Having problems with your Karcher Pressure Washers ?

Stripped male outlet on a karcher 3.86 pressure washer

\015 I stripped the outlet tube on the plastic threads how do you replace it\015

Answers :

Repair Help & Product Troubleshooting for Karcher Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Stripped male outlet on a karcher 3.86 pressure washer


... Karcher Pressure Washers

Poor pressure karcher g 2500 pressure washer with a 5.5 honda engine. No high pressure, hose pulsates as does water out of the outlet. have removed the unloader valve twice and cleaned it to no avail


I had this same problem on my pressure washer.the pump had some broken parts in it .i found my replacement pump on EBay. ... Karcher 2500 PSI Pressure Washer

How do you strip a Karcher K3.86 electric Pressure Washer


... Karcher Pressure Washers

Karcher B402 pressure washer Motor runs as soon as power supply connected, on/off switch does not seem to make a difference and no pressure at outlet? Was working fine, stopped for half an hour, came back and wouldn't work. Thanks Bob


Bob I had this happen to my Karcher, the pressure seals have blown. $Au200 for service and replacement from karcher dealer. tyhey would not sell the parts for a DFY ... Pressure Washers

How to remove outlet hose from Karcher 520 m - Karcher Pressure Washers


... Karcher Pressure Washers

Hi, I have a Karcher K3 pressure washer. 18 months old, used maybe 6 hours total. For the past 3 hours of use the compressor/pump seems to cycle audibly but pressure at outlet hose seems constant, hence I did'nt worry. Now it does not start with switch on. I now hear a buzzing sound from the unit. The unit was last used 6 weeks ago. The unit was stored in the garage away from frost, it does not leak water so I don't think there is any frost damage, but just this buzz. Any suggestions would


... Karcher K3.68MR Electric Pressure Washer

Karcher high pressure hose pops off high pressure outlet. I think it is stripped.


Try one of the products from your local DIY store, i,m talking about the two part putty that you mold with your fingers, can be drilled tapped and can do amazing bodges, plumbers are never without it! Good Luck - the Yeti ... Karcher PSI Electric Pressure Washer

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

Karcher K3.91, lost some pressure and pulsing when trigger is release. stripped it down and checked all six valves and there all sealing as they should. i took apart the unloader valve cleaned and inspected and thats fine. there is NO water leeks anywhere or oil. preasure washer is 2 years old and gets used once a week for ten minutes. i really dont understand why its playing up


... Pressure Washers

Karcher max 2700 psi 6.6 gpm 140F spray gun - Oregon 37-068 Pressure Washer Spray Gun With 12-Inch Lance Medium Duty 2,700 Max PSI 6.6 GPM 140-Degree F Max 1/4-Inch Male Inle


... Oregon 37-068 Pressure Washer Spray Gun With 12-Inch Lance Medium Duty 2,700 Max PSI 6.6 GPM 140-Degree F Max 1/4-Inch Male Inle

Karcher K386M-I was using the washer and the pressure hose popped off the outlet of the unit. I put it back on and it popped out again. The second time I noticed the oring was gone. It was on there when I first put the hose on. Why does the pressre hose pop off.It was on tight?


... Pressure Washers

I need 0 rings for Karcher 4000 psi pressure washer. Where can I find them?


... Karcher 4000 PSI 36 GPM Gas Pressure Washer G 4000 OH

I 've not used my Karcher Pressure Washer for over a year. I tried to use it but it will not start. I've changed the fuse. I've checked the water outlet, but it will not start up. What is the problem with it?


... Karcher K 2.27 1600psi Electric Pressure Washer

Water is leaking from under the chrome piece inside my Karcher 3.68m pressure washer. Hose intake and outlet look good. Any sugeestions.


Plastic Pump Manifold is cracked.\015\012\015\012Can be replace at a local Karcher Service Center,\015\012or if you are mechanically handy.\015\012Replacement Manifold Complete, is available from www.karcher.com.\015\012\015\012If it is ... Karcher K3.68MR Factory Refurbished 1,800 PSI 1.5 GPM Electric Pressure Washer

Pressure washer manifold kit has male adapter that is strip where hose screws on. How can that be fixed


... Karcher 2500 PSI Pressure Washer

Karcher 3.86M Electric pressure washer. Plugged it into outlet. Unit started running. turned it to off position. Attached hose. Turned on water valve. Turned on switch. Squeezed trigger. Nothing happened. Will not run. Ciruit breaker was reset.


... Karcher PSI Electric Pressure Washer

Karcher 570 pressure washer - Karcher Pressure Washers


... Karcher Pressure Washers

Karcher 232 pressure washer - Karcher Pressure Washers


... Karcher Pressure Washers

Karcher pressure washer 3.86 motor hums - Karcher Pressure Washers


... Karcher Pressure Washers

Karcher pressure washer wand won't spin - Karcher 1750 Psi Elec Pressure Washer


... Karcher 1750 Psi Elec Pressure Washer

Karcher pressure washer My Karcher pressure washer switches ON and OFF continually when I am trying to wash. It is about 6 yrs old 120 Bar 1750 PSI 420MH


... Karcher 2500 PSI Pressure Washer

Karcher k5.50m pressure washer Manual - Karcher Pressure Washers


... Karcher Pressure Washers

I have had 3 Karcher pressure washers all experience the same problem and so have two of my neighbors. Our area has very hard water and it causes problems with the washer not bringing up the pressure when the trigger is pulled (or surges up and down) and the nozzles clogging, etc. The service repair facilities cannot tell me how to prevent this. Many attempts to contact Karcher for advice have been ignored. I have been thinking that perhaps running the engine for a few seconds with no hoses a


If your water is that hard (and it appears it is) WD40 will NOT solve the problem. You should look into a water softener. However, chances are that a small, inexpensive model will not have the flow capacity required for a pressure washer. You'll like ... Karcher K2.26 Electric Power Washer

Leaky spill valve on karcher pressure washer - Karcher G2650HHR Gas Pressure Washer


You should replace the thermal by-pass valve with a new kit, part number is 45803590 ... Karcher G2650HHR Gas Pressure Washer

Karcher pressure washer model HDS 755 - Karcher Pressure Washers


... Karcher Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0598 seconds