Having problems with your Karcher Pressure Washers ?

I borrowed my neighbor's Karcher Model G 2650 OH (it's several years old). It had the yellow tip already on, but after awhile, I took the tip off to use a different tip,and pulled down the brass coupling at the end of the wand to insert the new tip. The problem is that the brass coupling at the end of the wand won't snap into place around the tip -- so I tried another, and another. No luck. And now the original tip that was on the wand won't snap back into place. HELP! I need to get my neighbor


Answers :

Repair Help & Product Troubleshooting for Karcher Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I borrowed my neighbor's Karcher Model G 2650 OH (it's several years old). It had the yellow tip already on, but after awhile, I took the tip off to use a different tip,and pulled down the brass coupling at the end of the wand to insert the new tip. The problem is that the brass coupling at the end of the wand won't snap into place around the tip -- so I tried another, and another. No luck. And now the original tip that was on the wand won't snap back into place. HELP! I need to get my neighbor


... Karcher Pressure Washers

I have a Whirlpool Gu180 ESJQ with a blinking green start light. If I clear this light (hold the start button for 5 second to place it in the end of cycle) then I can get it to start another wash cycle. However, the next wash cycle ends with a blinking start button again and the dishes aren't dry. I had an appliance service man come to check it out and he could not detect any problem! Now I have a leak!


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Bosch SHX45M05UC/48 I'm trying to install my dishwasher....but, the hose attached to the right side of the dishwasher looks like it should be connecting, at the other end, to another place within the dishwasher. I can't figure out where it connects and I'm sure I shouldn't have two drainage hoses. Help. mm


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

HAVE A DEWALT PRESSURE WASHER WITH 6.5 HONDA ENGINE THAT WAS STORED FOR A COUPLE OF YEARS. IT WILL START BUT ONLY RUN FOR3-4 SECONDS WITH CHOKE ON THEN KILLS. WAIT A MINUTE OR SO, PULL ROPE AND WILL RUN FOR ANOTHER 3-4 SECONDS. WON'T RUN CONTINUOUSLY. PUT FRESH GAS AND CLEANED BOWL UNDER CARB. ANY OTHER TIPS? THANKS, FOREST


Look for plugged filter anywhere in fuel line. ... Pressure Washers

We have the black tip on and have placed clear plastic hose to black plactic and the brass valve at the bottom of the washer and no siphoning


Chemical injectors are terribly designed, Flimsy to say the least. They all use a check valve (ball bearing) held agaunst a steel seat by a tiny spring. Yours is either stuckshut or rotted away from using bleach and not cleaning it well.Feel free to ... Pressure Washers

A knife with a plastic end must have fallen down during a cycle and melted to the heating coils of the dishwasher. Could not get it to come off at all! Then unfortunately we forgot and did another load. Obviously it has melted further and still wont come off. I'm not sure what to do? Thank you!


WEll, it will take heat to get this plastic off. nothing else works.I would use a heat shield, gas torch and a wet terry cloth towel. heat the unit up and pull off with the damp towel. Really nothing else works. Sometimes you can activate the burner ... Dishwashers

Indesit idl730 at the end of the cycle the pump wont stop trying to empty


... Dishwashers

Brass part in wand handle because the brass fitting


Bronze breaks, why it does not have flexibility. it substitutes part for steel inox\015\012 ... McCulloch FH180A Electric Pressure Washer

I have a karcher K3.98 pressure washer. The unit surges when I put the wand on and then it stops working. I tried cleaning the wand (didn't make any difference) I then tried another wand from my son's unit (still didn't work)I am wondering if the unit is worn out or can you suggest what is wrong? Thanks [email protected]


Dear davedulmage,\015\012To see if the unit is OK....first you must switch it on without water and without high pressure hose and gun. If machinr works smoothly, try by attaching a water supply. Now run the pump with water coming out of the o ... Karcher Pressure Washers

The cycle doesn't seem to stop correctly. I start a load. It doesn't seem to matter which mode that I start in, but it will count-down the time, but at the end it hasn't stopped running. I've cleaned out the filter and the trap below. I've ran vinegar through a cycle. I've cleaned all of the spray arms. It doesn't seem to advance out of the wash mode. There is still some suds at the end. I have to end the cycle by canceling and draining it manually, then run a couple of "rinse--9 minute" cycles


Hello,\015\012\015\012Based on your description I'd say the issue is with the control. That is what I'd be looking for if called out to service the unit with the symptoms you've described. \015\012\015\012The issue is within t ... Bosch 24 in. SHU43 Built-in Dishwasher

Hi. I have an LG LDF7810 dishwasher. I did a deep clean and ended up taking out a bunch of grease from the seal between the door-bottom and the tub. I even removed the door to get at the grease I thought was trapped back there. Since then it has been leaking water, sometimes a drip and a couple of times a few ounces have gushed out at the end of a fill cycle. Did I remove some factory grease designed to seal the door bottom? If so, what should I replace it with? If not, what else could the


It is possible that while you removed off the grease the water seal/oil seal was also damaged. Once the seal is taken out it can loose the sealing strength which can make it possible to leak.\015\012Hence it will be good to remove the seal and ... LG 24 in. LDF7810 Built-in Dishwasher

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

My Bosch SHU9925UC dishwasher will not stop cycling and come to an end. I also noticed that a couple of weeks ago it stopped beeping to signal the end of the wash. Can anyone help me please? Thanks for any ideas.


Go check this link it will help you http://www.applianceaid.com/boschDW.html#run\015\012\015\012Hope that helps......... ... Dishwashers

My dishwasher is a Fridigdaire FDB510LCS1, approximately five years old. The timer/knob stops advancing at about 7 o'clock, somewhere in the wash cycle. But the washer keeps running. I marked the place where it stops and, on additional tests, it stops in exactly the same place. I can advance the knob slightly past this location and the washer continues through to the end of the cycle.


Hi\015\012\015\012This is due to a faulty timer on your dishwasher. You would need to replace it to resolve this issue. You can buy the timer for your dishwasher from this link---\015\012\015\012 ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

We have an AM-14 dishwasher. It now will not work on auto. It would sometimes and then not and now only on manual. We have had a couple people in to look at it. One says the main board was bad, so it was replaced and the problem continues. The board that was removed was put into another washer and it worked ok. We were told then that that a wire from the motor was wrong and thats when we called in another person. That person said the board was bad and they couldn't work on it. We are in Lancaste


... Hobart AM14-253 Free-standing Dishwasher

The disk washer doesn't drain at the end of the rinse cycle. There is a humming sound but no water is forced through the hose to the sink/garbabe disposal. At the end of the wash, there is a large amount of dirty water in the bottom of the washer. I removed the spray arms, the spray arm holder and the screen and then removed the water, and found a couple of pieces of plastic. But I don't see how I can remove additional parts from the washer bottom. What could the problem be? Is there a fi


Is the dishwasher drain hooked to the garbage disposer? If so is it new? If so did you knockout the plug in the disposer? If so then you either have something clogging the drain or pump. Or the pump motor is bad. ... Dishwashers

I have a Bosch SHU8805UC/14 dishwasher. I took the front door panel off to install it better but ended up with two extra pieces that look like either part 935400 Door Guard, or 935526 Support. I cannot seem to find any place on the inside of the door where these pieces would fit. The dishwasher works fine but seems like it got noisier after I put it back together without these two parts. Can you help me locate the proper place for these 2 plastic parts?


Hello, \015\012\015\012Welcome to FixYa.\015\012\015\012I believe the parts you are referring to are likely the blocks in each corner of the outer door panel. These have been a sticking point for many I tech over ... Bosch Dishwashers

Wont drain dishwasher wont drain at end of cycle. I have tried the baking soda and vinegar with not results.


You may have check flapper valves. they may need replacing. ... Dishwashers

I have a Maytag model DWU9502AAM dishwasher, took out the top rack (easy) to wash furnance filters, and cannot get the rack back in rightly! Where are the rollers on each side supposed to be placed to hold the rack? Do the snap supports face up or down on the rack? I broke two of the roller snaps and replaced them, still no luck. Does anyone have a schematic??? Maytag has nothing on this I can find. Thanks!


Hi there,\012Well you can try from upside face...... there are some plastic lock type grips... for more information you can download the repair manual, please follow the below link -http://cgi.ebay.com/_W0QQcmdZViewItemQQitemZ ... Bosch SHU9915UC Dishwasher

My smeg dwi 710 dishwasher keeps flashing on the diplay panel and won't change to another wash selection. it wont close and wont start. the light is stuck on the heaviest wash selection and just keeps flashing on and off and on and off. i have tried turning it off, keeping buttons held down and nothing seems to work. there is nothing in the manual that says what the flashing means so i dont know how to fix it.


... Smeg Dishwashers

Programming lights are lighting up when i turn machine on but wont set on a programme. Also the door wont lock in to place?


... Maytag 24 in. MDB8751A Jetclean II Built-in Dishwasher

Whirlpool DWF417W, Type 12155 A couple of weeks ago the machine failed to empty, leaving dirty water in the machine at the end of the cycle. Start a new program it emptied & all was then well. A couple of days ago we started a wash cycle as normal, shut the door, the pump normally runs for about 10 seconds then the cycle starts. However the pump just runs continuously?? After looking here there seemed to be a few links to the subject of water being in the base & the anti flood switch being ac


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

I have the Karcher 2400 psi, 5.0 Honda engine. Starts fine, but when you pull the handle on the spray wand, the pump does not kick in and the water just continues to trickle out of the end of the wand at regular faucet pressure. Occasionally the "clutch" will kick in and you have full pressure, but if it does and I let off of the trigger then chances are that it won't kick in again. has been getting worse for several years.


... Karcher 2500 PSI Pressure Washer

Beko washing machine wm5100w my washing machine wont work it wont start and and the ready and wash dots keep flashing and the spin and end one stays on thanks


... Dishwashers

Baumatic dishwasher BTD 4SS. Program does not advance, gets stuck in 3 places on cycle ( at end of stage 3, 4 and between 4 & end), not sure if water is heating.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0946 seconds