15 GPM Model K348M

We just hooked up our old built in GE dishwasher and the water is shooting out the left side of the unit where the black water hose enters the tub. Shouldn't the water be entering into the wash arm? The hose isn't clogged. It attaches to a white plastic piece that is part of the unit itself. The water is entering both the tub but also shooting out of 2 slits approx 1 1/2" each. located right below where u attach the hose.. Any help would be greatly appreciated!


... GE GSD5130 Dishwasher

Bosch auto 3 in 1 dishwasher not running full cycle. When the programme starts, water starts to fill then stops and water drains as the timer goes back to 0.


... Bosch Dishwashers

The count down timer gets to 1 stays there a long time, then resets to 23 or so, gets to 0 in about 3 hours or so. What do I need to replace? Thanks for your help.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Based on your description I'd say the issue is with the control. Bosch has had a history of this exact problem I'm about to lay out for you and this is the fi ... Bosch 24 in. SHU43 Built-in Dishwasher

The upper spray arm on our dishwasher has become detached from the back of the machine, and there is no obvious means of reattaching it. Are there some clips perhaps that have snapped on the part which attaches to the back wall of the d/washer (part number PP-TD20 - it's a 4 by 1 1/2 inch long rectangular shape with rounded ends) or does this piece somehow need to be taken apart (how - i can't see how i might do this?) and the transparent 2nd layer underneath get attached first? Thanks, Sarah.


What exactly the brand / model of your unit.?Let me know.Thanks ... Dishwashers

THE KICK PLATE HAS 2 SCREWS AND EACH ONE IS ATTACHED TO A LONG PIECE OF METAL, THE LEFT ONE IS BROKEN. I HAVE THE INSPIRA SERIES DISHWASHER.PN 0626375 LEFT SCREW. KICK PLATE NO 06606130TFSW 1-7002-040


Go nto your Miele dealer and buy new parts. ... Miele 24 in. G643Vi Plus Built-In Dishwasher

I have a KitchenAid Sculptura dishwasher and it have been leaving food particles on the dishes. I started to take it apart, removing the bottom spray arm. I can see a lot of old food underneath. I'm having a hard time removing the next piece. There is a 1" rubber nut with a screw in the middle. Is this the next step for removal?


Hi\015\012\015\012Thanks for using FixYa. Please post back with the model no of your Kitchen Aid Sculptura Dishwasher so that I can further assist you.\015\012\015\012\015\012Thanks\015\012Ryle ... Dishwashers

Door on dishwasher, model KUDSO1FKSS1, came crashing down. I removed the front under panel and discovered 2 nylon cables hanging down and 1 piece of broken plastic. Does anyone have a diagram of how these need to be installed? and, should springs be replaced at this time as well?


Hello, Welcome to FixYa.\015\012\015\012While I don`t have diagram or illustration I can give some insight because this is actually very common.\015\012\015\012It is a fairly minor procedure to replace it/them. Slide the entir ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I opened my Quiet Partner 1 after a wash and noticed a cone shaped plastic piece laying on the bottom of the rack, Have no idea where this goes. Any ideas?


... Whirlpool Dishwashers

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

The top spray arm of my Frigidare model FBD4315LFC0 Aqua Surge dishwasher fell off. Their appears to be a missing part. I've been searching online for a schematic and can't find one thorough enough to use. The parts I have are: 1. The top sprayer arm (the one in the top of the tub) 2. The two piece plastic keeper ring that appears to fit into the top of the spray arm. 3. A small white grommet looking item that fit inside the keeper nut. 4. The keeper nut that screws directly onto the wate


Hello there:hey sorry i keep getting disconnected i will be back on really soon i need to find out what is going on i hope these things that i have discussed with you is helping you out the parts are not as hard as they look once yo ... Frigidaire 24 in. FDB435RFR Built-in Dishwasher

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

Simoniz piece # 9.036-694.0 PA 6.6 30% GF CIP max 130 bar max 40o C


... Karcher Pressure Washer 1800 PSI 15 GPM Model K348M

The maytag dishwasher model mdb7130AWB stoped cleaning correctly so we went from the arm assembly in bottom of dishwasher down to the cutter disc and we found a crack in the housing so i ordered that piece. the new part was designed a little different but we put it all back together the way it came off. but it started and ran maybe 1 minute and stopped. so i have pulled up the diagram and see some problems. in the current diagram. original there was no part 37, 17 19 and 3, alos the crew d


... Maytag MDB7130 Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0249 seconds