Having problems with your Karcher Pressure Washers ?

My K5.20M power washer won't start. Am looking

\015 My Karchner K5.20M power washer won't re- start after power outage I was using when the power went out. Need to check GFCI to restart???\015\012Where is that?? What else do I need to check?\015

Answers :

Make sure\015\012your extension cord is able to provide 13 amps or greater of current.\015\012The longer the extension cord the more current it requires to supply\015\012the 13 amps to your power washer. If your unit has a long extension cord it\015\012could pull more than the typical 15 amps used for a household circuit breaker.\015\012If you do not have an adequate circuit breaker it will continue to trip. Now\015\012that you have the correct power supply you will notice the GFI Test and Reset buttons\015\012by the power washer plug. Plug the power washer into the power receptacle which\015\012has live power. Make sure the power washer is off and then push the reset\015\012button located on the power washer plug until you hear a click. The GFI should\015\012be reset and you can now turn on your power washer.
Repair Help & Product Troubleshooting for Karcher Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

I own a KUDS01FLSS3 KitchenAid dishwasher. The lights on the control panel do not come on and a cycle can not be started. There is about an inch of water in the bottom of the dishwasher basin and it looks like the previous cycle did not complete. I have checked the wall outlet that the washer is plugged into and the washer is receiving power from the wall. And ideas? My next thought was to take the door off and check the power supply running to the door panel and control panel.


Servtek06 writes:\015\012check connections @ control board/module. May be Control Board/Module. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Power washer I have a karcher power washer and it haves a 7.0 robin motor on it... When i start it up the motor just goes in to high speed... I looked to see if all the springs are on the arm and they are ....All i can think of that the governer on the motor is not kicking it back... If you could help that will be great....Thanks Jerry


... Karcher 2500 PSI Pressure Washer

Power washer 1500 (reset gfci power plug ) still wont come on


... Pressure Washers

I have a Honda xr2600 power washer. When I tried using it, water was squirting from the top of the gun. I took it apart to find that there are o-rings on top of some kind of washer---looks like a lock washer but it's made of cardboard??? Two of these washers were broken. I can get the o-rings but I can't seem to find the washers. I tried getting the manual for this model on line with no luck. Any assistance will be greatly appreciated.


The washers that you describe are made of teflon and are split to facilitate installation and/or allow expansion as they wear. These washers are actually seals and at times are used together with orings to seal high pressure. You should ... Honda Pressure Washers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

My K5.20M power washer won't start. Am looking


Make sure\015\012your extension cord is able to provide 13 amps or greater of current.\015\012The longer the extension cord the more current it requires to supply\015\012the 13 amps to your power washer. If your unit has a long extension cord i ... Karcher Pressure Washers

Campbell hausfeld standard duty electric pressuse washer serial 15930 water wizard .. I cannot locate the reset button and after a short while it wont turn on at all it powers off automatically. and after checking cords and plugs it wont turn on at all..


... Campbell Hausfeld 1,350 Psi Electric Pressure Washer With Auto Detail Kit #PW1350

Hi, I have a Hotpoint Aquarius DWF31 Dishwasher. The dishwasher was put on last night and this morning although it looks liked it as cleaned is has not drained. But now there is no power at the machine. I have checked the fuse at the plug which is ok and also there is power at the socket. Is there a fuse inside the dish washer or any thing else i can check


... Hotpoint Dishwashers

Why wont blackmax power washer 2700 psi honda engine wont stay running once i spray


... Honda Pressure Washers

DISHWASHER WAS IN MIDDLE OF CYCLE... HOUSE LOST POWER AND NOW WASHER STOPPED AND WONT FINISH CYCLE NO LIGHTS ON BOARD DOES HAVE POWER TO UNIT HOWEVER NOTHING LIGHTS UP


Remove the rear panel. Gain access to the thermal fuse. (glass tube like fuse)\015\012This does have a tendency to go bad. A faulty door switch can also cause this. ... Kenmore Dishwashers

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

I just purchased a du920qwdb4 whirlpool dish washer and there is no power cord. I looked all around it and I dont even see where on would go. Do you have any idea of where one would connect with the washer?


You need to supply a power cord; the power supply cord kit (Part No. 4317824), available at your local dealer or parts supplier, should be used, if you want to plug into a standard 3 prong outlet. Alternatively, you can direct wire the unit to the ju ... Whirlpool 24 in. DU920QWD Built-in Dishwasher

Power washer compressor wont engage


... Pressure Washers

Electric power washer wont pump


... Earthwise Pressure Washers

Honda powered gx160 model pressure washer wont start


Did you drain out the fuel before you stock it? If you didn't, you may need to clean the carburetor or replace a new one because the fuel inside has become a kind of stick varnish. You may take a look at following link to see how to change or replace ... Honda 8 HP Engine

The cable in my Husky Gas Power Washer wont pull start


... Honda Pressure Washers

Dish washer has no power light so wont start


... Bosch Dishwashers

Gas powered pressure washer wont start


On pressure washers the more you pull the cord the more pressure builds up making it difficult to pull and start. I hold the trigger down as i pull this keeps the pressure down. If this is not the problem then take a look at the Spark plug, Air Filt ... Briggs & Stratton Gas Pressure Washer 20244

Power button wont stay down on my tricity bendix dbw42 dishwasher. Ive opened it and it looks like the control panel needs replaced


... Dishwashers

I have a union power pressure washer it runs for 10 minutes and then cuts off and wont work again, it still needs the choke on when the engine is warm and only runs for a few seconds


"it still needs the choke on when the engine is warm and only runs for a few seconds"This sounds like a fuel problem such as the carb needs cleaning ... Pressure Washers

Our GE Profile (Quiet Power 6) dishwasher is having trouble cleaning our dishes. The top shelf rarely gets cleaned and the bottom is questionable. It used to work fine. We always use Cascade powder detergent on a normal wash cycle. We have hard water. Any advice would be appreciated. I took apart the washer looking for an obstruction but none existed.


The obstruction can be external to the unit. Check the drain at EACH connection working backward from the sink connection all the way to the motor pump outlet hole. Do not forget to dis-assemble the Air-Gap (if installed) and to check the inside of ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

I am looking for a service manual for a gas powered craftsman pressure washer 2000 psi 3.75 hp. Cant seem to hook it up correctly


If you have the product model number (located on the tag on the unit) you can follow the attached link and enter in your pressure washer model and then look to the right side of the page and click on the "manual" button to get a copy of the manual yo ... Briggs & Stratton Pressure Washers

GU980 dishwasher I have a buzzing sound when the washer is in drain mode. The manual indicates there might be something in the Power Clean Filter, and that it will go away when the object grinds up. I called Whirpool, and they said the same, and to run for 2-3 cycles to make go away. 2-3 cyles later, noise is still there. I noticed a nub off the rack that looks like an end peice of metal broke off from rust. My guess is it's stuck in the PCF, and will not grind up. I removed the nut, lower spray


The nut holding the inpeller has to come off it is probally frozen\015\012if it snaps off then the pump assy willl have to be replaced or at least the motor, you need to get below the impeller to see what is down there though, or let it run as ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Blew a circit breaker this morning dishwasher wont start all power in kitchen is working this is a 1 1/2 year old dish washer


I am sure that you know that the dishwasher is on its own circuit... and that, in an older home that has been upgraded, the dishwasher may be on a GFI circuit.... If I am correct, you have an open GFI circuit somewhere in the kitchen or in a first f ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0770 seconds