Having problems with your Kenmore 13722 / 13724 / 13729 Built-in Dishwasher ?

I have dish washer detergent (powder) sitting in the bottom of my dishwasher. The washer goes through the entire wash/rinse cycle, but the soap is not desolving.


Answers :

Hi,
\012


\012

I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying...
\012


Dishwasher Spray Arms not Spinning

How to Buy Appliance Parts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

Dishwasher Maintenance

heatman101

Asker

\015
Repair Help & Product Troubleshooting for Kenmore 13722 / 13724 / 13729 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have dish washer detergent (powder) sitting in the bottom of my dishwasher. The washer goes through the entire wash/rinse cycle, but the soap is not desolving.


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Kenmore 13722 / 13724 / 13729 Built-in Dishwasher

I am getting a clicking/ticking noise (1 click/second) from my Maytag (model MDB9100)dishwasher after it goes through its auto clean normal wash cycle. At the end of the cycle the arrow = clean and the clicking sound is there. I opened the washer door for about 1 minute noted the soap containers are empty, dishes clean, machine still hot/steamy. Closed the washer door and the clicking sound resumes. Please advise.


This is the heated dry timer going through the drying cycle until the dishes are dry. The dry cycle runs on a timer and it will click through the cycle until it finishes the amount of time preset on the timer to dry the dishes. ... Maytag MDB9100A Dishwasher

I have a kitchenaid dishwasher model kuds24se with a problem. I MUST hit cancel before I hit start. Note that it doesn't matter how long it's been since the last cycle. It could be a few minutes or a day or more. I have to hit start to get a complete wash cycle. If I don't hit cancel, the washer goes through some sort of cycle and stops. It seems like a normal cycle but of course it is not because I don't hear any water and, upon completion, when I open the door there is heat but the soap dispen


... KitchenAid KUDS24SE Built-in Dishwasher

I have a ge quiet power 3 and recentlly it wont desolve the soap at all. it goes through the cycles and all but the door for the soap opens and the soap just falls out.


... Dishwashers

Gld2445rfs2 frigidaire dish washer when i start wash cycle it goes for 30 min then PF lite comes on and soap dispenser will not open.But if i open the despenser door and start the wash all over it will complete the cycle. the problem is which part is bad??


... Frigidaire Dishwashers

Doesn't appear that the washer is running through its cycle. The soap packet isn't desolving and no water is on the plates. There was an incident when the washer tripped the circuit breaker, reset breaker and now it doesn't work. Is there anything I can do, or do I need to call service?


I think something went wrong with your motor or the inlet Solenoid valve. That was the reason for the trip.Take service center help!Hope you are getting power after resetting the trip. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

The soap dispenser opens while in cycle but it doesn't wash the dishes they come out greasy and the entire washer is dirty It does get hot but dishes come out dirty Model FP4702799 Serial KUDIO 1ELB L3


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

The water doesn't spray out and the paddles don't turn during the entire cycle leaves soap running down the door. The washer is a Crosley CDU450V model. I have already checked to make sure the holes in the paddles aren't plugged.


Lower arm does not spin ... Crosley CDU450 Dishwasher

Soap does not all desolve during wash cycle, there is always some left in the door. we use cascade. this dish washer is new and we have always had this problem.


This could be caused by hard water depending on where you live. Make sure you always use Jet Dry, run the hot water on your kitchen faucet for a few minutes before you start the dishwasher and if that doesnt work there are a few different dishwasher ... Kenmore 18 in. 14432 / 14439 Built-in Dishwasher

The dishwasher goes through the entire cycle and beeps when it is done, however no water ever enters the washer and the dishes are still dirty. What part needs replacing. Thank You Vince


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

Whirlpool adp8540 - goes throught the wash cycle without the soap door opening, the water gets into the soap box, and the powder or tablet (I've tried all the brands) are wet but remain in the soap box. When I flick the level on the soap box, works just fine, just doesn't happen during the wash cycle.


Normally, the dispenser is waterproof when closed, so the detergent should not get wet. Most likely the actuator of the dispenser works and does open the door, but something is blocking it from opening all the way. Look for stuff not it its place, ie ... Whirlpool Dishwashers

The washer cycle stopped without warning, i thought the timer or the timer motor but it is not the timer works fine and so is the motor. but the timer motor runs til the washer motor starts than is the timer stops and the washer is working but not cycling so no rince or drain or soap etc... just pumping water. if you can tell me what might be the problem, thank you. like i said the timer stops when the washer motor start.


... Jackson JPX-300L Dishwasher

Frigidaire model F71C12PHS0 is not washing, it goes through the cycle and when the door is opened the soap container is open with soap still in it. We have run it with the door open to see if it is spraying and it is. The heat is working because when we open it at the end of cycle it is hot. Yet soap is still there and dishes are not clean. Thanks to anyone who can help me trouble shoot this.


... Frigidaire 18 in. FDR252RB Built-in Dishwasher

Hello .i have a dish washer model du1010xtxq1.this is a brand new dishwasher. when i select the cycle it starts. and it runs for approx 8 min then it goes into drain cycle the red light goes on . then it drains when is finishn drainning it will shutt off. what can i do? i need help


We are having the same problem. Did you find out anything to help? ... Dishwashers

Soap problem When the drying cycle is done, you open the door and the soap is still there. It goes through the cycle and dishes has water on them just. We had taken out the pieces to clean because of the hard water we have. Thanks


Hi,You may have a problem with your heating element...if the water isn't staying hot the dishwasher ... Dishwashers

GE Harmony top load washer: The soap tray when filled with liquid soap will not properly dispense the soap when the water is filling the machine and the soap tray remains full of water and soap at the end of the cycle?


Hi\015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allow the door to open. The stri ... Dishwashers

Dishwasher soap remains in the soap dispenser following the complete cycle. I have had the washer for a year and a half. The first year, no soap remained in the dispenser. Now about 1/8th of the soap remains and the stainless under it still has a soap residue.


Try cleaning the soap dispenser with white vinegar so that it is free of all detergent, then try using about 1/4 less detergent than you have been to see if you still have any remaining in the dispenser. Also, make sure your drain filter is free of a ... Whirlpool Dishwashers

My G832SC is not draining at the end of the cycle. It runs the entire cycle, and the dishes appear to be clean. The soap dispenser has opened and the dishes are rinsed. However, the dry cycle doesn't run because the machine doesn't drain at the end. The intake/drain light is flashing. If I reset the machine and start a new cycle, it will perform an initial drain and the water level does go down. We checked the tri-filter and the valve pump thing, rinsed both. Checked the hose under the sink. We


... Miele Slimline G832SCi Built-in Dishwasher

Washer goes through complete cycle but doesnt totally drain. there is about 1 inch of dirty water left in washer. this washer is over 1 year old, kenmore ultra wash


Make sure your Drain Pipe is properly fixed . any Blockage in the Drain Pipe Creates the above mentioned Problem ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

When dishwasher is turned on to the cycle mode - it fills with water - heater heats water to the proper temp - pump starts - washer goes through it's complete cycle - even pumping out the wash water and the drying cycle,then shuts down. the problem is that it does not circulate the wash water thru. the spray heads-even though the circ,pump is running.Even though the unit is 8 yrs.old and hasn't run for 6 yrs,my wife&i do our dishes by hand. our unit is a GU1200XTKB0 Serial# FL4617501


The impeller on the wash pump is worn out or the disposer screen is obstructed. Disassemble as needed to investigate the cause. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

My hda3500n00bb fills with water switch goes through cycle but washer wont run


... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Soap suds and some water not draining out of washer after cycle is complete


If you read the manual, it states that this is normal.\015\012so dont let this bother you ... Danby DDW496W Free-Standing Dishwasher

When washer goes into spin cycle it over flows where the retainer hose goes in.


... LG Washer Wasing Machine Thermistor 6322fr2046c

My Miele Diamante G 2150 SCU is not completing a wash cycle. It starts and water goes into the dishwasher but it doesn't finish the cycle and the soap is still in the container.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1115 seconds