Having problems with your Karcher Pressure Washers ?

Our Karcher pressure washer gun is leaking at C clip can we fix it without buying new gun? We have bought a new C clip but its still leaking. regards Mike


Answers :

Repair Help & Product Troubleshooting for Karcher Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Our Karcher pressure washer gun is leaking at C clip can we fix it without buying new gun? We have bought a new C clip but its still leaking. regards Mike


... Karcher Pressure Washers

My Karcher K730 MXS pressure washer was leaking water out of the rear of the gun handle. I bought a replacement hand gun and the new gun is doing exactly the same!


... Karcher Pressure Washers

I have a pressure washer with a faip 3 piston pump. the other day i was using it and it stopped unloading. i cleaned the unloader and it didn't help. I bought a new one and it still won't work. I e-mailed Ryobi and they will not respond. There were no instructions on installing and adjusting the unloader. Could you give me an idea how to install and set up the new unloader. Any help would be most appreciated.


I think your main problem is that the unloader valve needs to be lubricated. Use the very best water resistant bearing grease you can find. If you can e-mail me a pic of your unloader assembly I can try to explain how to set it up. [email protected] ... Honda Pressure Washers

I bought a new lg ldf6810bb/01 when re-doing the kitchen. After about a year, the dishes quit drying. Since we had bought an extended warranty, we have had several repairmen out to check on this. The did change the fan in the door, but now says everything is working as should. However, it still wont dry the dishes. We finally got in touch with the distric manager for best buy where we originally purchased, and after some more reps coming out, finally replaced the dishwasher. However, t


... LG LDF6810 Built-in Dishwasher

I have a JD 3300 psi 1150 Briggs n Stratton pw. It is leaking from the oil cap/ dipstick seemingly from high pressure. The cap dipstick is about 10 inches long, so this is a real squirt goin on. There is no rubber oring or gasket in the cap. I bought it from a pawn shop new, or at least seemed new as the hose and tips were still factory wrapped. Any ideas?


Either there is compression from cylinder getting into crankcase pushing the oil out or the oil level is too high. ... Briggs & Stratton Pressure Washers

My ESD haier 302 dishwasher does not drain. I bought a new control top/panel but there is still a problem, and waiting to receive the new control board. What's wrong?


... Haier ESD302SS Stainless Steel Built-in Dishwasher

I just bought a simpson silenco 850 dishwasher & my son picked it up & took it to the property to install it .He said the waste pipe hose was missing the rubber end with the silver clip to hook on .Do I need to buy a new hose or could I find another rubber piece to slip over & re-attach the clip? Thanks


... Dishwashers

Have a brand new LG dishwasher, food residue still left on dishes after cycle. I am not talking about unusually dirty dishes here, just normal tiny bits of food. This is why we bought a new one, old one had same problem. Any ideas?


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

I just bought a new Whirlpool Silent Partner III. I have used it about five times with different amounts and kinds of soap, adjusting the jet dry amount and using pots and pans cycle. I still get filmy, milky gross looking dishes and glasses. I am really disappointed!


The problem is hard water that causes that white residue. go to www.dishwasherfilter.com and get the filter they make. it is made to solve this problem. it will filter the ... Whirlpool GU2400XTP Built-in Dishwasher

MY Creda 479908 dishwasher just keeps going when I set it going. It just stays in washing (for hours) and needs me to move it on or stop it. Can these still be bought new? Many thanks Bernard


... Creda Dishwashers

The little actuator type motor in the dispenser goes off buzzing like crazy and its random. This motor is used to open the dispenser door. I bought a replacement dispenser assembly which includes new motor and it still has the same random buzzing sound. Would this be some type of issue with a relay or something?


Hello.\015\012Thank you for using Fixya.\015\012\015\012this is the troubleshooting of your problem:\015\012\015\012Unjam the motor \015\012Unjam the pump \015\012Test t ... Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher

SERIAL # NEX725476 CRAIG N DOUGLAS 63 14TH AVENUE TAURANGA I bought my new model double dish drawer DD60 model thru Noel Leeming on the 29.07.2009 (inv 104174599 Cust # 5321218) I have already written a strong complaint about this useless dishdrawer some months ago. I was asked to provide the serial number, which I have done as above. I am still totaly unhappy with this dishwasher. Where does it say in the manual that you have to buy expensive dish tabs, with power balls, & wash every wash


... Fisher and Paykel Dishwashers

I have a new Ariston LKF720 dishwasher. In part of its wash cycle it is very noisy - not water noise, but a grating motor-like noise. Is there anything I can do? Is there anywhere I can watch a dishwasher do a run and listen to its noise, Ariston or other brand? We bought the present one off the floor and did not expect any problem, having had other dishwashers for years, they being quiet. The poor technician already changed the motor, but it is still just as noisy. I am even considering sellin


... Ariston Technologies L63 Free-Standing Dishwasher

WE JUST BOUGHT A NEW DISHWASHER DU1345XTVB HOOKED EVERYTHING UP CORRECTLY AND RAN A QUICK CYCLE THRU IT AND WHEN IT WAS DONE THERE WAS STILL WATER IN THE BOTTOM. THIS WAS TO REPLACE THE OLD DISHWASHER SO IT WAS ALREADY HOOKED UP THRU THE GARBAGE DISPOSAL. WE CHECKED THE HOSES NO KINKS...VERY FRUSTRATED! HELP!! TRISH W.


Make sure the garbage disposal is working, if it is not then it will not allowthe dishwasher to drain. Also make sure there is not blockage in the intake port on the disposal where the hose connects itself. If you installed a new disposa ... Whirlpool Dishwashers

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

I see that you have advised on the dishwasher soap residue problem in the past. I was just wondering if you have learned anything new since the last time you posted. I have this dw residue problem, too. I DON"T seem to have it with the gel packs. But my 3-level Kenmore did the job great up until about 6 months ago. Then, I bought a different dw soap and had trouble. So I changed brands. It STILL left a residue. SO bad that I phoned the company. They were completely noncommittal about the reason


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

My zanussi dishwasher zsf4123s stopped getting hot,i bought a new heating element but still does not heat up,though im not sure if i fitted it correctly


... Zanussi ZT485 Built-in Dishwasher

No pressure i have a karcher g 2600 vh i wasnt getting pressure and i found that my spill valve was faulty it was actually broken i bought a new one installed it and im still not getting much better pressure ive taken the pump apart and checked for build ups blew thru the valves wirh the compressor and there appear to be no blockages


... Karcher G 2600 VH Gas Pressure Washer

Hotpoint Dishwasher Bought it new 2 weeks ago. Seemed to be working ok. Last night it started leaking out the front door (suds). I disconnected the drain line (tried to blow through line to tub, NO GO) so I started it and ran it into the sink. It seemed to be flowing OK, but there is still about 1/2 inch of water inside washer. Is this OK? Model # HDA3400G02BB


Water will not come on. started 3 months ago being erratic, some time it would work, some time it would not. Now it has gotten solid. Everything runs except water, therefore no wash. ... Dishwashers

SOAP DISPEN DISHWASHER SOAP DISPEN NOT OPENING I bought a brand new LG dishwasher about 6 months ago. I've had a few problems with it. First, it gives off a smell when it operates. Secondly, more often than not, the soap dispenser does not open. I have read the manual and have tried putting a lot less soap but it still does not work. Should I try switching to liquid soap instead?


Is the machine heating ok?, if so then the dispenser and or the electronic control board is most likely faulty. \015\012if the machine is still in warranty call your lg service agent and when the tech is on site, reque ... Dishwashers

Good Morning, I don't need any help except to get rid of my lg dishwasher because it is the worst dishwasher I have ever had!!! I have had it fixed once(new motor ,new soap tray,new board) and it still does not work good and still smell like it is burning up. I have not been as unhappy with anything in my life. WISH I HAD NOT HEARD OF LG AND WASTED A LOT OF MONEY!!!!!!!!!


Hi,You might be interested in this.....http://www.contacthelp.com/directory/Shopping/Electronics/LG?ListingID=386heatman101 ... LG Dishwashers

We just bought a house with an old Hotpoint Dishwasher Model # HDA467, Serial # TZ611315X. I know there was a recall years ago, can we still qualify for it? We won't be using this dishwasher.


Click below for the information on the recallhttp://www.geappliances.com/products/recall/dw1.htm?omni_key=Dishwasher ... Dishwashers

Hello, Firstly, thank you for what you do, you help so many people and I know it takes time. I have a Bosch SHE44C06-UC Dishwasher. I fixed the E1 (Heating Circuit) error. First, before I found the writeup about the solder joint, I bougut a new heater and replaced it, ithe part included the element, flow switch and high temp sesor soall are new, then I fixed the solder and E1 went away and the cycle finsihes and the dishes are clean and dry. Still I check the error codes and still have


... Dishwashers

BOSCH DISHWASHER,MODEL# SHV99A13UC19, I HAVE NO PROBLEM REMOVING THE EXISTING DISPENSER, HOWEVER INSTALLING THE NEW MUST REQUIRE A TOOL TO PULL IN THE NEW DISPENSER COMPRESSING THE GASKET SO THE CLIPS HOLD INTO PLASE. I NEED ANOTHER 1/16 OF AN INCH FOR THE LATCH ON THE CLIPS.


Put the new one in a cup of hot water for two minutes to soften up the gasket then quickly install it while it is still flexible. ... Dishwashers

I have a Neff dishwasher S6409N1GB/09 and for the last 3 months engineers have been out to fix it but it still does not work. They have fitted a new motor, new pump, new circuit board, new fill tube, new breather, can you advise what the problem could be, because the engineers have given up on it, help. Mr Dave Gallagher


... Neff Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0962 seconds