Having problems with your Karcher Pressure Washers ?

I've lost power. I forgot to turn the unit off and was gone for a couple of hours.

\015 210 model\015

Answers :

I would be sure that you burned it out
Repair Help & Product Troubleshooting for Karcher Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I've lost power. I forgot to turn the unit off and was gone for a couple of hours.


I would be sure that you burned it out ... Karcher Pressure Washers

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Our Beko DE6340 has stopped working. We turned it on as usual and left it to run. Several hours later we opened the door and the was water in the bottom. This has happened before so I slid the unit out took out the drain and reattached. Now it won't turn on. I have taken the top panel off an there is power to the switch but no lights are coming on. Any ideas?


... Dishwashers

I was using the washer and it was running fine for a couple of hours and then it quit like there was a current sensor or something tripping. I would turn power on and press trigger on wand and then it will run for a few seconds and then quit again. I have to turn the power swich off then on again and then it does the samething.


Your preasure regulater ,remove and clean you will be back in action ,can I borrow it to clean my shop.lol ... Northstar Electric Wet Steam & Hot Water Pressure Washer 1700 PSI

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

Whirlpool Dishwasher ADG 450. Start as normal and it keeps intermittentlly stopping and starting. Washs / drains fine, but sometimes cycle seams to last for a couple of hours. I think it is four beeps when it is stopping and then immediately starts again. We had a problem months ago where as the sink was draining into the dishwasher out pipe, so dishwasher wasn't draining / filling up. Fixed the problem by turning the pipe the other way so water couldn't flow that way - but I don't know if that


... Dishwashers

Won start Was using the pressure washer 1st time this year and started on the second pull. Ran out of gas shut-off also noticed it needed oil. Believe, I put too much oil so, I drained some and added gas. At first, there was no resistant in the pull so waited an hour and tried again. This time the resistant was there on the pull but still would not start; no attempt even to turn over. It's been a couple of days...changed the spark plug although, hardware guy said nothing was wrong with it..still


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a Bosch SHU43C05UC diswasher. Last night, I put it on before going to bed as usual. I was awakened a couple of hours later to a loud grinding sound (like a pump being run dry), and found the noise coming from the dishwasher. The display read "0" time remaining, so I opened the door and the dishes seemed clean, so I left it shut off. Tonight I have been trying to troubleshoot the problem. The dishwasher will turn on, but it will not seem to fill with water. I have verified that the


Ok well before you can do anything you must obtain a service manual, link below.\015\012\015\012http://allrepairmanuals.com/bosch ... Dishwashers

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

Please help We turn the machine on and error #304 pops up. The units almost up toTemperature but doesn't quite make it. A day or two before this washappening error #203 had popped up a couple times. The operationsmanual states the reasons for some other errors but not these.


Hi, you dont state the make and model of your machine. ... Dishwashers

Our dishwasher worked just fine until today. There are no lights on the panel and it will respond. We checked power and it is on. We turned off power to the unit for one hour. Still no response. Help.


... Kenmore 24 in. 15689 Built-in Dishwasher

We lost power as our dishwasher was running. When power was restored it seems to be stuck in the drain cycle. We have tried turning the unit off and back on and also holding the start button for 5 seconds.The 4 lefthand lights blink on and off and the right hand lights are steady. It is a model D1996.


Try to unplug it or turn off the circuit at the electric box.............wait ten minutes or so and plug it in and try again..................the program needs to be reset in that manner sometimes....... ... Dishwashers

Dish Washer, Electrolux Home Products, Model FDB2510LCC0, Serial NO: 7H34962223 Machine does not drain or add water. The machine has been worked for a couple of years. I checked the following: 1. Overfill Protector not stuck 2. Motor turns on and the machine cycles correctly 3. Since the machine has been running correctly the unit is hooked up correctly: hoses, garbage disposal, knockout plug. Again everything has worked and the motor does cycle and the machine will perform the different cycles


... Electrolux 23 in. ESI602 Free-standing Dishwasher

I used the dishwasher a couple of days ago and then today I could not turn it on the unit seems to have electric to it and I am thinking it might be a fuse. the circuit breaker seems ok


Check where the power comes into machine and the door switches. ... Frigidaire Dishwashers

I have a new Bosch Dishwasher.I just turned the Unit on and 10 Minutes into the Wash Cycle it comes up with Error Code E 16. There is no information in the Operating instructions about what this means or how to fix it. I have been on the phone for 1 hours on hold listening to elevator music after ringing BSH Home Appliances Pty Ltd Customer Care I just install in using the Installation Guide. I have 20 years experiance in Appliance Repairs. Does anyone know what E 16 means and what is the fix.


... Bosch Dishwashers

Hotpoint Model HDA 3500N 10 BB Unit is only about a year old. The dial does not move. I noticed it when the washer was on for more than 3 hours and saw that the dial was still in the middle of the wash cycle. I then turned it to the rince cycle which operated there (not moving) until I manually moved it to dry. Did not move from there either. Thank you for any help you can give me.


HiThanks for using FixYa. From what you have described it seems to be an issue with the timer that has gone bad, they don’t often fail but if everything else is working fine then it is the Timer ... Hotpoint Dishwashers

I have a bosch SHU6802UC dish washer. Recently the cycles were getting very long (3+ hours) and now when you press power/start, the unit turns on and you can hear the rather loud hum (pump?) of the cycle starting but it does not do anything else, just continues the loud hum. No cycle, does not fill with water, nothing. I ran the diaognostic and it immediately came up "7" on the display. Any thoughts or direction would be greatly appreciated. FYI, I did thuroughly clean it which made no di


There are a few possibities...if you remove the lid and take the two t20 screw off the left side panel at the front you could check the pressure chamber and its hose are not blocked. Use the link and go to page 4, part 263834 and 361113. You ca ... Dishwashers

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

I have a KitchenAid KUD1021RWHO dishwasher that will not turn on when I hit the start button. The LED lights work when I press cycle selection ie. "normal" but when I press the start button nothing happens. I have waited for a couple of hours and then it will start. However during the last week it has happened more frequently and now it has not worked for the last (2) days. Any ideas as to what the problem may be? Thank you for your help!!!


Hello,\015\012\015\012This is a very common issue on these units. The touch pad has failed. You can try to flip the breaker off for several minutes and see if that clears the code. More than likely the touch pad will need to be replaced.\015\01 ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

Hello all, We have an Ikea Whirlpool DWF 416 that is a couple of years old and has never caused any problems. From today the door has stopped shutting properly. The electronics and internal mechanisms seem to be working fine, since when you turn it on the cycle starts - but only if you hold the door shut. Has maybe a catch gone? Any ideas for fixing a door-shutting problem like this? Thanks in advance! Dave


The catch is no longer working. Contact IKEA for the replacement part. I'm sure it's available through EBAY or something, but probably not guaranteed or as reliable. ... Dishwashers

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Unit not turning on


... McCulloch FH160G Pressure Washer

I have a GE gss1800z02. When the unit is turned on it starts to work, then sparks start coming out of the bottom of the unit. If the unit is off and the circuit breaker is on, their is a sound similar to a TV being turned on about every 30 seconds.


... GE Dishwashers

Hi, I have a Karcher K3 pressure washer. 18 months old, used maybe 6 hours total. For the past 3 hours of use the compressor/pump seems to cycle audibly but pressure at outlet hose seems constant, hence I did'nt worry. Now it does not start with switch on. I now hear a buzzing sound from the unit. The unit was last used 6 weeks ago. The unit was stored in the garage away from frost, it does not leak water so I don't think there is any frost damage, but just this buzz. Any suggestions would


... Karcher K3.68MR Electric Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1116 seconds