Having problems with your Karcher Rotary Nozzle ?

Rotating dirt blaster nozzle, bought new, 1st day works fine, a few days later the nozzle blows out in a bigger slower circle???


Answers :

I fixed mine works good easy too watch my video step by step i put it on youtube
http://www.youtube.com/watch?v=UFXSLOBL0Mg
Repair Help & Product Troubleshooting for Karcher Rotary Nozzle

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rotating dirt blaster nozzle, bought new, 1st day works fine, a few days later the nozzle blows out in a bigger slower circle???


I fixed mine works good easy too watch my video step by step i put it on youtube ... Karcher Rotary Nozzle

I have a 1993 Frigidaire dishwasher than ran and worked perfect up till the other day. I put it on and in the morning I realized it had stopped at about 5 oclock on the cycle circle. The water had not drained away. I reshut the door but it didn't work. Then I reset it to start but it didn't work.


HAVE THE HEATING ELEMENT TESTED WITH MULTIMETER ... (TURN UNIT OFF FIRST) BSC APPLIANCES 07779933829 ... Frigidaire Dishwashers

I have a whirlpool GU1200 that I purchased on Craig's List. The unit worked fine for a few months. Then, I removed it to replace the floor. When I reinstalled it a few days later, it only works in quick wash and pots and pans modes. Some of the other panel options don't seem to work any longer either. Any ideas?


... Whirlpool GU1200XTKS Dishwasher

Frigidaire FDB126RBS2 Washer stopped working mid-cycle. Then a few hours later began washing again. Ran a load a day for another week before it happened again. It ran and stopped at Light Wash, then a few hours later started again and stopped mid-way through the rinse cycle. It has no power now and will not start again.


Be very careful, it sounds like an electrical failure, were the machine has cut out to protect you and itself. You need an expert there and quickly. Water and electric are a bad mix and more house fires are caused by washers than most other appliance ... Dishwashers

Husky Model HU80833 pressure washer was working, then no pressure. What is wrong? Unit is over two years old. Had been working properly earlier in day. While trying to finish job, it lost pressure and nothing would make it get back up to pressure. Also tried it again later, same result


... Honda Pressure Washers

I have a stihl water blaster RE170. the nozzle (water comes out in a circle) not longer works effectively - most times coming out as a point rather than a circular fashion. Do i have to buy a new nozzle or is there something I can do to fix it?


... Pressure Washers

I have a Hot Point dishwasher. Model HDA499M-02. When I turn the knob it seems like it is going to start up. But then it stops and will not work. I gave up on it and then a few days later it worked again. And when I tried to use it again it did the same thing as before.


... Hotpoint Dishwashers

Kenmore dishwasher model #: 15829000 It will fill & heat, but won't run/wash on any cycle. I was told the motor may be frozen or jammed by an object, but am not sure how to get to it. I assume i have to remove the lower spray arm assembly? Could there be another reason? This happened before, but it began working fine again a day later. It has worked fine since for almost a year now.


There should be a 665. xxx etc as the model no. before teh 15829000 that you have mentioned.\015\012Will need the full model no. of your dishwasher in order to give you some solutions for the problem. If you are not hearing any sound at the tim ... Dishwashers

I have a Kenmore, Stock 15649, approximately 14 - 15 yrs old that worked fine until the past few days. The upper rack doesn't appear to be getting any water, as bowls and glasses are still dirty after being washed. It appears as though water would spray from the bottom, through a "nozzle" in the middle of the lower rack, then go to an arm located underneath the upper rack. I haven't noticed any obstructions in this path that would inhibit the water from spraying. Any suggestions (outsid


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

My Scout 135 Extra pressure washer worked fine and 20 min. later the burner will not start. The fuel nozzle sprays fuel but the ignitor will not spark. How do I check the transformer to determine if it has power and if it is sending power to the ignitor?


... Northstar Pressure Washers

Hei, I just bought a FI 100 dishwasher and it work well for two days, but now it starts a circle but does not stop, can you help me with his?


... Fagor FI-200 Dishwasher

We have a SGS53C12 - The water is not draining we have cleaned filters. Sometimes this works but a few days later it blocks again. The programme runs to the end of its cycle but water still there. Is there anything else we can try? We bought dishwasher June 2007.


... Bosch Dishwashers

I have a Kenmore model 665. It is having an intermittent problem. It goes through the fill cycle, and then stops. Timer does not progress either. Then, at some random moment, it will come back on and finish the entire cycle. This could even be a day or two later. Sometimes it seems a nearby thump will set it off, other times no one is anywhere near it when it comes back on. This happened for a month or so off and on 6 months ago, and then it worked fine for 6 months. Now it's back to it.


Its possible its a door switch thats causing this or the main wire is loose..be careful as you do have 115 volts. i'd turn off power and check where power comes into d/.w and make sure the wire nuts are tight.. the next step is a little more difficul ... Dishwashers

Built in model MDB5601AWB- about 3 years old. The touch panel stopped working..no lights would come on when touched. Tried it a couple of days later. Lights came on..finished a cycle. after satying in the wash mode for a few hours. Then lights started flashing on and off. At that point I shut it off at fuse box since I couldn't get lights to stop blinking and haven't trusted to use since


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. From what you have described it seems to be the ... Maytag Dishwashers

I have a Maytag quiet series 300, model # MDBTT60AWW. The front control panel have some green lights on but the start/cancel button won't work. The dishwasher will work for 5 days and quit for 2-3 days then work again. I tried to reset the main electrical panel hoping the dishwasher will reset too but it didn't work. I opened the panel on the front door to see if water is getting into the electronic panel but it is dry. I'm wondering if it is the front control panel itself is the problem. I want


... Maytag Dishwashers

The hidden control panel has only about half the lights showing what function is pressed. A couple of days ago the washer would not start. The only function which would work was the far left sensor light. After trying to cut power and pushing other buttons, to no avail, we let the machine sit a couple days. It now works again with only half the lights on function pad working. It acts like there was a electrical short.


First retrieve the tech spec sheet behind the toe-kick panel located near the floor and run the diagnostics if it will let you do so w/o the full operation of the keys on the pad,then if it wont the touchpad or keyboard on the front that you use to s ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

At the beginning the pressure washer was running but there was no power from the nozzle. I stop the gun trigger, remove the nozzle , it works for 1 minute and stop working again Now the washher pressure turns off on its own after 1 minute or less Honda 2400 psi


See attached link:\015\012http://www.wmpcs.com/index.php?main_page=page&id=14\015\012\015\012If you continue to have the problem you m ... Honda Karcher G2400HH-R Pressure Washer

No high pressure. has been a consistant problem for a while. Was able to get high pressure to "kick-in" before by removing nozzle, squeezing trigger to "prime" high pressure, then quickly put nozzle back in then it would work. now it doesn't work at all.


See this link to fix the problem ... Honda Karcher G2400HH-R Pressure Washer

The karcher pressure washer was working one day then just stopped working the next day .Thepower light comes on when i press the on switch but nothing happens .So the power is getting to it but will just not fire up .Please could you advise


... Karcher Pressure Washers

Good morning. I have a KitchenAid KUDM01TJ with a constantly flashing "Rinse" light. when I hit the "Cancel" button, it too flashes in the same time with the Rinse light. I left the machine alone, came back a few days later and saw that the issue had resolved itself - but I didn't use the machine. A few days later, the "Rinse" light was flashing again and naturally, I hit "Cancel" to see if the same thing happened and it did. This time the lamps are still flashing. I read through the other repo


No its not the problem of button secquence.its the problem of keypad circuit this is creating this problem.as the circuit is getting overheated and it stops working.the key pad sometimes functions and sometiomes doesnot.in this case the key pad circ ... Dishwashers

I have a ge profile quietpower 7 dishwasher. its built in.cannot find manuel and cannot find the serial number anywhere on the dishwasher..i need either your help with serial number or help with why water will not go into the dishwasher. motor runs water decided it wont go in. one day worked perfect and next day stopped working.


Hi\015\012\015\012This is often caused due to the fill valve. You can ... GE Dishwashers

I have an 8 year-old Kenmore 665.16912 dishwasher. Worked fine until two days ago. Then it stopped working altogether: nothing lights up on the front panel. I have checked the 120 in the electrical box, the door switch is working, the thermal fuse is working and there is 120 volts at the white and black connections to the timer control board. I bought a new timer control board for $120 and that did not fix the problem. What else could be causing the unit to completely stop working?


If all are really good then the only thing it con be is the display (8269205) $25.00 part, if it's bad dishwasher wont run ... Kenmore 16912 Built-in Dishwasher

Hi, We have a Smeg ST 663 dishwasher that does work. However, sometimes when you want to use it and turn the power button on it beeps twice with the red light flashing and you can't get it to work or change the settings. Sometimes if we leave it for a while and try it again later it will work, but it is annoying as sometimes it won't want to work for ages and we really want our dishes cleaned! The dishwasher doesn't have many buttons on it (a power button, cycle selection button and 1/2 load


Hi,\015\012\015\012Turn machine on and press and hold the programme select button till the light goes out about 5-7 seconds see if this resets it if it does start a cycle and see what happens.Otherwise the pcb as its not responding to an ... Smeg Dishwashers

I have had an E24 error message on my Siemens freestanding dishwasher. As well as the Error message the the little tap sign lights up too. Up until now the problem has occurred around 1 in 3 attempts and mainly at night but not in the day. When it does work the washer works perfectly and washes well. Today it will not work at all. The error always comes up 2 minutes into any cycle. I've tried turning the water feed off and on and in the past this has worked. It sounds like no water is gettin


Hi Steve\015\012\015\012E24 error normally indicates failure to drain, the first\015\012thing to check is that the water is actually being supplied to the appliance\015\012and is turned on. If it is then check the water inlet valve, if th ... Siemens 24 in. SE25T250 Free-Standing Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


THE TECH WHO CAME TO FIX MY DISHWASHER FROM Y=THIS EXACT PROBLEM TOLD ME THAT IT IS CAUSED BY THE WATER THAT TAKES TOO MUCH TIME TO GET WARM, SO YOU HAVE TO MAKE SURE THE WATER IS NOT GOING TO BE COLD BEFORE YOU TURN THE DISHWASHER ON. AS TO FIXING I ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0691 seconds