Having problems with your Karcher Pressure Washers ?

How do i use the patio & deck cleaner on the karcher k5.68MD, when i add the liquid, what do i need to do for it to be pump up into the hose.


Answers :

The nozzle on the end of the wand either twists or pulls out to get you into soap mode, the liquid you have in the tank come out real slow, it does not come out with the high speed nozzle. The idea is to soak the job with detergent, then blast it off with the high pressure water. Hope this helps.
Repair Help & Product Troubleshooting for Karcher Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i use the patio & deck cleaner on the karcher k5.68MD, when i add the liquid, what do i need to do for it to be pump up into the hose.


The nozzle on the end of the wand either twists or pulls out to get you into soap mode, the liquid you have in the tank come out real slow, it does not come out with the high speed nozzle. The idea is to soak the job with detergent, then blast it off ... Karcher Pressure Washers

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

My fhh18a does not draw the liquid from the holding tanks to the spray. Added deck wash and sprayed a large portion of the deck before noticing that none of the wash had used. Tried switching tanks and then filled both tanks to try them both. Nothing!!! Spray works great, I just want to use the cleaner to do the job right.


Your spray wand's end adjustment rotates to change the spray pattern, it also pulls out for low pressure application of the chemicals.First, adjust the nozzle for the spray pattern that you want. Then pull it out to start adding chemical ... McCulloch FHH18A Electric Pressure Washer

I HAVE A CEAN MACHINE 1210 COLEMAN POWERMATE MODEL # pwo701210 MY PROBLEM IS THE SPRAYER HOSE TO THE PUMP DICONNECTED FROM THE PRESSURE OF THE MACHINE I FOUND 2 PARTS A SPRING AND A LIL BRASS PIECE THAT CAME FROM INSIDE THE ADAPTER NEED TO KNOW IF THERES ANY OTHER PIECES MISSING MAYBE A LITTLE DIAGRAM WOULD HELP SO I WILL KNOW WHAT I NEED PLZ HELP !!!!


Need a repair manual where can I find it ... Pressure Washers

It leaves about an inch of water after finishing, Hoses seem clear but the pump seems stiff to turn when i take out the filter, how can i get to the back of pump to clear it. do i need to turn the dishwater on its side to get access to it underneath


I WOULDNT TURN IT ON ITS SIDE IF IT HASNT FULLY EMPTIED. I WOULD TRY A DILUTED SOLUTION OF Mr MUSCLE DRAIN UN-BLOCKER. THEN RUN ON A FULL CYCLE STRAIGHT AWAY. ... Dishwashers

I have a go kart with a honda power washer motor that I just purchased.It lacks power at start and stalls alot.Put new pull in,sprayed carb cleaner,adjusted carb,new air filter,need to know if it need a fuel pump and were to get one


Hondas are gravity feed no pump needed .You might need to clean the card though. ... Karcher 2500 PSI Pressure Washer

The light of outlet,inlet keeps going on when I start the cycle.I have accidently put in normal washing up liquid and not the special dishwasher liquid . I checked the hose at back and filtrer.I think there is some scale build up .I need instructions how to check the ball bearing and pumpetc.I have no manual.


Go online to Hotpoint - I think I saw they had manuals on line when I was looking to solve my problem yesterday. Good luck. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Coleman pressure washer model PWO952750. The connection to the pump for the hose sprayer broke off at the pump. Looking at a parts list I believe I need a Manifold kid. Am I correct ?


... Coleman Pressure Washers

Need the liquid detergent that dispenses into machine via external hose


Contact knight chemicals ... Jackson JP-24B Built-in Dishwasher

We have a new honda gx390 pressure drain cleaner with bertolini pump we can not get max pressure to the hose can you help


Assuming that you have a pressure gauge to determine actual system pressure. Without pressure gauge, you could use the sound of the engine as test for capacity pressure (if engine and pump are paired correctly, engine will labor at full ... Honda Pressure Washer PSI 3000

I have an Avanti DW18 dishwasher that will not fill with water. No stopped up hoses. Dains water and if i add water manually it pumps it out.


Sorry to read about your problem.Their is a 60% chance that your cold water inlet valve is stuck. 30% that you water leval sensor is defective.I suggest you contact a local service company to repair your problem, this should be 1 hour or ... Avanti DW18 Built-in Dishwasher

My dishwasher will not drain, I have removed the screens, tried to run a wire through, and put drain cleaner in overnight but nothing works,,,, Do I need a drain pump? Thanks, Bonnie


How can I drain my dishwasher? ... GE Nautilus 24" Built-in Dishwasher

I have a Whirlpool Quiet Partner II model DU1100XTPQ7. The top rack is not clean after the dishwasher runs. We cleaned both sprayers with pipe cleaner & ran water through the lower sprayer with a hose. Then we let the dishwasher soak overnight with a gallon of vinegar in it. After running that through a cycle, we still see no improvement. We do have very hard water here; I add 1/2 cup of vinegar to every load. Any suggestions? Heather


... Whirlpool GU2400XTP Built-in Dishwasher

Karcher kb9030 can any t patio deck cleaner fit kb 9030


... Pressure Washers

I need a new pump out hose for whirlpool DWH B00


... Whirlpool DWH B80

Need the connection for the wand hose to the pump for Blue Max Gasoline High Presssure Washer stock No: PW2200/03435


Your pressure washer is sold under various brand names, however I believe that it is made by campbell hausfeld. Parts are here:\012 ... Psi Blue Max 2200 High Pressure Gas Power Washer

I have a 620m pressure cleaner that doesn't increase pressure at all ? No blocked hoses, there seems to be evidence of water getting past pistons, do i need to replace the rubbers ?


... Karcher Pressure Washers

I have a Bosch Dishwasher (approx. 3 years old) that is not emptying. Drain hose OK and drain is clear. I suspect it needs a new pump. Are there any adjustments I can try before I call a technician. Thanks Bill Rubel


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

I need the part that the water hose connect to and then that part connect to pressure pump for a blue max 2200psi 1.6 gpm i thank it is a ck valve can you help me find that part thank you edward


Take the old one to a hardware store or homedepot and get a brass replacement ... Psi Blue Max 2200 High Pressure Gas Power Washer

Water will not drain out of bottom of dishwasher.It will go through the whole cycle but will not drain. This is a Frigidaire model no.FDB510LCS3 Serial no.is:noth70219331.Pump hose was disconnected and drained completely,dishwasher was put through another cycle and still ended up with water puddled in the bottom!! Could this dishwasher be called a lemon??? Does the pump need replacing?? I have noticed on your website that many others are having the same problem.To me it appears that it may be sh


Check the input to the drain hose to make sure it is not blocked by something like a cherry pit.  That could cause the water to not drain fully. ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

My tappan dishwasher is only 1 1/2 yr old and its not getting at least 1/2 of dishes clean. We have tried everything from changing to liquid soap, increasing water pressure at meter, not using while washing clothes. We used a dishwasher cleaner to remove calcium, and run hot water in sink before using. We know the wand, pump and drain are working. It is model TDB210RFB5 with 1.1A motor. Is the motor too small to clean dishes? I wish I could get my money back or exchange for an upgrade. Thanks!


... Electrolux Dishwashers

Karcher 6.85 replaced seals as they were worn out and passing water into the oil now when I turn it on motor runs turning water on water comes out of outlet (which is ok??) but does not pressurize with hose disconnected. My Bosch pressure cleaner passes water through but when pump is started it pressurizes. Is it bypassing? Thanks in advanced


... Pressure Washers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

Cat pump 3200 psi problem- plz help! I hook up the hose and no water will come out of the pump out let with or with out the hose the pressure waser hose hooked up!


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1145 seconds