Having problems with your Karcher Pressure Washers ?

The on off switch is not connecting. The switch just turns freely


Answers :

Repair Help & Product Troubleshooting for Karcher Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The on off switch is not connecting. The switch just turns freely


... Karcher Pressure Washers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

My power button cover broke on the dishwasher and I figured out the part number I needed, but when I put it back together I got the wires crossed on the board and door switch. Now the control lights up , but the dishwasher will not run a cycle. THe question is does the plug on the door switch have to be a certain way, because there are three wires and you can connect the plug both ways. I did turn the plug, but it still does not run. Did I break the switch? Bosch SHU9956uc/14


The wires do have to be a certain way on the door. Otherwise a door open can tell the board that's it shut and vice versa. The easiest way to do it, is test the switch with an ohmmeter, place the meter on the switch, push button in and see if the rea ... Bosch SHU9956 Built-in Dishwasher

Whirlpool dishwasher g2p dws over filling thus filling bottom panel with water which in turn floats polystyrene disk which connects micro switch shutting off machine. also fills up over few days ? faulty fill valve may be ?


Could be but if it is filling up when it is not running then you have a bad solinoid ... Dishwashers

Hotpoint Dishwasher DWF 30, has power to the machine's switch on and off. The LED lights on control panel do not alluminate. There is no sound of pump working, or filling of water. all water ways are clear, impeller turns freely by hand. Any clues?


Just one question is the water to the unit turned on ? some times a unit will have a fail safe protection device where it would not start the system if there was no water pressure to prevent damage to the unit, but given the symptoms i really don't ... Hotpoint 24 in. DWF32P Free-standing Dishwasher

It doesn't work at all no lights anywhere. I ordered and replaced new switches, and replaced the control board. The circuit breaker is on, and if I put one of the little meters that just tells if you have either 120 or 220 volts accross the two white wired connections on the board, 110 lights up. The float seeks to move freely.


If you have no lights at all and you have power to the circuit double check that the circuit board is connected properly first since you replaced that. On some models there is a safety circuit installed that disconnects power in the event it detects ... Kenmore 24 in. 15932 Built-in Dishwasher

I have an LG model LG8812st dishwasher and the spray nozzle under the top rack does not rotate. It turns freely by hand but it appears there is no water geting to it through the connection on the rear wall. Any ideas??


Either the pump is not able to pump due to clogged pump or there is not enough water in the tub after filling to get up to the upper spray arm. ... Dishwashers

Kitchenaid model KUDIO1ILBL6 The lights for Heavy Cycle ,Normal Cycle and Cancel blinking at the sametime constantly. The tech sheet is missing and the unit is appox. 5years old.have shut power down for 5 minutes .When power turn back on only the Heavy Cycle light blinks costantly. Have Ohmed out the door switches and check adjustment OK. Checked board strips and plugs for good clean and tight connections OK. Thanks


Hi, You need to reset the unit by pushing the buttons. Push the heated wash/heated dry a few times. All the lights will light up and the dishwasher will continue its . Let ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a SMEG DWF614 SS dishwasher. I continue to get an E8 error message. The diverter valve motor turns freely & the motor turns freely when they are seperated. However, when they are assembled, the motor turns the valve & continues to try turning the valve when the valve is on its stop position. Is the motor & valve faulty or is it the control. If you can answer, what part number would I require. Regards Leighton Davies


... Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher

Bosch SHX46A (6 years old) Selected regular cycle, pressed On and closed door. Cycle did not start normally. Pump runs, but no water is coming into the DW. I confirmed the water supply line is turned on. I opened door, turned off On/Off switch, then poured water into drain. Then turned On/Off switch on. DW began pumping water OUT of the DW. Also, it doesn't matter if the door is open or closed - if you turn the DW on, the pump will run. I suspect a problem with the electrical controls, or perha


From your description, I doubt that the problem is door latch is the cause.\015\012\015\012The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump.  It appears that this DW is not progressing ... Bosch Integra® 500 SHX46A0 Dishwasher

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

I have a AEG OKO_ FAVORIT 4040 dishwasher which has had very little use despite its age. The problem is that the switch that detects an over-fill is activated all the time and the pump continues to try and empty an already empty dishwasher even when the main switch is turned off, the only way to stop this is to turn it off at the power point I have had some sucess deactivating this switch by tilting the dishwasher forwards however because of the angle it sometimes overflows when filling. The ma


Hi there,This could be a problem on the control board of the unit. It could be faulty and need replacement or you may try to access the board and try to clean it.Make sure upon doing this all electrical connection to the unit ... Dishwashers

My Maytag dishwasher (DWU7400BAE)does not turn on. The latch micro-switches work; replaced the timer switch, still doesn't work; makes no sound of any kind when timer switch is turned. Could this be a relay problem, or is there a solenoid that activates the water flow?


... Maytag Dishwashers

I conected the hose turned on the water switched it on the motor started then just went off nothing is happening it just stopped


I fixed mine works good easy too watch my video step by step i put it on youtube ... Karcher K2120

Champion dishwasher we have a champion freestanding dishwasher at my church. after the cycle is completed, the pressure guage behind the washer still shows 25-30 and it contnues to spray water. not forced by the motor, but more like a stuck open fill valve. if i turn off the water and run it, then turn the water back on, the valve is closed and does not let water freely in. butif i run it with the water on, it will continue to spray in freely after the cycle light goes out and you open the door.


If you turn the unit off from the circuit breaker will the water still run?if so the guts inside the solenoid valve are worn.you can call champion and get a kit to replace the worn parts and its not difficult to do.hope this helps. ... Dishwashers

WHAT ARE THE THERMAL FUSE SPECIFICATIONS FOR KENMORE ELITE MODEL 66513122K701SERIAL NUMBER FY1211868 AND WHAT IS THE PART NUMBER FOR A THERMAL FUSE KIT? WE HAVE HAD TWO FUSES BLOW AND THERE DAMAGE TO THE WIRING ON THE LEFT HAND SIDE OF THE CONTROL PANEL THAT CONNECTS O THE SWITCH. THEIR IS DISCOLORATION ON THE PARTS AND WIRING. WE HAVE SEEN EXPERTS STATE THAT IN ORDER TO CORRECT OUR ISSUE WITH THE FUSE BURNING OUT WE NEED A THERMAL FUSE KIT AND WE NEED THE SWITCH AND THE WIRING THAT CONNECTS TO


Http://appliancejunk.com/ge/dishwasher/31-9137.pdf\015\012\015\012A ... Dishwashers

Model No. DU850SWPU3 AND SER. FT 4101406 TYPE 280-0. When cycle is complete and in off position the dishwasher fills with water. I find the bottom of the dishwasher standing full of water when I get ready to fill with next load of dishes. When I remember to turn off the wall switch this does not happen, however once in a while I forget to turn off the wall switch. The next day I find the bottom of the dishwasher full of water again. I then have to go through the cycles manually a couple of tim


If by turning the wall switch off, and only then it stops comming in, it means the board is faulty. There is a leak in the electronic system allowing to solonoid to stay partially open. Strangs that it doesnt flow onto the floor. ... Whirlpool GU2400XTP Built-in Dishwasher

Frigidaire fdb510lcb0 upper arm moves freely, but not turning during cycles.


... Dishwashers

My Bosch SHV46C dishwasher keeps running, even when the door is open, unless you turn the control switch off. Then, when you turn the switch on, it starts running again.


I have a Bosch that was stuck in pump down mode even when the door was open.The problem ended up being too much water in the drip pan below the unit. There is a float in the drip pan that actuates the same limit switch as the internal overfill ... Bosch SHV46C03 Built-in Dishwasher

Cannot start Homelite 7 HP EX21 gas pressure washer. Not sure how to set the primer lever? Forgot to turn on switch. Turned on switch, now cord is tight, will not pull?


... Pressure Washers

Hi - my Viking dishwasher has developed a problem where the pump runs continuously, whether the power switch is ON or OFF. After the power is turned ON, the troubleshooting guide indicates that there is too much water in the dishwasher. (One of the pot symbols on the display flashes continuously to show this indication.) I am unable to switch between programs, e.g., from quick rinse to pots & pans. I cleaned all the filters to no avail. I had to secure the circuit breaker in order to turn t


If you open the kick plate, you'll see the pan below the motor and check for leaks. The leaks will trigger the sensor to pump water out. Once you dry out the pan, the pump motor will stop and you should be able to reset the program. ... Viking DFUD042 Built-in Dishwasher

I have a Karcher K2.65 Deluxe pressure washer. All connected up, turned it on but I have low pressure out of any of the attachments and water splashing out of connection between gun and extension tube


... Pressure Washers

Our tricity bendix cooker top ceramic hob ring keeps turning on when switch is off, we have cleaned all round the switch seems a bit dangerous x


... Tricity Bendix Cooker Selector Switch For Dsie502gr currys

Karcher 3.86M Electric pressure washer. Plugged it into outlet. Unit started running. turned it to off position. Attached hose. Turned on water valve. Turned on switch. Squeezed trigger. Nothing happened. Will not run. Ciruit breaker was reset.


... Karcher PSI Electric Pressure Washer

DISHWASHER I have a problem with my CDA - CW494 dishwasher (6 ½ years old) You can switch it on and the lights come on. Then when you go to shut the door the lights switch off and the dishwasher doesn't start. If you move the door up and down the lights switch on and off. My husband has checked all wiring connections and they seem fine.


One of the switches in the door latch are not making contact properly. before you take the door apart make sure the dishwasher is 100% level. this can affect the door lat switches ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0589 seconds