Having problems with your Karcher PSI Electric Pressure Washer ?

Attaching the spray wandto the unit it doesnt seem to want to thread to the attachment


Answers :

Repair Help & Product Troubleshooting for Karcher PSI Electric Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Attaching the spray wandto the unit it doesnt seem to want to thread to the attachment


... Karcher PSI Electric Pressure Washer

The rubber hose from the solenoid to the rectanglar shaped box on the side of the unit where the water goes into the unit. the rubber hose has water comming out when unattached for the side of the unit, however when reattached water gurgles and sprays out of the rectangular shaped box that takes the water into the unit. unit seems to operate fine, just leaks really really bad from the attachement point outside unit.....


... Whirlpool 24 in. DU927QWD Built-in Dishwasher

My Kitchen Aid KUDS01DJSS0 seems to have water going to the upper spray arm (I see water coming out of the unit just beneath the upper rack), but the pressure doesn't seem to be high enough to clean the upper rack. No evidence that water is coming out of the spray arm on the very top. Lower rack dishes seem to clean OK. I have already removed the whole upper spray arm assembly and inspected the flapper valves that the middle sprayer goes into. I suspect that it's not making good enough contac


... KitchenAid Dishwashers

The unit goes through its cycles but the top rack is not getting clean. The bottom spray wheel works, the middle and top spray arms are getting water but it seems not enough to make them rotate. The pump screens are clear and there seems to be enough water. Whats going on?


The problem is likely to be that the jets in the rotor arm are blocked.\012\012To check this, remove the arm (it is easy to do, as it is intended for the user to do this) and clean out all the holes. Try running water from you tap through ... Dishwashers

My Kitchen Aid KUDS01FLSS2 dishwasher does not spray water thru the wash arms nor do they seem to turn. Additionally, one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" when rotated by hand. The spray arm assembly appears true on visual examination. The unit fills, cycles and pumps out in an apparent normal way. While on this site a while back I was advised to clean the unit and referred to a downloadable repair manual that was, in fact, not


Hi.The fact that "one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" would suggest a tubing problem. However there are more faults that will result in no spray. Testing in this case can be ... KitchenAid Dishwashers

NEFF S4443 top spray bar not rotating, no water. Bottom spray bar rotates and sprays water. Checked and replaced fine/course mesh filters. Will pump to empty and refill on pre-wash (rinse). Seems the pump may have two outlets one feeding the bottom spay bar (nearest from of machine) and one just behind which feeds the upper spray bar. Running without spar bars attached (including mechanism feeding to bar, water is only being forced out of the from outlet. Any ideas before I start taking it apart


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

I have a neff dishwasher that is maybe 5 years old. im pretty sure there is nothing wrong with it as it was working perfectly fine before i had a plumbing problem a few days ago. after the plumbing problem was fixed the dishwasher doesnt seem to want to fill any longer. it sounds like it wants to work but its just not filling and going thru the cycle. does it just need to be reset or something? im not sure of the model number as ive misplaced the directions for it. could you please help? by the


Look for the connection from the valve to the inlet of diswasher. Check the hot water valve to be on. It is probably closed when anyone working on the plumping. Good luck. ... Neff 24 in. S5443X2 Built-in Dishwasher

My Karcher 411A seems to have lost pressure. Behaviour is this, when you press the water release on the spray gun you get 100% pressure for like 10 seconds and then it seems to dwindle down to 30-40% of its total pressure. When the pressure cuts down I can hear more noise coming from the gun sprayer aswell. So not sure if the problem is in the gun or the main pump unit ?


Sounds more like a clog on the intake side. Check the filter and the hose on that side. ... Pressure Washers

The unit fills up with water but the circulation pump wont turn on. if i jump the pump it works. the pump is connected to the timer board. is there any sensor that would cuase the timer board not to turn on the circulation pump. this unit seems to be manufactured by ASKO mod. DW20.3 i dont want to replace the board ($375.00) if not nessary. thank you


Hi\015\012\015\012\015\012Thanks for using FixYa. There is no sensor on your dishwasher for drainage purpose however, it uses a drain solenoid to open and close the dishwasher drain port. If this \015\012solenoid ... Dishwashers

Dishwasher seems to slowly fill up with water when the unit is off. Seems as if the water valve doesnt shut off poperly.....what might be the problem?


Most likely the water valve is contaminated with calcium deposits, preventing the valve from seating properly.\015\012\015\012Possibly you could remove the water valve, remove the electrical coils and soak it in a household Calcium/Lime/R ... Bosch 24 in. SHX57C05UC Stainless Steel Built-in Dishwasher

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

I have a Karcher K3.91M pressure washer that pulsates when the trigger is released (off). It works fine when turned on, pressure seems OK. Before this started the unit would just turn off until I again wanted to use it. Is it a problem ? Correctable? All connections seem tight & I see no leakage.


... Karcher K 5.85 M Electric Pressure Washer

I have a Crosley CDU 600 V under counter dishwasher and it seems to be leaking from around a fly-wheel that attaches between an aluminum pump and a plasic housing. Can I tighten it? It looks to have a plastic nut on it and says "left hand threads"


... Crosley 24 in. CDU600 Built-in Dishwasher

Dish washer is leaking soap suds from bottom of door and doesnt seem to want to drain


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Water will not drain out ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Bosch Exxcel model number SGS46E12GB had the check water light on a week ago, checked supply and cleaned filters, all good. light still on, got upset and slammed the door, light off. since then the unit will either wash stuff, or not. didn't seem the arms were spraying very well when I opened the door, so I bypassed the door switch tonight and put it through a pre rinse cycle. (I ran it with the bottom filters removed) upshot is the pressure of water was really poor. also, when I first turned


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

I have a portable dishwasher. Where it connects to the faucet it is leaking and spraying water when i turn on the water. It doesnt seem to connect fully to the faucet


... Maytag 24" Tall Tub Portable Dishwasher - Black

Unit fills with water Spray arms do not turn all other clcles seem to work


Hi,\012When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher ... Dishwashers

Kenmoore Quiet quard 3 Model #665.74363K1 Serial #FS3502091 The unit will not drain properly. When in drain mode, it will drain slowly when diconnected from the disposal and lowerd to floor, and drains even slower at disposal level, or hooked to disposal. Disposal nipple is clear. I removed the hose and flushed it out with high pressure, found no blockages, hose flows freely and did not fix the problem. The motor is turning and seems to pump water fine, all wands are truning with powerfull spray


... Kenmore Dishwashers

No water? Unit is approximately 2 years old. Used once daily. Heats, but does not seem to be filling with water or spraying water through the cleaning chamber.


If there's no water entering your dishwasher, check these:Water-inlet valve ... Dishwashers

Our dishwasher doesnt seem to be cleaaning the dishes properly. After the cycle soap residue remains on the door and bottom of the unit and the dishes are not getting clean. I have checked the supply line and discharge for blokage but both are clear. what should I be looking for?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

ONE OF THE SPRAY HEADS IN PATIO ATTACHMENT SEEMS BLOCKED


Simple. find the smallest drill bit to fit the hole and run bit thru it. wala. ... Karcher 2500 PSI Pressure Washer

We have a Haier dishwasher and the capacitor burned out. The mahcines are sold at Argos and Comet but I can't source a replacment part which seems kind of crazy. It is out of Warranty and comet can't help. The capacitor is 5uv and has 2 pins. There are generic alternatives with 4 pins. Comets spare part place doesn't sell the capacitors separately and don't know if they come as part of a wider unit. Can anyone help I understand these parts cost about £6 and don't want the expense of a new


... Haier Dishwashers

NEED PARTS TO HOLD UPPER SPRAY ARM ON MODEL: FDB4315LFSO WHITE INSERT WILL NOT LOCK INTO THREADED UPPER UNIT?? PC MISSING ??ARM ISELF IS 9" LONG AND HAS NUMBER 1644681 ON IT. ONLINE SITES CAN'T IDENTIFY IT?


... Frigidaire Dishwashers

The model number I have is LD 1415ti doesnt want to pump any water but all other functions seem ok is this likely to mean a replacement pump?


... LG Dishwashers

Maytag diswasher MDB6600AWW Sprayer arms don't spin. Dishwasher makes all the right noises, except for spraying. Water fills properly and heats up. Water drains properly. Found paper on the back of access panel. Ran Manual Function and Field Service tests, no problems indicated. Disassembled all the pieces inside the bottom of the dishwasher. No obviously damaged parts. Shaft for motor turns freely. It seems like the parts that attach from the impeller to the motor shaft don't


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1196 seconds