Having problems with your Karcher PSI Electric Pressure Washer ?

My karcher has a hole in hose close to unit can i cut it and put back in


Answers :

If the hole is in the gun hose then no.
\012it will need to be replaced. try bunnings warehouse.
\012you may need to purchase the gun & hose together.
Repair Help & Product Troubleshooting for Karcher PSI Electric Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My karcher has a hole in hose close to unit can i cut it and put back in


If the hole is in the gun hose then no.\012it will need to be replaced. try bunnings warehouse.\012you may need to purchase the gun & hose together. ... Karcher PSI Electric Pressure Washer

Karcher K386M-I was using the washer and the pressure hose popped off the outlet of the unit. I put it back on and it popped out again. The second time I noticed the oring was gone. It was on there when I first put the hose on. Why does the pressre hose pop off.It was on tight?


... Pressure Washers

Attempting to put the electric 1400 psi back together but hose handle portion inside washer unit will not allow the unit to be closed entirely. Model # 2.55


... Pressure Washers

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

Maytag MDB8859AWS, cover latch that's a part of the detergent dispenser came entirely out of the hole that the long spindle on the end of the cover latch fits into it. Does this mean the part's broken? Now the detergent dispenser won't open automatically. I can TRY and close the cover after I put the cover latch's long spindle back in the hole, but something doesn't seem right. Only three months old!


... Maytag MDB8859AWS Stainless Steel Dishwasher

Hello there, I have a Bosch Logixx dishwasher which I purchased just over 2 years ago. My upper dishwasher tray is not fitting properly into the hose pipe holes on the inside of the back wall of the dishwasher. It has a movable plastic mechanism sort of fitting which is dropping off everytime I open the tray to keep the utensils and unable to close it fully until I re-adjust the plastic to fit into the holes proeperly and then it works. I am not sure how to fix the problem, do I need an En


Hello Deepak,\015\012\015\012You can definitely fix this yourself, but I'm not entirely sure from your description which part is "dropping off". It may be a simple fix where something needs to be clipped back into place or you may need to ... Bosch 24 in. SGS69L02 Logixx Built-in Dishwasher

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

Maytag Quiet Series 100 Help - diswasher always has water in the bottom - doesn't fully drain. We took apart as far as we could down to the hole with the orange washer _ no obstruction. Put it back together and we underneath - and removed drain hose - and checked the drain as far as we could reach behine the anti syphon - no obsturction - wha should we try next?


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa.\015\012Dishwasher not draining properly or not draining at all issues can arise due\015\012to different reasons. Usually, these issues are related to kinked hoses,\015\012knocked o ... Maytag 24 in. MDB5651A Built-in Dishwasher

Whirlpool Dishwasher had to replace the discharge hose on my dishwasher. After I put everything back together we went out for dinner while it ran thru a cycle. We returend to find the bottom of the unit full of water. Can you tell me why and how to solve this problem? Thank you for your time. Jeff


Did you route the hose with a loop in it ...? is the water dirty or fresh? I can help ... Whirlpool GU2400XTP Built-in Dishwasher

Installation Question Instructions refer to two flexible hoses; there is one hose with the unit, and just one port on the unit. There are two adapters, instructions say put one on each hose. Hose came with one adapter already in place. Am I supposed to put the other adapter on the other end of the hose?


... Amana APO8JR 8,000 BTU Portable Air Conditioner"

LDS4821WW loses water in wash and rinse cyle then gives E1 error. there are no leaks on the floor.The drain hose is looped high at the back of unit. so the unit is doubled looped first loop is at the side attached to the unit then the second is at the back of unit then to drain.


... LG LDS4821WW 24 in. Built-in Dishwasher

My portable dishwasher hose that attaches to the faucet is to short for where I want my portable dishwasher to sit. I would like for it to sit in one spot. I am not allowed to alter or cut holes in the side of cabinets, I am renting. Is there an extension for the hose to the faucet? If not, what can I do to make the hose longer? If I really have to I will cut the two hoses that comes from the dishwasher to the faucet, but I would rather have an extension first.


You should be able to find extension or replacement hoses that you can use to extend the existing hoses at a hardware store. If you need to join two hoses that have female connectors, adaptors with two male connections are available. ... Dishwashers

Soap door on my Whirlpool dishwasher model # DU810SWKU0 does not open.I had inner door off to check rinse agent problem.Is there something i did putting inner door back on? If I close soap door and turn timer knob on outside of door the soap door will open after I make two full turns of the knob.If this cant be fixed can I just put soap in the bottom tray that has no door or put soap in both trays and do not close the soap door? Thank You RH.


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I bought a house with a Bosch dishwasher in it and soon found that the top spinner holes are blocked with bits of old labels. I have removed the spinner and separated the concentric tubes but I do not see how to push the debris back along to the inlet. Do I need a power but very small jet to put into the holes along the arm? Would drying it then putting the suction of a vacuum over the inlet hole be useful?


This is very common if the filters are not cleaned regulary if you remove the arms and soak them in hot soapy water for around half an hour this should loosen the debris also tap them on the side of the sink this will remove more stubborn debris ,ref ... Bosch Dishwashers

There are two hoses coming from my Bosch SHE45M06UC dishwasher. One is obviously the drain coming from the back of the unit, and the other is attached to the side looped and not connected to anything. I went online to the Bosch website for a installation manual and it describes this hose as a air venting hose. Does the end attach anywhere or does it just hang loose on the unit. My husband detached it from its original position and thought it was part of the water line. HELP!


Many people realize the dishwasher connects to a little hose on the sink, it is called an air gap. However, many people wonder " The air gap is there to prevent the water from being siphoned out of the dishwasher. When water flows through the drain ... Bosch Dishwashers

I have a bosch dishwasher model number SGS0902GB/05. I use tablets instead of detergent. I put the tablet in the Dispenser and close the lid, noproblem. I then set the programme and shut the door, I usually set the programme to delay start so that it washes dishes in the small hours when all are in bed, however, when I have set the programme and close the door within a minute the dispenser assembly opens and the tablet falls into the dishwasher, I then try and put the tablet back in the dispe


Hello Andrew,\015\012\015\012I'm more than happy to give step-by-step instructions for replacing the detergent dispenser, however it's not cheap (about \302\24350) and it probably doesn't need to be replaced. Some of the smaller component ... Bosch Dishwashers

The pressure tower came off. I don't know where it came from, nor how to put it back on! It's so tall, it looks like the racks won't close once it's in somewhere. I have no idea how to put it back inside the dishwasher.


With a model # it's hard to give good help but when they ware out the can blow the tower . . you can replace the tower assem ( if ge it will come with lower wash arm other brand it will not .. mm hope this ... Dishwashers

Mod #: MDB6600AWB Ser #: 16505148CG No water comes out of spray arms, checked and cleaned filter-OK. Wash impeller is cracked where it slides onto the hexagon rod but it you take the filter flow plate off and put the impeller back on, when you put the unit on rinse only and quickly open the door you can see it is still turning and moving the water. The unit still fills and drains. it just does not have enough force with the impeller to force the water into the spray arms.


Hi,\015\012 \015\012Please check the bellow link regarding your query....\015\012 \015\012 ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Water leaks from underneath the unit. Water only leaks when the pump cuts on (pressurizes). It leaks down on to the hose connecting to the water inlet valve on the right hand side of the unit when looking at the door of the unit. When the unit is full of water and the motor / pump is not running the unit does not leak. This unit is a Maytag jetclean dishwasher Model DWU9200BAB about 12 years old


Please change the 'o'rings of drain line and the inlet and also check the drain hose and the inlet if there are any holes in it ... Dishwashers

Pressure hose wont stay attached to karcher unit


... Karcher K3.540 Electric Pressure Washer

Unicoupler on hose fell apart. How can I put it back together?


... Kenmore Dishwashers

Hi, I have a Karcher K3 pressure washer. 18 months old, used maybe 6 hours total. For the past 3 hours of use the compressor/pump seems to cycle audibly but pressure at outlet hose seems constant, hence I did'nt worry. Now it does not start with switch on. I now hear a buzzing sound from the unit. The unit was last used 6 weeks ago. The unit was stored in the garage away from frost, it does not leak water so I don't think there is any frost damage, but just this buzz. Any suggestions would


... Karcher K3.68MR Electric Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0933 seconds