Having problems with your Kenmore 13743 Staimless Steel Built-in Dishwasher ?

Pots and pans and normal wash blinking

\015 I have a Kenmore dishwasher 13743K. The pots and pans and normal wash lights are blinking constantly. Will not stop and will not run. can you give me any advice.\015

Answers :

Try resetting it. Locate the switch in your breaker box, and flip it off- then on again. Hope that works!
Repair Help & Product Troubleshooting for Kenmore 13743 Staimless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore ultra wash quiet guard dishwasher, the pots and pans and the normal wash button are blinking. The start and cancel and smart wash out tons have a faint light glowing. Thoughts? I tried the sequence of pressing heated dry, normal wash, heated dry, normal wash and that did nothing. I've flipped the breaker too. I was in process of taking it apart to clean filter, thinking that would help, but lost my manual and now I can't get that off to flea either:(. Sig


... Kenmore 24 in. 15689 Built-in Dishwasher

"Quick Rinse" light blinks constantly, unable to select "start" unable to select "normal wash" sometimes can select "pots and pans" but still not able to start. Was working normally, when it stopped at end or pre-rinse to start the main washing cycle, the "quick rinse" light came on blinking, and no other button works except as described above. Thanks,


Hi,\015\012 \015\012Check out the console assembly. take off the inside cover and the plastic over the electronics, just remove the two screws holding down the circuit board, pull it to the side, then blow ... Dishwashers

Pots and pans and normal wash blinking


Try resetting it. Locate the switch in your breaker box, and flip it off- then on again. Hope that works! ... Kenmore 13743 Staimless Steel Built-in Dishwasher

Kenmore 13283K: blinking "Pots Pans" and "Normal Wash" lights


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Here again is my model and serial it stops in the middle of the cleaning cycle Kenmore 665.16773402 serial # ft0302854 Here is how I have been resetting the dishwasher. I hit the following sequence of buttons: Normal Wash Heated Dry Normal Wash Heated Dry Normal Wash After that ? all the lights are lit up as follows: Smart Wash, Pots Pans, Normal Wash, China Gentle, Turbo Zone, Hi Temp Wash, Sani Rinse, Heated Dry, Sanitized (Green light ? not a button), Lock on (Red Light ? no


Door latch.Open and close the door to make sure the door latch is securely fastened\015\012 \015\012Hi-Temp Wash, Hi-Temp Rinse, or Sanitize options.Some models have options that may requi ... Dishwashers

The three lights for Pots & Pans, Normal Wash, Econo Wash are all flashing. When I hold the start button down for four seconds, just the Normal light is on. However, once I close the door, all three lights are on again, and the dishwasher does not start. We have tried unpugging it and then plugging it in again. It worked once then went back to all three light flashing. Before this, only the Normal Wash and Econo Wash lights were flashing.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I can't seem to access any previous post dialog that may have taken place but I'd like to help if you can fill me in on whats taken place to this point.\015\012\015\012The scenario you describe i ... Viking DFB450 Dishwasher

I have a Kenmore Ultra Wash 15632/34/37/39. The Pots & Pans button is blinking constantly and I cannot Start the dishwasher. I tried pushing Hi-Temp, then Air Dry, then again. The sequence didn't work for me. If I press the sequence, then the Pots & Pans light blinks along with the Quick Rinse and Cancel buttons. Which combination do I use to get the dishwasher working again, please? Thank you.


Try to Press and hold AIR DRY for 4 seconds, to reset the dishwasher ... Kenmore 24 in. 15689 Built-in Dishwasher

I have a Whirlpool Gold Quit Partner III, model GU1100XTLB1. When I run the normal cycle it functions well until near the end. At that time the unit stops and the pots&pans indicator light blinks. If I hold the cancel button in the unit drains then refills and the light starts to link again. I don't know how to reset this unit because I only have air dry. If I leave the power off for a day I can get the unit to reset. If not, it just fills back up with water and the pots&pans starts blinking aga


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have whirlpool diahwasher ,model DU1055XTSQ3,quiet partner -1. when i start the machine the folowings things happen: 1.the machine does not start . 2.Start /resume light starts blinking ,after few seconds ( 40-50 seconds), the pots and pans light also starts blinkng .after some time ( 1 minute ) the normal light also starts blinking .All three lights start blinking 3. I have done the following to rectify the problem from the book : alnernatively pressed heated dry and normal keys for


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Vdb450ss The three lights for Pots & Pans, Normal Wash, Econo Wash are all flashing. When I hold the start button down for four seconds, just the Normal light is on. However, once I close the door, all three lights are on again, and the dishwasher does not start. We have tried unpugging it and then plugging it in again


... Viking DFB450 Dishwasher

Kenmore Elite 665.1310 Normal Wash and Cancel/Drain button flashing red lights. I have already unplugged and the problem remains. Also 3 buttons (pots&pans, normal wash, china gentle) dimly lit red


... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

My Kenmore ultra wash dishwasher model 665.1374 will only work if I press the restart button. When I do it goes to pots and pans with the drying cycle light lit. I cannot get the smart wash, normal wash, or quick wash buttons to work.


... Kenmore Dishwashers

Pots and pans and normal lights blinking


That reset sequence code didn't work for me. We tried everything on a ton of forums. What I did to fix our Whirlpool dishwasher was to disconnect the drainage tube from the garbage disposal. I noticed it smelled really bad so I figured it was clo ... Whirlpool GU2200XTSB GU2200XTSQ 24 in Builtin Dishwasher

Pots and pans and normal wash buttons flashing


... Viking VDB200 Dishwasher

We have a Kenmore Ultra wash dishwasher Model # 665.13733K601 and serial # FW18136133. came home from work yesterday and the pots and pan button and the normal wash buttons were flashing alternately. When I pushed the cancel button it started to flash, then I pressed the smart wash button and now its flashing. I turned of the breaker for awhile and then back on and the lights weren't on right away but later started flashing again, and I can't get the dishwasher to do anything. Any help on my pro


Hi,\015\012That unit took a power surge and the control is now bad....those controls can all of a sudden go wacky and the usual cause is power problems...\015\012The only way to fix it will be to replace the control...\015\012 ... Dishwashers

I have a Kenmore model 665.17579201. It does not work. The normal wash and quick rinse cycle were blinking now just the quick rinse is blinking. What does this mean? I tried to reset it, but my machin


... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

The three lights for Pots & Pans, Normal Wash, Econo Wash are all flashing.


... Viking DFB450 Dishwasher

My Kenmore dishwasher model #66515639000 quit working. It was washing dishes just fine one day and then the next the buttons weren't working properly. The pots & pans button was flashing with the cancel button. After searching on your site, I tried to resent the control panel by pressing the normal wash button and the air dry button 3 times then opening and closing the dishwasher. Now the quick rinse button is flashing. Any ideas of what to do now?


... Dishwashers

Normal or pots & pan light blinking and or sometimes both blinking and will not cancel and therefore we cannot turn on.this is a whirlpool quiet pardner ii.


Hello, the problem is from powering on wiring connection from the [power supply consult a technician to give you an helping hand thank you for using fixya. ... Dishwashers

Kenmore dishwasher 665.13843K601 ser. FU4806977 STOCK 13843K TYPE 575-0 Tried to turn it on won't start/ run/ perform any functions The following buttons light up but will not perform functions; Smart wash and heated dry also lights up like it should, pots and pans, normal, fast wash, high temp, sani rinse The following buttons do not perform functions or light up Quick rinse, Turbo ZOne, Delay Hrs., Cancel/Drain, Start/Resume I killed the power to it for 1 minute for reset but d


The touch pad is not working. Pull the front kick plate from font/bottom of machine and there is a 'TECH SHEET'. This has a complete diagnostic sequence for you to go through and verify the functions for you. ... Dishwashers

We have run our dish washer several times, however, the dishes are not getting cleaned. We first ran it on "normal wash." The second and third time we ran it on "pots and pans." Not only are the dishes not getting cleaned, but the soap is hardly getting dissolved. We use liquid dish soap too. I noticed this last time, at the end of the wash, the soap was getting built up on the front-right (when facing the machine) and had turned into a solid clump; almost like plaster. I don't have a manual so


First idea goto your local home depot they make a product called AFFRESH for front load washing machines and dishwashers run this tablet inside your dishwasher with no dishes on the inside on the hotest setting this usually takes out all build up wit ... Dishwashers

My Whirlpool Quiet Partner IV dishwasher model number GU3600XTRY1 has stopped working. The normal light on the top panel is flashing and one lighted bar is showing in the start touch circle. Upon throwing the breaker in fuse box panel seems cleared but when you try to press any buttons it makes a starting noise for a few seconds then goes quiet and returns to the state above.. My buttons on top are Accusense, pots&pans, normal, light, glass express, rinse only Soak and scour Hi temp wash


I think I just responded to this problem. Please accept both if you are happy with the solution. ... Dishwashers

DU100XTPS7: In "pots and pans" and "normal" cycle water fills during "soaking" phase, but does not transition to "washing" phase at all; In "light" cycle the water fills during soaking, then light comes on for washing phase but nothing happens - have had the washer for 3 years and worked fine until 2 days ago - thanks in advance for any info


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

My viking dishwasher is blinking normal wash and light china wash and water is on he bottom of the pan. I have tried cancel restarting it nothing is working. The water is very hot also. Thank you... someone please help!


... Viking 24 in. Professional Series DFUD140 (Premium) Built-in Dishwasher

Our Kenmore Ultra Wash Quiet Gaurd is not quiet. Could there be something wrong with it? Also, how long are the normal, pots & pans, and smart washes supposed to last? The model # is 16512200, Serial #FM3107487, stock #16512, and Type # is 575.0. Thank you for your assistances.


Hi,Everything you are asking is or can be relative. The noise issues is a matter of personal preference and what is quiet to someone else may not be to you...Make sure that ALL parts were installed and installed correctly. If the blanket ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1152 seconds