Having problems with your Kenmore 13719 / 13712 Built-in Dishwasher ?

My kenmore 665.13719k601 fills with water when I turn it on, but then just makes a humming sound, not moving the arms around. It drains fine when I hit cancel. I presume that means the motor is broken down inside? I've taken apart everything I can down to the food mincer, but I can't get past that. How would I proceed here?


Answers :

Repair Help & Product Troubleshooting for Kenmore 13719 / 13712 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My kenmore 665.13719k601 fills with water when I turn it on, but then just makes a humming sound, not moving the arms around. It drains fine when I hit cancel. I presume that means the motor is broken down inside? I've taken apart everything I can down to the food mincer, but I can't get past that. How would I proceed here?


... Kenmore 13719 / 13712 Built-in Dishwasher

Maytag DWU6402AAB dishwasher hums but motor does not run. I've taken the inside apart down to the disk-shaped impeller. It turns freely so the pump and motor are not stuck. When control knob is turned motor hums at the places where it normally should run. The water valve & heating coil seem to be operationg normally. i assume the next step is to test the motor &/or motor relay. Is this correct and how do I do that?


... Dishwashers

My Kenmore Elite UtraWash Dishwasher won't drain completely. We have checked the hoses (water supply and drain connected to the disposal) - both are free of obstructions. We have taken the whole thing apart but can't get the plastic cover off to access the motor or "garbage disposal thingy" inside the dishwasher. All of the bolts were taken out, but it was still firmly attached. Didn't want to force it and potentially make the problem worse. Any suggestions before I call Sears Repair people


I have the same problem. The part you're talking about can be released from under the dishwasher to clean it. www.searspartsdirect.com has useful diagrams. I cleaned everyt ... Dishwashers

No pressure i have a karcher g 2600 vh i wasnt getting pressure and i found that my spill valve was faulty it was actually broken i bought a new one installed it and im still not getting much better pressure ive taken the pump apart and checked for build ups blew thru the valves wirh the compressor and there appear to be no blockages


... Karcher G 2600 VH Gas Pressure Washer

I have a model 5000g. it might have 15 hrs. total running time on it. when i tried to use it last it would not build pressure. i took the pump apart and cleaned and regreased it. everything looked good. ive got good pressure to the pump but just a small spray out the wand. when running there is no real load on the engine. it has always been kept inside in a warm enviorment.


... Karcher Pressure Washers

Whirlpool dishwasher top spinner and top rack spinner is not putting out water or very little and not spinning. I have taken apart and cleaned everything including the sump / chopper, can't find any blockage in the tubes that deliver water from the pump to the spinners. Is the Pump or Motor done? how can that be it's less than 5 years old? Its a Whirlpool Quiet Partner I Model DU1055XTPQ3


First, confirm that the holes are not blocked on these arms. (I did not want to assume you have done this.)Then check the impeller on top of the motor stem for being loose or worn/damaged - to rule the impeller out. If it is fine, then ... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Buzzing sound we have a gold quiet lll edition , it is now buzzing when we start it. we have had a repair man here twice each time he has taken it apart and cleaned it. he has said because we have hard water, the water oxidized and some sediment has broke though the seal into the motor and now we need a new motor. does this sound right? we have had dishwashers from whirlpool for years prior. never had to change a motor. please can you offer some suggestions? thanks very much desperate in Mexico.


If buzzing while it is washing then probably is a motor problem but mostly not from hard water just poor quality parts ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

I'm trying to fix a whirlpool du980qpdq6 dishwasher. The door on the soap dispenser won't open. I've checked the latch and it works...no blockage. I've taken the door apart and looked at the Wax motor in the door. Apparently that is what actuates the mechanism that opens the door. Does anyone know how to test the wax motor to see if it is functioning?


... Dishwashers

Kenmore Dishwasher 665.1383 is about 4 years old. The past 2 months it has developed a strong plastic or chemical smell. The smell has tainted brand new glasses that then have the odor when they are taken from the shelf to use. It is very strong during use and can be smelled throughout the house. I have taken everything out down to the screen to look for debris or anything that could cause the smell. I have tried the vinegar remedy and also scrubbed the entire inside with bleach. Nothing


That's not the full model number,there should be four more numbers.anyway does it have a heating element in the bottom of the tub,if so feel it with your hands,a piece of plastic could of hit it and is still melting when you run it,you can try using ... Dishwashers

I have a Whirlpool dishwasher (model DU890SWKQO). I turned it on and for a few minutes only the motor was running, no water. I opened the dishwasher to stop it and turn it off, then on again. When I opened it, the was an odor (burning or heat smell) and it was foggy (steam or smoke, not sure which) inside. I am assuming I did not turn the dial correctly so it only 'clicked' on the motor. Concerned now that the dishwasher is broken or concerned that it's not safe to use. Was the steam/smoke


... Dishwashers

I have a kenmore DW model 16019. The clean Light stays on the light does not turn off. I have tried to disconnect and have taken the motort apart to make sure everything is clean. What Can I do to solve this problem? 1. Does the washer work at all? No it does not work 2. Does it display any codes or flashing lights other than the CLEAN LIGHT being lit? no other lights are on except for the green blinking light 3. Is the light solid or blinking? blinking Green light 4. Entire model # is necessary


Thanks for re-posting with all the info!!The model # is 665.16019403The cleaning light blinking is a fault code listed in the tech. service sheet, its usually a faulty heating circuit.The sheet can be found behind the ki ... Kenmore Dishwashers

I have a kenmore DW model 16019. The clean Light stays on the light does not turn off. I have tried to disconnect and have taken the motort apart to make sure everything is clean. What Can I do to solve this problem?


Please accept this answer - and re-post your question with the following information:1. Does the washer work at all?2. Does it display any codes or flashing lights other than the CLEAN LIGHT being lit?3. Is the ... Dishwashers

I have just bought a house with this dishwasher. The first couple weeks it was fine, now not all of the water will drain. Ive taken it all apart and cleaned it but after washing there is about 2cm of dirty water covering the bottom. It happens with both but usually only one at a time. I have read horrible things about the dish draw, what could the problem be? Help Please


The most common cause of problems on dishwashers installed by the builder are Installation issues. Usually, the drain hose is kinked and food particles accumulates on the hose until it clogs completely.If you are planning to fix it by yo ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Dishwasher is not cleaning well, dirty film all over everything, like its not rinsing. In rinse cycle only, some water comes out of lower left port inside but nothing else. Hear a low buzz underneath unit like a motor or pump is energized but no water getting to the top.During normal wash cycle, buzz from underneath seems to cycle on and off, say every minute or so like its cycling on an overload. Do I have a bad pump and if so how do I get to it?


Hi. This may well be a pump issue, or an obstructed hose assembly, as well. Your symptoms are indicating that the impeller may be damaged. In order to pull the necessary schematics, I will need the entire model number. This ID tag will allow me to pu ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

My GE Nautilus will not drain. I have taken out the covers on the inside to check for blockage and there is none. I took the cover off the lower portion to check if motor is turning and I am not certain that the grinder is grinding. Any help out there with this problem and what parts do I need to fix it?


Do you hear the pump running? i dont like the idea of calling it a grinder.....things can still cause your pump to clog need to unassemble from the inside and check pump...also check drain hose for clogs. mac and cheese is a stinky mess. ... GE Nautilus 24" Built-in Dishwasher

My general electric model number pdw8200j03ww dishwasher continually leaves my glasses with small food particles in the inside. i am not sure where i need to ''cleaning'' the diswasher out to get rid of this problem. i am also not sure to take everything apart


... GE Dishwashers

The dishwasher is making a "buzzing" type of noise. I've taken out everything and it's still doing it--seems to be coming from the motor.


You'll need to clean and possibly replace the chopper and/or impeller.To get to the chopper you need to remove all parts you can from the pump assembly inside the dishwasher.To get to the impeller you'll need to pull the dishwasher out and remo ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

All aspects of the dishwasher work except the wash motor/pump does not run. Is it the motor? I have taken the lower arm assembly apart and removed the support to spin the impeller. It spins fine although there is axial play.


If the shaft is moveing from side to side you need to replace the motor. did you tern the impeller around about 3 complet terns? ... Dishwashers

The door handle is broken which enables the opening of the door. Therefor we can't open the door and need to replace the handle but dont know how . The handle is situated inside the door and there are no screws around it to to take it apart. It is an Indiset DG5000 model. There are screws at the edges of the door.


I had a similar problem with a similar model.\015\012Insert a fine screwdriver into the small space immediately abive the handle. Press the inside end down firmly and the lock should release.\015\012I ran mine for about 3 weeks, this wa ... Dishwashers

I have a maytag dishwasher mdb5600awb. it is about 5 years old. it does not clean anything on the top shelf for the most part. i took everything apart and found nothing that was clogged. we tried a rinse agent and that didnt help. for 460 dollars i expected more out of this. i also had the motor replaced 3 years ago. can someone give me an idea why i cant get my dishwasher to wash dishes?


Replace the dock at the back if it is missing a piece. That solved my problem with the top rack not getting clean. ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Westinghouse undercounter dishwasher. after shutting door with latch, comes on when dial knob turned to selected wash. was taken out to redo floor underneath. after being placed back in position, did at least 2 loads fine. now after dial knob gets to selected wash, dishwasher light comes on and i can hear the motor try but then starts clicking. there is also water at the bottom inside the dishwasher


This seems to be a drainage problem, obviously. There may be some food debris in the drain tube where it connects to the drain pipe. It would be easy to detach and do a visual check, and see if you can clear the clog. Also, try to s ... Dishwashers

Whirlpool Dishwasher (DU800CWDB1)does not drain. Have taken everything apart, cleaned, tested.. same problem.


If you have cleaned the pump and outlet hose and it still wont work, Have you checked that the drain it is connected to is not pluged up ? Is the motor running during the time it should be draining out ? The way they work is one direction for wash an ... Whirlpool 24 in. DU800CWD Built-in Dishwasher

Frigidaire Dishwasher won't start (lights cycle but no water/motor) Model Number: FDB1050REB2 Brand: Frigidaire Our dishwasher is 1.25 years old and already not working (grrr!). When it is turned on, the lights cycle through like a normal wash cycle, but the motor isn't engaged nor does any water cycle through. This happened about a month ago and I took everything apart to make sure all of the connections were secure and it started working again...not this time. Any ideas?


... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0928 seconds